2013 TOYOTA iQ EV warning

19
OVERVIEWELECTRIC VEHICLE SYSTEM FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
Remaining charging time Charging information is displayed on the
Multi-Information Display.
If the POWER switch is turned to ON mode during charging, the estimated amount
of time needed for charge completion will be displayed.
After confirming, switch the POWER switch to OFF to turn off the display. The
POWER switch will turn off automatically after approximately two minutes.
Multi-Information Display-Charging
information
Charging information and warning messages The first time the POWER switch is
turned to ON mode after charging is completed, a message detailing the results
of the charge is shown. Also, if an operation that cannot be carried out during
charging was attempted, a warning message will be shown.
While charging with an external power source, the heater or Air Conditioning
can be operated before getting in the vehicle. If the Air Conditioning system is
remotely activated while charging, charging will stop but resume when the Air
Conditioning system goes off.
The Remote Climate Control will operate in accordance with the temperature
settings of the Air Conditioning system, so be sure to check the settings before
leaving the vehicle.
- Press and hold the “
” button.
- The system will shut off if a door is opened. The system can be stopped by
pressing the “
” button twice.
2013Scion-iQ-EV.indd 191/14/13 6:49 PM

20
* The power switch must be in the “ON” mode and the brake pedal depressed to
shift from Park.
Downshifting increases power going uphill, or provides regenerative braking
downhill. For best power economy during normal driving conditions, always drive
with the shift lever in the “D” position.
FEATURES/OPERATIONS
Transmission
Parking brake
ELECTRIC VEHICLE SYSTEM
In the unlikely event that the electrical leakage detection function is not
operating properly, contact your Toyota or Scion dealer as soon as possible.
Check that it is operating properly by following the procedure below.
Step 1 Insert the charging cable into the outlet of the external power source.
Step 2 Press the test button on the CCID (Charging Circuit Interrupting Device).
If the error warning indicator
illuminates when the test button
is pressed, the function is
operating correctly.
Step 3 Press the reset button on the CCID (Charging Circuit Interrupting Device).
Check that the error warning indicator turns off. Charging cannot be carried out
while the error warning indicator is illuminated.
Charging can be continued by following the normal procedure. Store the charging
cable when not in use.
See the Owner’s Manual for important precautionary information.
Inspecting electrical leakage
detection function
2013Scion-iQ-EV.indd 201/14/13 6:49 PM

OVERVIEWELECTRIC VEHICLE SYSTEM FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
21
* The power switch must be in the “ON” mode and the brake pedal depressed to
shift from Park.
Downshifting increases power going uphill, or provides regenerative braking
downhill. For best power economy during normal driving conditions, always drive
with the shift lever in the “D” position.
FEATURES/OPERATIONS
Transmission
Parking brake
Pull(2) Push
(1) Pull slightly
(3) Lower
Park*
Reverse
Neutral
Drive
P
R
N
D
N
SRegenerative brake
Maximum
regenerative brakeB
Release
Set
In the unlikely event that the electrical leakage detection function is not
operating properly, contact your Toyota or Scion dealer as soon as possible.
Check that it is operating properly by following the procedure below.
Step 1 Insert the charging cable into the outlet of the external power source.
Step 2 Press the test button on the CCID (Charging Circuit Interrupting Device).
Step 3 Press the reset button on the CCID (Charging Circuit Interrupting Device).
Check that the error warning indicator turns off. Charging cannot be carried out
while the error warning indicator is illuminated.
Charging can be continued by following the normal procedure. Store the charging
cable when not in use.
See the Owner’s Manual for important precautionary information.
2013Scion-iQ-EV.indd 211/14/13 6:49 PM

30
Emergency tire puncture repair kit
Refer to the Owner’s Manual for more details.
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or replaced, turn
the power switch to the “ON” mode and press and hold the “
SET” button until
indicator blinks three times. Let the vehicle sit for a few minutes to allow
initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Toyota or Scion dealer.
NOTE: The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the light.
If belt is fully extended, then retracted even slightly, it cannot be re-extended
beyond that point, unless fully retracted again. This feature is used to help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child restraint
system, refer to the Owner’s Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Door locks
UnlockLock
Driver’s use
Front passenger’s use
UnlockLock
SAFETY AND EMERGENCY FEATURES
2013Scion-iQ-EV.indd 301/14/13 6:50 PM

31
OVERVIEWELECTRIC VEHICLE SYSTEM FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
Emergency tire puncture repair kit
Refer to the Owner’s Manual for more details.
If tire pressure indicator is on, check/adjust each tire.
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or replaced, turn
the power switch to the “ON” mode and press and hold the “
SET” button until
indicator blinks three times. Let the vehicle sit for a few minutes to allow
initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manual for tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Toyota or Scion dealer.
NOTE: The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the light.
Towing eyeletEmergency tire
puncture repair kitIf belt is fully extended, then retracted even slightly, it cannot be re-extended
beyond that point, unless fully retracted again. This feature is used to help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child restraint
system, refer to the Owner’s Manual.
Take up slack
SAFETY AND EMERGENCY FEATURES
2013Scion-iQ-EV.indd 311/14/13 6:50 PM