operatIng the power retract-
able hard top
PreParatIoN
there should be no objects on the parcel
shelf, roof, or trunk lid.
• 6.5 ft (2 m) free height above the car, and
8 in. (0.2 m) behind.
• Flat ground.
• ambient temperature above 14 ˚F (-10 ˚C).
• trunk lid and trunk divider closed.
• the car must be at a standstill.
• due to the low roofline, the front seat head
restraints must be in the lowest position.
• always have an unobstructed view of the
power retractable hard top when it is in
motion.
the windows open automatically approxi-
mately 1 in. (2 cm) when the power retractable
hard top is operated. they close automati-
cally. trunk dIvIder
t
he trunk divider limits the amount of cargo
in the trunk to leave space for the power
retractable hard top.
1. raise the divider when loading the trunk.
2. Close the divider completely (3) before
operating the hard top. see the decal on
the trunk divider.
r aise or lower the folded power retractable
hard top to facilitate loading.
1. Press the button and wait several sec -
onds for the hard top to rise slightly.
2. open the trunk divider, load the cargo,
and close the trunk divider again.
3. Press the button again to lower the folded
power retractable hard top.
load assIstance
oPeratIoN
1. engine idling (car parked outdoors).
2. Press the brake pedal.
3. Hold down the button (see inset illustra-
tion above) to open or pull up to close the
convertible hard top. Hold until a tone is
audible and the message top Fully up/
top Fully down is displayed.
4. release the button. automatIc car wash
remove the antenna by turning it coun-
terclockwise before washing the car in an
automatic car wash.
tP 14973 (U sa & Canada) at 1220. Printed in s weden, Göteborg 2012, Copyright © 2000-2012 Volvo Car Corporation
enterIng the rear seat
MaNUal seat
m
oving the seat forward
1. remove the seat belt from the guide (a).
2. Pull up the handle (b) and fold the backrest
forward until it locks in position.
3. Move the seat forward (C).
m oving the seat rearward
1. Move the seat rearward until it reaches the
desired position (d).
2. Pull up the handle (e) and return the back-
rest to the upright position.
3. Put the seat belt back into the guide (F).
PoWer seat*
m oving the seat forward
1. remove the seat belt from the guide (a).
2. Pull up the handle (b) and fold the backrest
forward until it locks in position.
3. Press and hold in the front section of the
button (G).
m oving the seat rearward
1. Press and hold in the rear section of the
button (G).
2. Pull up the handle (e) and return the back-
rest to the upright position.
3. Put the seat belt back into the guide (F).
note
When putting on the seat belt, it is easiest
to reach for the lower section of the belt,
near the guide, instead of reaching over
your shoulder.
adjustIng the Front seat
1
lumbar support.
2 head restraint height adjustment.
3 access to rear seat.
4 backrest tilt.
5 raise/lower the seat.
6 raise/lower the front edge of the seat
cushion.
7 Forward/rearward
r eM ote key a Nd t He P oW er seat
each of the remote keys can be used by
different drivers to store the driver’s seat posi-
tion in the following way:
• adjust the seat to your preferences.
• lock the vehicle by pressing the lock but-
ton on the remote key that you normally
use. this stores the seat’s current position
in that remote key’s memory
a.
• Unlock the vehicle (by pressing the unlock
button on the same remote key) and open
the driver’s door. the driver’s seat will
automatically move to the position stored
in the remote key (if the seat has been
moved since you left it).
a. this setting does not affect the separate power seat mem-
ory. Consult your owner’s manual for detailed information.
