OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
1
INDEX
Engine maintenance 9Fuel tank door release and cap8Hood release 8Indicator symbols 4-5Instrument cluster 4Instrument panel2-3Keyless entry16Light control-Instrument panel9
Smart Key system1,27
Air Conditioning/Heating18-19Audio 20-21Auto lock/unlock110Automatic Transmission 10Back door 17Cooler box 26Crawl control 21Cup holders 26Door locks 25Dynamic radar cruise control 22-23Four-wheel drive 11Garage door opener (HomeLink®)323Lights1& turn signals 15Mirrors-Side 17Moonroof 17Multi-Information Display224Parking brake 27Power outlets-12V DC 27Power outlet-120V AC 27Rear seat entertainment system 26Seat adjustments-Front12Seat adjustments-Rear12Seat heaters and ventilators 19Seats-Head restraints 12Seats-Tumbling second row seats 13Seats-Tumbling third row seats 14Steering lock release 11Tilt and telescopic steering wheel 24Te l e p h o n e controls (Bluetooth®)25Windows-Power 16
Window wipers & washers 16
Doors-Child safety locks 29Floor mat installation 31Seat belts 28Seat belts-Shoulder belt anchor 28Spare tire & tools 29Star Safety SystemTM30
Tire Pressure Monitoring (warning) System 28
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND
EMERGENCY FEATURES
1Visit your Toyota dealer for information on customizing this feature.2 Programmable by customer. Refer to the Owner’s Manual for instructions and more
information.
3HomeLink®is a registered trademark of Johnson Controls, Inc.
28
SAFETY AND EMERGENCY FEATURES
If belt is fully extended, then retracted even slightly, it cannot be re-extended
beyond that point, unless fully retracted again. This feature is used to help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child restraint
system, refer to the Owner's Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Push up, or squeeze
lock release to lower
System reset initialization
1. Push and hold “ SET” button
until the indicator blinks
three times.
2. Wait a few minutes to allow
initialization to complete.
Seat belts-Shoulder belt anchor
After adjusting tire pressures, or after tires have been rotated or replaced, turn the
“ENGINE START STOP” switch to ON and press and hold the “ SET” button until
indicator blinks three times. Let the vehicle sit for a few minutes to allow
initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Toyota dealer.
NOTE:The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the light.
Tire Pressure Monitoring (warning)
System
