JOBNAME: 1183107-2013-r4eWG-E PAGE: 40 SESS: 12 OUTPUT: Fri Nov 30 10:46:58 2012
/tweddle/toyota/sched-maint/1183107-en-r4e/wg
110,000 miles or 132 months
Check installation of driver’s floor matInspect and adjust all fluid levelsRotate tiresVisually inspect brake linings/drums and
brake pads/discs
Inspect the following:__ Battery coolant
__ Health check
__ Motor/Inverter coolant
Additional Maintenance Items for
Special Operating Conditions
1
Driving on dirt roads or dusty roads:Inspect ball joints and dust coversInspect drive shaft bootsInspect steering linkage and bootsTighten nuts and bolts on chassis and
body
Driving while towing, using a car-top
carrier, or heavy vehicle loading2:Tighten nuts and bolts on chassis and
body
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
115,000 miles or 138 months
Check installation of driver’s floor matInspect and adjust all fluid levelsRotate tiresVisually inspect brake linings/drums and
brake pads/discs
Inspect the following:__ Battery coolant
__ Health check
__ Motor/Inverter coolant
Additional Maintenance Items for
Special Operating Conditions
1
Driving on dirt roads or dusty roads:Inspect ball joints and dust coversInspect drive shaft bootsInspect steering linkage and bootsTighten nuts and bolts on chassis and
body
Driving while towing, using a car-top
carrier, or heavy vehicle loading2:Tighten nuts and bolts on chassis and
body
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
Maintenance Log
MAINTENANCE
40Maintenance Log
JOBNAME: 1183107-2013-r4eWG-E PAGE: 41 SESS: 12 OUTPUT: Fri Nov 30 10:46:58 2012
/tweddle/toyota/sched-maint/1183107-en-r4e/wg
120,000 miles or 144 months
Check installation of driver’s floor matInspect and adjust all fluid levelsReplace cabin air filterReplace battery coolant3
Replace motor/inverter coolant4
Rotate tires
Inspect the following:
__ Ball joints and dust covers
__ Battery coolant
__ Brake lines and hoses
__ Brake linings/drums and brakepads/discs
5
__ Drive shaft boots
__ Health check __ Heater coolant
__ Motor/Inverter coolant
__ Radiator, condenser, hoses and/or
intercooler
__ Steering gear box
__ Steering linkage and boots
Additional Maintenance Items for Special Operating Conditions
1
Driving on dirt roads or dusty roads:Tighten nuts and bolts on chassis and body
Driving while towing, using a car-top carrier, or heavy vehicle loading2:Tighten nuts and bolts on chassis and body
DEALERSERVICEVERIFICATION:
D
AT E:
M
ILEAGE:
1Perform these service items only if you drive primarily under the conditions indicated.2Not all vehicles are designed for towing. Refer to your Vehicle Owner’s Manual for details.3Perform this service item at every 48 months or 50,000 miles whichever comes first. Refer to “Battery Coolant” in
the “Explanation of Maintenance Items” section in the back of this guide for more information.
4Perform this service item at every 48 months or 50,000 miles whichever comes first. Refer to “Motor/Inverter
Coolant” in the “Explanation of Maintenance Items” section in the back of this guide for more information.
5Inspect thickness measurement and disc runout.
Maintenance Log
MAINTENANCE
Maintenance Log41
JOBNAME: 1183107-2013-r4eWG-E PAGE: 44 SESS: 11 OUTPUT: Fri Nov 30 10:46:58 2012
/tweddle/toyota/sched-maint/1183107-en-r4e/wg
Motor/Inverter Coolant
Replace at specified intervals. When
performing inspections, check that the
motor and inverter (electric vehicle motor
assembly) coolant level is between the
FULLandLOW lines on the
see-through reservoir tank.
Notice: A qualified technician should
perform this operation.
• Only use Zerex G 48 orGlysantin G
48. The dilution ratio for both Zerex
G 48 andGlysantin G 48 is 50%
coolant and 50% deionized water.
Therefore, dilution is needed when
coolant in the vehicle is added.
• Do not use TOYOTA Super Long Life
Coolant (SLLC) or similar high quality
ethylene glycol based non-silicate,
non-amine, non-nitrite, and non-borate
coolant with long-life hybrid organic
acid technology.
• To prevent foreign matter such as
dust or dirt from entering the cooling
system, make sure to confirm that the
container used to add coolant is clean
and free of foreign matter such as
dust or dirt.
Nuts and Bolts on Chassis and
Body
Re-tighten the seat-mounting bolts and
front/rear suspension member retaining
bolts to specified torque.
Radiator, Condenser, Hoses
and/or Intercooler
Inspect for damage, debris, corrosion,
kinks, cracks, rot, clogging and leaks.
Have any problem repaired immediately by
a qualified technician.
Steering Gear Box
Inspect for signs of leakage. If you
discover any leakage, have it repaired
immediately by a qualified technician.
Steering Linkage and Boots
With the vehicle stopped, check for
excessive freeplay in the steering wheel.
Inspect the linkage for bending and
damage and the dust boots for
deterioration, cracks and damage. Replace
any damaged parts. A qualified technician
should perform these operations.
Tire Rotation
Tires should be rotated according to the
instructions in the
Owner’s Manual.When
rotating tires, check for damage and
uneven wear. Replace if necessary.
Transaxle Lubricant Fluid
Replace at specified intervals. When
performing inspections, check each
component for signs of leakage. If you
discover any leakage, have it repaired by a
qualified technician immediately.
Explanation of Maintenance Items
44Maintenance Log
MAINTENANCE
