2013 TOYOTA LAND CRUISER windshield wipers

206 2-3. Operating the lights and wipers
LC200_OM_OM60F57U_(U)
■The windshield wiper and washer can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
■Effects of vehicle speed on wiper operation (vehicles with rain-sensing
windshield wipers)
Vehicle speed affects the wiper operation when the washer is being used
(delay until drip prevention wiper sweep occurs) even when the wipers are
not in “AUTO” mode.
With “ ” selected, wiper operation will be switched from low speed to
intermittent wiper operation only when the vehicle is stationary.
(However, when the sensor sensitivity is adjusted to the highest level, the
mode cannot be switched.)
■Rain drop sensor (vehicles with rain-sensing windshield wipers)
●If the wiper switch is turned to “AUTO” position while the “ENGINE
START STOP” switch is in IGNITION ON mode, the wiper will operate
once to show that “AUTO” mode is activated.
●If the temperature of the rain drop sensor is 176F (80C) or higher, or
14F (-10C) or lower, automatic operation may not occur. In this case,
operate the wipers in any mode other than “AUTO”.
■If no windshield washer fluid sprays
Check that the washer nozzles are not blocked if there is washer fluid in the
windshield washer fluid reservoir.
●The sensor judges the amount of rain-
drops.

207 2-3. Operating the lights and wipers
2
When driving
LC200_OM_OM60F57U_(U)
CAUTION
■Caution regarding the use of windshield wipers in “AUTO” mode (vehi-
cles with rain-sensing windshield wipers)
The windshield wipers may operate unexpectedly if the sensor is touched or
the windshield is subject to vibration in “AUTO” mode. Take care that your
fingers or anything else do not become caught in the windshield wipers.
■Caution regarding the use of washer fluid
When it is cold, do not use the washer fluid until the windshield becomes
warm. The fluid may freeze on the windshield and cause low visibility. This
may lead to an accident, resulting in death or serious injury.
NOTICE
■When the windshield is dry
Do not use the wipers, as they may damage the windshield.
■When there is no washer fluid spray from the nozzle
Damage to the washer fluid pump may be caused if the lever is pulled
toward you and held continually.
■When a nozzle becomes blocked
Do not try to clear it with a pin or other object. The nozzle will be damaged.

222 2-4. Using other driving systems
LC200_OM_OM60F57U_(U)
■Dynamic radar cruise can be set when
●The shift lever is in “D” or range “4” or higher of “S” has been selected.
●Vehicle speed is above approximately 30 mph (50 km/h).
■Accelerating after setting the vehicle speed
The vehicle can accelerate normally. After acceleration, the set speed
resumes.
However, during vehicle-to-vehicle distance control mode, the vehicle speed
may decrease below the set speed in order to maintain the distance to the
vehicle ahead.
■Automatic cancelation of vehicle-to-vehicle distance control
Vehicle-to-vehicle distance control driving is automatically canceled in the
following situations:
●Actual vehicle speed falls below approximately 25 mph (40 km/h).
●VSC is activated.
●The sensor cannot operate correctly because it is covered in some way.
●The windshield wipers are operating at high speed (when the wiper
switch is set to the “AUTO” mode or high speed wiper operation position).
●When second start mode is set.
●The switching operation continues for 5 seconds or more after the center
differential lock switch has been operated.
If vehicle-to-vehicle distance control driving is automatically canceled for any
other reason, there may be a malfunction in the system. Contact your Toyota
dealer.

5
When trouble arises
625 5-2. Steps to take in an emergency
LC200_OM_OM60F57U_(U)
Indicates that the
dynamic radar cruise
control sensor is dirty
or covered with iceClean the sensor.
(If equipped)Indicates that the
dynamic radar cruise
control system is
unable to judge vehi-
cle-to-vehicle distance• Switch driving mode to
either normal or power.
• If the windshield wipers
are on, turn them off or
set them to either inter-
mittent or slow mode.
(Flashes)
(If equipped)Indicates that your
vehicle is nearing the
vehicle ahead (in vehi-
cle-to-vehicle dis-
tance control mode)
A buzzer also sounds.Slow the vehicle by
applying the brakes.
Warning messageDetailsCorrection procedure

717 Alphabetical index
LC200_OM_OM60F57U_(U)
Warning buzzers
Brake system........................ 606
Open door ........................... 608
Seat belt reminder ................ 609
Warning lights
Anti-lock brake system ......... 608
Brake system........................ 606
Charging system .................. 607
Low fuel level........................ 610
Malfunction indicator lamp.... 607
Master warning ..................... 610
Open door ............................ 608
Pre-collision .......................... 608
Seat belt reminder ................ 609
Slip indicator light ................. 608
SRS airbags ......................... 607
Tire pressure ........................ 609
Unengaged “Park” ................ 609
Warning messages ................. 617
Warning reflector holder ........ 495
Washer
Checking .............................. 542
Preparing and checking
before winter ...................... 310
Switch ........................... 202, 208
Washing and waxing............... 512
Weight
Cargo capacity ..................... 302
Load limits ............................ 309
Weight .................................. 666
Wheels...................................... 557
Window glasses ....................... 93
Window lock switch .................. 93
Windows
Power windows ...................... 93
Rear window defogger ......... 351
Washer ......................... 202, 208Windshield wiper de-icer.........352
Windshield wipers ...................202
Wireless remote control key
Replacing the battery ............563
Wireless remote control key ....44
WMA disc ..................................373W
*: For vehicles with a navigation system,
refer to the “Navigation System Owner’s Manual”.