2013 TOYOTA VERSO S bulb

1
2
3
4
5
6
VERSO-S_EE
5
4-1. Maintenance and care
Cleaning and protecting
the vehicle exterior ........... 352
Cleaning and protecting
the vehicle interior ............ 356
4-2. Maintenance
Maintenance
requirements..................... 359
4-3. Do-it-yourself
maintenance
Do-it-yourself service
precautions ....................... 362
Hood ................................... 365
Positioning a floor jack ........ 366
Engine compartment........... 368
Tires .................................... 383
Tire inflation pressure ......... 386
Wheels ................................ 388
Air conditioning filter ........... 390
Wireless remote control/
electronic key battery........ 393
Checking and replacing
fuses ................................. 397
Light bulbs .......................... 4135-1. Essential information
Emergency flashers ........... 424
If your vehicle needs to
be towed .......................... 425
If you think something is
wrong ............................... 433
Fuel pump shut off
system.............................. 434
5-2. Steps to take in an
emergency
If a warning light turns
on or a warning buzzer
sounds... ......................... 435
If you have a flat tire
(vehicles with a
spare tire) ......................... 448
If you have a flat tire
(vehicles with an
emergency tire
puncture repair kit) ........... 461
If the engine will not start ... 478
If the shift lever cannot be
shifted from P ................... 481
4Maintenance and care5When trouble arises

192
2-1. Driving procedures
VERSO-S_EE
Turn signal lever
Turn signals can be operated when
Vehicles without a smart entry & start system: The engine switch is in the
“ON” position.
Vehicles with a smart entry & start system: The “ENGINE START STOP”
switch is in IGNITION ON mode.
If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
The turn signal lever can be used to show the following intentions
of the driver:
Right turn
Left turn
Lane change to the right
(push and hold the lever
partway)
The right hand signals will
flash until you release the
lever.
Lane change to the left
(push and hold the lever
partway)
The left hand signals will flash
until you release the lever.

4Maintenance and care
351
VERSO-S_EE
4-1. Maintenance and care
Cleaning and protecting
the vehicle exterior ......... 352
Cleaning and protecting
the vehicle interior .......... 356
4-2. Maintenance
Maintenance
requirements................... 359
4-3. Do-it-yourself
maintenance
Do-it-yourself service
precautions ..................... 362
Hood ................................. 365
Positioning a floor jack ...... 366
Engine compartment......... 368
Tires .................................. 383
Tire inflation pressure ....... 386
Wheels .............................. 388
Air conditioning filter ......... 390
Wireless remote control/
electronic key battery...... 393
Checking and replacing
fuses ............................... 397
Light bulbs ........................ 413

362
VERSO-S_EE
4-3. Do-it-yourself maintenance
Do-it-yourself ser vice precautions
If you perform maintenance by yourself, be sure to follow the correct
procedures as given in these sections.
ItemsParts and tools
Battery condition (P. 377)•Warm water
• Baking soda
• Grease
• Conventional wrench
(for terminal clamp bolts)
• Distilled water
Engine coolant level (P. 375)• “Toyota Super Long Life Coolant”
or a similar high quality ethylene
glycol-based non-silicate, non-
amine, non-nitrite and non-borate
coolant with long-life hybrid
organic acid technology. “Toyota
Super Long Life Coolant” is pre-
mixed with 50% coolant and 50%
deionized water.
• Funnel (used only for adding cool-
ant)
Engine oil levelP. 370)• “Toyota Genuine Motor Oil” or
equivalent
• Rag or paper towel
• Funnel (used only for adding
engine oil)
Fuses (P. 397)• Fuse with same amperage rating
as original
Light bulbs (P. 413)• Bulb with same number and watt-
age rating as original
• Phillips-head screwdriver
• Flathead screwdriver
• Wrench
Radiator, condenser and inter-
cooler (P. 377)

412 4-3. Do-it-yourself maintenance
VERSO-S_EE
After a fuse is replaced
If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (P. 413)
If the replaced fuse blows again, have the vehicle inspected by any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
When replacing light bulbs
Toyota recommends that you use genuine Toyota products designed for this
vehicle.
Because certain bulbs are connected to circuits designed to prevent over-
load, non-genuine parts or parts not designed for this vehicle may be unus-
able.
CAUTION
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle and possibly a fire or
injury.
Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
Do not modify the fuses or fuse boxes.
NOTICE
Before replacing fuses
Have the cause of electrical overload determined and repaired by any autho-
rized Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional as soon as possible.

413
4-3. Do-it-yourself maintenance
4
Maintenance and care
VERSO-S_EE
Light bulbs
You may replace the following bulbs by yourself. The difficulty level
of replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perform, contact any authorized
Toyota dealer or repairer, or another duly qualified and equipped
professional.
For more information about replacing other light bulbs, contact any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
Preparing for light bulb replacement
Check the wattage of the light bulb to be replaced. (P. 524)
Front bulb locations
Front position lights
Front fog lights
(if equipped)
Headlights
Front turn
signal lights

414 4-3. Do-it-yourself maintenance
VERSO-S_EE
Replacing light bulbs
Headlights
Unplug the connector and
remove the rubber cover.
Release the bulb retaining
spring.
Rear bulb locations
Rear fog light (for
left-hand traffic)/
Back-up light (for
right-hand traffic)
Rear fog light (for
right-hand traffic)/
Back-up light (for
left-hand traffic) Stop/tail lights
License plate
lights
Rear turn signal lights
STEP1
STEP2

415 4-3. Do-it-yourself maintenance
4
Maintenance and care
VERSO-S_EERemove the bulb.
To install a new bulb, align the
tabs of the bulb with the cutouts
of the mounting hole.
Front fog lights (if equipped)
Vehicles without a front
spoiler
Remove the 2 screws and a clip.
Vehicles with a front spoiler
Remove the 3 screws and a clip.
The front spoiler will come off on
that side when the screws are
removed.
*: Vehicles with a front
spoiler only
Remove the grommet.
STEP3
STEP1
*
STEP2