2013 TOYOTA YARIS HYBRID lock

5
597 5-2. Steps to take in an emergency
When trouble arises
YARIS_F (including HV)_WE_52D27EConnect the hose to the valve.
Screw the end of the hose clock-
wise as far as possible.
Make sure that the compressor
switch is off.
Remove the power plug from the
compressor.
Connect the power plug to the
power outlet socket or cigarette
lighter socket.

5
609 5-2. Steps to take in an emergency
When trouble arises
YARIS_F (including HV)_WE_52D27E
Emergency start function (vehicles with a smart entry & start system)
When the engine does not start, the following steps can be used as
an interim measure to start the engine if the “ENGINE START STOP”
switch is functioning normally:
Vehicles with a Multidrive
Set the parking brake.
Shift the shift lever to P.
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Push and hold the “ENGINE START STOP” switch for about
15 seconds while depressing the brake pedal firmly.
Even if the engine can be started using the above steps, the system
may be malfunctioning. Have the vehicle inspected by any authorized
Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional.
The starter motor does not turn over, the interior lights and
headlights do not turn on, or the horn does not sound.
One of the following may be the cause of the problem:
One or both of the battery terminals may be disconnected.
The battery may be discharged. (P. 621)
There may be a malfunction in the steering lock system (vehi-
cles with a smart entry & start system).
Contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional if the problem cannot be
repaired, or if repair procedures are unknown.

5
611
5-2. Steps to take in an emergency
When trouble arises
YARIS_F (including HV)_WE_52D27E
If the hybrid system will not start (hybrid vehicle)
Reasons for the hybrid system not starting vary depending on the
situation. Check the following and perform the appropriate proce-
dure:
The hybrid system will not start even though the correct
starting procedure is being followed. (P. 236, 241)
One of the following may be the cause of the problem:
Vehicles with an electronic key: The electronic key may not be
functioning properly. (P. 619)
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. (P. 151)
There may be a malfunction in the immobilizer system.
(P. 155)
There may be a malfunction in the steering lock system.
The hybrid system may be malfunctioning due to an electrical
problem such as an open circuit or a blown fuse. However,
depending on the type of malfunction, an interim measure is
available to start the hybrid system. (P. 612)
The interior lights and headlights are dim, or the horn does
not sound or sounds at a low volume.
One of the following may be the cause of the problem:
The 12-volt battery may be discharged. (P. 628)
The 12-volt battery terminal connections may be loose or cor-
roded.

5
613
5-2. Steps to take in an emergency
When trouble arises
YARIS_F (including HV)_WE_52D27E
If the shift lever cannot be shifted from P (vehicles with a hybrid transmission or a Multidrive)
If the shift lever cannot be shifted with your foot on the brake pedal,
there may be a problem with the shift lock system (a system to pre-
vent accidental operation of the shift lever). Have the vehicle
inspected by any authorized Toyota dealer or repairer, or another
duly qualified and equipped professional immediately.
The following steps may be used as an emergency measure to
ensure that the shift lever can be shifted:
Set the parking brake.
Except hybrid vehicle
Vehicles without a smart entry & start system:
Turn the engine switch to the “ACC” position.
Vehicles with a smart entry & start system:
Turn the “ENGINE START STOP” switch to ACCESSORY
mode.
Hybrid vehicle
Vehicles without an electronic key:
Turn the engine switch to the “ACC” position.
Vehicles with an electronic key:
Turn the “POWER” switch to ACCESSORY mode.
Depress the brake pedal.
Press the shift lock override
button.
The shift lever can be shifted
while the button is pressed.

614
5-2. Steps to take in an emergency
YARIS_F (including HV)_WE_52D27E
If the shift lever cannot be shifted (vehicles with a multi-mode manual transmission)
If the shift lever cannot be shifted with your foot on the brake pedal,
there may be a problem with the shift lock system (a system to pre-
vent accidental operation of the shift lever). Have the vehicle
inspected by any authorized Toyota dealer or repairer, or another
duly qualified and equipped professional immediately.
The following steps may be used as an emergency measure to
ensure that the shift lever can be shifted:
Set the parking brake.
Vehicles without a smart entry & start system:
Turn the engine switch to the “ON” position.
Vehicles with a smart entry & start system:
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Depress the brake pedal.
Press the shift lock override
button with a flathead screw-
driver or equivalent.
The shift lever can be shifted
while the button is pressed.

616
5-2. Steps to take in an emergency
YARIS_F (including HV)_WE_52D27E
If the electronic key does not operate properly
Unlocking and locking the doors
Use the mechanical key (P. 66)
in order to perform the following
operations:
Unlocks all the doors
Locks all the doors
: If equipped
If communication between the electronic key and vehicle is inter-
rupted (P. 78) or the electronic key cannot be used because the
battery is depleted, the smart entry & start system and wireless
remote control cannot be used. In such cases, the doors can be
opened and the engine (except hybrid vehicle) or hybrid system
(hybrid vehicle) can be started by following the procedure below.

620 5-2. Steps to take in an emergency
YARIS_F (including HV)_WE_52D27E
Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery is depleted.
(P. 501)
Changing “ENGINE START STOP” switch modes (except hybrid vehi-
cle)
Vehicles with a Multidrive or multi-mode manual transmission: Release
the brake pedal and press the “ENGINE START STOP” switch in
above. (P. 617, 618)
The engine does not start and modes will be changed each time the
switch is pressed. (P. 230)
Vehicles with a manual transmission: Release the clutch pedal and press
the “ENGINE START STOP” switch in
above. (P. 618)
The engine does not start and modes will be changed each time the
switch is pressed. (P. 230)
Changing “POWER” switch modes (hybrid vehicle)
Release the brake pedal and press the “POWER” switch in above.
(P. 619)
The hybrid system does not start and modes will be changed each time the
switch is pressed. (P. 243)
If the doors cannot be locked or unlocked by the smart entry & start
system
Lock and unlock the doors by the mechanical key or wireless remote control.
When the electronic key does not work properly
Make sure that the smart entry & start system has not been deactivated in
the customization setting. If it is off, turn the function on.
(Customizable features P. 679)

5
625 5-2. Steps to take in an emergency
When trouble arises
YARIS_F (including HV)_WE_52D27E
Starting the engine when the battery is discharged (vehicles with a
Multidrive)
The engine cannot be started by push-starting.
To prevent battery discharge
Turn off the headlights and the audio system while the engine is off.
Turn off any unnecessary electrical components when the vehicle is run-
ning at a low speed for an extended period, such as in heavy traffic.
Charging the battery
The electricity stored in the battery will discharge gradually even when the
vehicle is not in use, due to natural discharge and the draining effects of cer-
tain electrical appliances. If the vehicle is left for a long time, the battery may
discharge, and the engine may be unable to start. (The battery recharges
automatically during driving.)
Precautions when the battery is discharged (vehicles with a smart
entry & start system)
In some cases, it may not be possible to unlock the doors using the smart
entry & start system when the battery is discharged. Use the wireless
remote control or the mechanical key to lock or unlock the doors.
The engine may not start on the first attempt after the battery has
recharged but will start normally after the second attempt. This is not a
malfunction.
The “ENGINE START STOP” switch mode is memorized by the vehicle.
When the battery is reconnected, the system will return to the mode it
was in before the battery was discharged. Before disconnecting the bat-
tery, turn the “ENGINE START STOP” switch off.
If you are unsure what mode the “ENGINE START STOP” switch was in
before the battery discharged, be especially careful when reconnecting
the battery.