2013 TOYOTA VERSO oil dipstick

413
4-3. Do-it-yourself maintenance
4
Maintenance and care
VERSO_WE_OM64550E_EURO5
Engine compartment
Gasoline engine
Washer fluid tank (P. 427)
Engine coolant reservoir
(P. 421)
Engine oil level dipstick
(P. 416)
Engine oil filler cap
(P. 418)Fuse box (P. 444)
Battery (P. 423)
Electric cooling fan
Condenser (P. 423)
Radiator (P. 423)

414 4-3. Do-it-yourself maintenance
VERSO_WE_OM64550E_EURO5
Diesel engine
Washer fluid tank (P. 427)
Engine coolant reservoir
(P. 421)
Engine oil level dipstick
(P. 416)
Engine oil filler cap
(P. 418)Fuel filter (P. 428)
Fuse box (P. 444)
Battery (P. 423)
Condenser (P. 423)
Electric cooling fans
Intercooler (P. 423)
Radiator (P. 423)

416 4-3. Do-it-yourself maintenance
VERSO_WE_OM64550E_EURO5
Engine oil
With the engine at operating temperature and turned off, check the oil
level on the dipstick.
Checking the engine oil
Park the vehicle on level ground. After warming up the engine
and turning it off, wait more than 5 minutes for the oil to drain
back into the bottom of the engine.
Hold a rag under the end and pull the dipstick out.
Gasoline engine
Diesel engine
Wipe the dipstick clean.

417 4-3. Do-it-yourself maintenance
4
Maintenance and care
VERSO_WE_OM64550E_EURO5Gasoline engine with flat dipstick and diesel engine: Reinsert
the dipstick fully.
Gasoline engine with non-flat
dipstick: Reinsert the non-flat
dipstick fully with its protruding
areas ( in the illustration)
pointing towards the engine.
Holding a rag under the end, pull the dipstick out and check
the oil level.
Flat dipstick
Low
Normal
Excessive
The shape of the dipstick may
differ depending on the type of
vehicle or engine.
Non-flat dipstick
Low
Normal
Excessive
The shape of the dipstick may
differ depending on the type of
vehicle or engine.
Wipe the dipstick and reinsert it fully.

418 4-3. Do-it-yourself maintenance
VERSO_WE_OM64550E_EURO5Adding engine oil
If the oil level is below or near
the low level mark, add engine
oil of the same type as already in
the engine.
Make sure to check the oil type and prepare the items needed before
adding oil.
Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
Engine oil selectionP. 5 7 3
Oil quantity
(Low  Full)1ZR-FAE/2ZR-FAE engines
1.5 L (1.6 qt., 1.3 Imp.qt.)
1AD-FTV engine without DPF catalytic converter
1.7 L (1.8 qt., 1.5 Imp.qt.)
1AD-FTV engine with DPF catalytic converter/
2AD-FHV engine
1.6 L (1.7 qt., 1.4 Imp.qt.)
Items Clean funnel

420 4-3. Do-it-yourself maintenance
VERSO_WE_OM64550E_EURO5
CAUTION
Used engine oil
Used engine oil contains potentially harmful contaminants which may
cause skin disorders such as inflammation or skin cancer, so care should
be taken to avoid prolonged and repeated contact. To remove used engine
oil from your skin, wash thoroughly with soap and water.
Dispose of used oil and filters only in a safe and acceptable manner. Do
not dispose of used oil and filters in household trash, in sewers or onto the
ground. Call any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional, service station or auto parts store for
information concerning recycling or disposal.
Do not leave used engine oil within the reach of children.
NOTICE
To prevent serious engine damage
Check the oil level on regular basis.
When replacing the engine oil
Be careful not to spill engine oil on the vehicle components.
Avoid overfilling, as the engine could be damaged.
Check the oil level on the dipstick every time you refill the vehicle.
Be sure the engine oil filler cap is properly tightened.
Engine oil
1AD-FTV with diesel fuel that contains 500 ppm or less of sulphur engine
(P. 119)
Using engine oil other than ACEA B1 may damage the catalytic con-
verter.
1AD-FTV with diesel fuel that contains 50 ppm or less of sulphur and
2AD-FHV engines (P. 119)
Using engine oil other than ACEA C2 may damage the catalytic con-
verter.

573 6-1. Specifications
6
Vehicle specifications
VERSO_WE_OM64550E_EURO5
Lubrication system
*1: The engine oil capacity is a reference quantity to be used when changing
the engine oil. Warm up and turn off the engine, wait more than 5 minutes,
and check the oil level on the dipstick.
*2: To distinguish the 1AD-FTV engine, ask any authorized Toyota dealer or
repairer, or another duly qualified and equipped professional.
Engine oil selection
1ZR-FAE and 2ZR-FAE engines for EU area
“Toyota Genuine Motor Oil” is used in your Toyota vehicle. Toyota rec-
ommends the use of approved “Toyota Genuine Motor Oil”. Another
motor oil of matching quality can also be used.
Oil grade:
0W-20, 5W-20, 5W-30 and 10W-30:
API grade SL “Energy-Conserving”, SM “Energy-Conserving” or SN
“Resource-Conserving”; or ILSAC multigrade engine oil
15W-40 and 20W-50:
API grade SL, SM or SN multigrade engine oil
Oil capacity
(Drain and refill
- reference
*1)
Gasoline engine
Diesel engine1ZR-FAE and 2ZR-FAE engines
With filter: 4.2 L (4.4 qt., 3.7 Imp.qt.)
Without filter: 3.9 L (4.1 qt., 3.4 Imp.qt.)
1AD-FTV (without DPF catalytic converter)
*2
With filter: 6.3 L (6.7 qt., 5.5 Imp.qt.)
Without filter: 5.9 L (6.2 qt., 5.2 Imp.qt.)
1AD-FTV (with DPF catalytic converter)
*2
and 2AD-FHV engines
With filter: 5.9 L (6.2 qt., 5.2 Imp.qt.)
Without filter: 5.5 L (5.8 qt., 4.8 Imp.qt.)