2013 TOYOTA HILUX brake

174
2-1. Driving procedures
HILUX_OM_OM0K134E_(EE)
Parking brake
Usage in winter time
See “Winter driving tips” for parking brake usage in winter time. (P. 235)
NOTICE
Before driving
Fully release the parking brake.
Driving the vehicle with the parking brake set will lead to brake components
overheating, which may affect braking performance and increase brake
wear.
To set the parking brake,
fully pull the parking brake
lever while depressing the
brake pedal.
At this time, the brake system
warning light will come on.
To release the parking
brake, slightly raise the
lever and lower it in com-
pletely while pressing the
button.
At this time, the brake system
warning light will go off.

204 2-4. Using other driving systems
HILUX_OM_OM0K134E_(EE)
Canceling and resuming the constant speed control
Pulling the lever toward you
cancels the constant speed
control.
The speed setting is also can-
celed when the brakes are
applied or the clutch pedal
(manual transmission only) is
depressed.
Pushing the lever up
resumes the constant
speed control.
Resuming is available when
the vehicle speed is more than
approximately 40 km/h (25
mph).

219 2-4. Using other driving systems
2
When driving
HILUX_OM_OM0K134E_(EE)
Locking the rear differential
The following systems do not operate when the rear differential is locked.
It is normal operation for the ABS warning light, VSC OFF indicator (if
equipped) and slip indicator (if equipped) to be on at this time.
•ABS
• Brake assist (if equipped)
• VSC (if equipped)
• TRC (if equipped)
For easy unlocking
Slightly turn the steering wheel in either direction while the vehicle is in
motion.
Automatic unlocking feature (4WD models)
Shift the front drive control lever to H2 or H4.
Never forget to turn off the switch after using this feature.
After unlocking the rear differential
Check that the indicator goes off.

221
2-4. Using other driving systems
2
When driving
HILUX_OM_OM0K134E_(EE)
Driving assist systems
To help enhance driving safety and performance, the following sys-
tems operate automatically in response to various driving situations.
Be aware, however, that these systems are supplementary and
should not be relied upon too heavily when operating the vehicle.
ABS (Anti-lock Brake System)
Helps to prevent wheel lock when the brakes are applied suddenly, or if
the brakes are applied while driving on a slippery road surface
Brake assist (if equipped)
Generates an increased level of braking force after the brake pedal is
depressed when the system detects a panic stop situation
VSC (Vehicle Stability Control) (if equipped)
Helps the driver to control skidding when swerving suddenly or turning
on slippery road surfaces
TRC (Traction Control) (if equipped)
Helps to maintain drive power and prevent the drive wheels from spin-
ning when starting the vehicle or accelerating on slippery roads
LSD (Limited Slip Differential) (if equipped)
Helps traction when one rear wheel begins to spin by automatically
transmitting driving force to the other rear wheel

224 2-4. Using other driving systems
HILUX_OM_OM0K134E_(EE)
Sounds and vibrations caused by the ABS, brake assist, VSC and TRC
A sound may be heard from the engine compartment when the engine is
started or just after the vehicle begins to move. This sound does not indi-
cate that a malfunction has occurred in any of these systems.
Any of the following conditions may occur when the above systems are
operating. None of these indicates that a malfunction has occurred.
• Vibrations may be felt through the vehicle body and steering.
• A motor sound may be heard after the vehicle comes to a stop.
• The brake pedal may pulsate slightly after the ABS is activated.
• The brake pedal may move down slightly after the ABS is activated.
Reactivation of the TRC/VSC systems after turning off the engine
Turning off the engine after turning off the TRC/VSC systems will automati-
cally reactivate them.
Reactivation of the TRC system linked to vehicle speed
When only the TRC system is turned off, the TRC system will turn on when
vehicle speed increases. However, when both TRC and VSC systems are
turned off, the systems will not turn on even when vehicle speed increases.
If the VSC OFF indicator light blinks and the slip indicator light comes
on...
It may indicate a malfunction in the VSC and TRC. Consult any authorized
Toyota dealer or repairer, or another duly qualified and equipped profes-
sional.

228 2-4. Using other driving systems
HILUX_OM_OM0K134E_(EE)Vehicles with the DPF system switch
If the DPF system warning light and the indicator light on DPF system
switch turn on or flash, follow the procedure below to regenerate.
Stop the vehicle in a safe place.
Firmly set the parking brake and shift the shift lever to P (auto-
matic transmission) or N (manual transmission). Release the
clutch pedal.
Do not stop the engine.
Also, make sure that there are no flammable materials near the
exhaust pipe. (P. 230)
Press the switch.
The DPF system warning light
and the indicator light on the
switch will change from solid or
rapid flashing to slow flashing,
and the idling engine speed will
increase.
Regeneration will take around 20
- 30
* minutes to complete.
When the DPF system warning
light goes out, the idling engine
speed will have finished returning
to normal.
*: Differs in accordance with the
outside temperature.
STEP1
STEP2
STEP3

233 2-5. Driving information
2
When driving
HILUX_OM_OM0K134E_(EE)
CAUTION
Things that must not be carried in the rear deck
The following things may cause a fire if loaded in the rear deck:
Receptacles containing gasoline
Aerosol cans
Storage precautions
Observe the following precautions.
Failure to do so may result in death or serious injury.
Stow cargo and luggage in the rear deck whenever possible.
Except for single-cab models: Do not stack anything behind the front seats
higher than the seatbacks.
Such items may be thrown about and possibly injure people in the vehicle
in the event of a sudden braking, sudden swerving or an accident.
Do not place cargo or luggage in or on the following locations as the item
may get under the clutch, brake or accelerator pedal and prevent the ped-
als from being depressed properly, block the driver’s vision, or hit the
driver or passengers, causing an accident:
• At the feet of the driver
• On the front passenger seats (when stacking items)
• Except for single-cab models: On the rear seat (when stacking items)
• On the instrument panel
• On the dashboard

236 2-5. Driving information
HILUX_OM_OM0K134E_(EE)
Before driving the vehicle
Perform the following according to the driving conditions:
Do not try to forcibly open a window or move a wiper that is
frozen. Pour warm water over the frozen area to melt the ice.
Wipe away the water immediately to prevent it from freezing.
To ensure proper operation of the climate control system fan,
remove any snow that has accumulated on the air inlet vents
in front of the windshield.
Remove any ice that has accumulated on the vehicle chassis.
Periodically check for and remove any excess ice or snow
that may have accumulated in the wheel well or on the
brakes.
When driving the vehicle
Accelerate the vehicle slowly and drive at a reduced speed suit-
able to road conditions.
When parking the vehicle (in the winter time or in the cold
latitudes)
Park the vehicle and move the shift lever to P (automatic trans-
mission) or 1 or R (manual transmission) without setting the
parking brake. The parking brake may freeze up, preventing it
from being released. If necessary, block the wheels to prevent
inadvertent sliding or creeping.