2013 TOYOTA PRIUS PLUS child restraint

175 1-8. Safety information
1
Before driving
PRIUS +_OM_OM47841E_(EE)(1) For the CRS which do not carry the ISO/XX size class identifica-
tion (A to G), for the applicable mass group, the car manufac-
turer shall indicate the vehicle specific ISOFIX child restraint
system(s) recommended for each position.
Key of letters inserted in the above table:
IUF: Suitable for ISOFIX forward-facing child restraints systems of
universal category approved for the use in this mass group.
IL: Toyota recommend to use “TOYOTA MIDI” approved for the use
in this mass group. When using this child restraint system,
adjust the support leg to 6th lock position from 1st lock position
where the support leg is shortest position. Move the seat to the
rear most lock position, and adjust the seat back to the 2nd lock
position from the most upright position.
X: ISOFIX position not suitable for ISOFIX child restraint systems
in this mass group and/or this size class.
*: When you use a child restraint system in this position, remove
the head restraint.
The child restraint systems mentioned in the table may not be avail-
able outside of the EU area.
Other child restraint systems different from the systems mentioned in
the table can be used, but the suitability of the systems must be care-
fully checked with the child restraint system manufacturer and
retailer.

176 1-8. Safety information
PRIUS +_OM_OM47841E_(EE)
When installing a child restraint system on the front passenger seat
Selecting an appropriate child restraint system
Use a child restraint system appropriate for the child until the child
becomes large enough to properly wear the vehicle’s seat belt.
If the child is too large for a child restraint system, sit the child on a rear
seat and use the vehicle’s seat belt. (P. 115)
When you have to use a child restraint
system on the front passenger seat,
adjust the following:
The seatback from the 1st lock position
(most upright position) to the 5th lock
position
The seat cushion to the fully rearward
position

177 1-8. Safety information
1
Before driving
PRIUS +_OM_OM47841E_(EE)
CAUTION
Using a child restraint system
The use of a child restraint system not suitable for the vehicle may not prop-
erly secure the infant or child. It may result in death or serious injury (in the
event of sudden braking or an accident).
Child restraint precautions
For effective protection in automobile accidents and sudden stops, a child
must be properly restrained, using a seat belt or child restraint system
depending on the age and size of the child. Holding a child in your arms is
not a substitute for a child restraint system. In an accident, the child can be
crushed against the windshield, or between you and the vehicle’s interior.
Toyota strongly urges the use of a proper child restraint system that con-
forms to the size of the child, installed on the rear seat. According to acci-
dent statistics, the child is safer when properly restrained in the rear seat
than in the front seat.
Never install a rear-facing child restraint system on the front passenger
seat when the airbag manual on-off switch is ON. (P. 166) In the event of
an accident, the force of the rapid inflation of the front passenger airbag
can cause death or serious injury to the child if the rear-facing child
restraint system is installed on the front passenger seat.
A forward-facing child restraint system may be installed on the front pas-
senger seat only when it is unavoidable. A child restraint system that
requires a top strap should not be used in the front passenger seat since
there is no top strap anchor for the front passenger seat. Adjust the seat-
back as upright as possible and always move the seat as far back as pos-
sible, because the front passenger airbag could inflate with considerable
speed and force. Otherwise, the child may be killed or seriously injured.

178 1-8. Safety information
PRIUS +_OM_OM47841E_(EE)
CAUTION
Child restraint precautions
Do not allow the child to lean his/her head or any part of his/her body
against the door or the area of the seat, front and rear pillars or roof side
rails from which the SRS side airbags or SRS curtain shield airbags deploy
even if the child is seated in the child restraint system. It is dangerous if
the SRS side airbags and curtain shield airbags inflate, and the impact
could cause death or serious injury to the child.
Make sure you have complied with all installation instructions provided by
the child restraint manufacturer and that the system is properly secured. If
it is not secured properly, it may cause death or serious injury to the child
in the event of a sudden stop, sudden swerve or accident.
When children are in the vehicle
Do not allow children to play with the seat belt. If the seat belt becomes
twisted around a child’s neck, it may lead to choking or other serious injuries
that could result in death.
If this occurs and the buckle cannot be unfastened, scissors should be used
to cut the belt.
When the child restraint system is not in use
Keep the child restraint system properly secured on the seat even if it is
not in use. Do not store the child restraint system unsecured in the pas-
senger compartment.
If it is necessary to detach the child restraint system, remove it from the
vehicle or store it securely in the luggage compartment. This will prevent it
from injuring passengers in the event of a sudden stop, sudden swerve or
accident.

179
1
1-8. Safety information
Before driving
PRIUS +_OM_OM47841E_(EE)
Installing child restraints
Follow the child restraint system manufacturer’s instructions. Firmly
secure child restraints to the seats using a seat belt or the ISOFIX
rigid anchors. Attach the top strap when installing a child restraint.
Seat belts
ISOFIX rigid anchors (ISOFIX
child restraint system)
Lower anchors are provided for
the second outside seats.
(Tags displaying the location of
the anchors are attached to the
seats.)
Anchor brackets (for top strap)
An anchor bracket is provided
for each second outside seats.

180 1-8. Safety information
PRIUS +_OM_OM47841E_(EE)
Installing child restraints using a seat belt
Rear facing Baby seat/child seat
Adjusting the angle of the seatback.
Second seats
While pulling the lever (either
[outside seats only] or ), fold
the seatback forward and then
back to the 1st lock position
(most upright position) until it
locks into place. Adjust the seat-
back to the 5th lock position.
1st lock position
5th lock position
Move the seat as far back as
possible.
Third seats
Adjust the second seat forward
so that it does not interfere with
the child restraint system.
While pulling the lever, fold the
seatback forward and then back
to the 1st lock position (most
upright position) until it locks into
place.
STEP 1
A
B

181 1-8. Safety information
1
Before driving
PRIUS +_OM_OM47841E_(EE)Remove the head restraint. (P. 1 1 2 )
Place the child restraint system
on the seat facing the rear of the
vehicle.
Run the seat belt through the
child restraint system and insert
the plate into the buckle. Make
sure that the belt is not twisted.
Keep the lap portion of the belt
tight.
Follow the directions given in the
child restraint system installation
manual and fix the child restraint
system securely in place.
If your child restraint system is
not equipped with a lock-off (a
seat belt locking feature), secure
the child restraint system using a
locking clip. (P. 188)
After installing the child restraint system, rock it back and forth to
ensure that it is installed securely.
STEP 2
STEP 3
STEP 4

182 1-8. Safety information
PRIUS +_OM_OM47841E_(EE)Forward-facing Child seat
Adjusting the angle of the seatback.
Second seats
While pulling the lever (either
[outside seats only] or ), fold
the seatback forward and then
back to the 1st lock position
(most upright position) until it
locks into place. Adjust the seat-
back to the 5th lock position.
1st lock position
5th lock position
Move the seat as far back as
possible.
Third seats
Adjust the second seat forward
so that it does not interfere with
the child restraint system.
While pulling the lever, fold the
seatback forward and then back
to the 1st lock position (most
upright position) until it locks into
place.
STEP 1
A
B