2013 TOYOTA HIGHLANDER HYBRID bulb

1
2
3
4
5
6
7
5
4-1. Maintenance and careCleaning and protecting the vehicle exterior............ 480
Cleaning and protecting the vehicle interior............. 483
4-2. Maintenance Maintenance requirements ..................... 486
General maintenance.......... 488
Emission inspection and maintenance (I/M)
programs........................... 491
4-3. Do-it-yourself maintenance Do-it-yourself service precautions ....................... 492
Hood ................................... 496
Positioning a floor jack ........ 498
Engine compartment ........... 500
12-volt battery ..................... 511
Tires .................................... 515
Tire inflation pressure ......... 523
Wheels ................................ 526
Air conditioning filter............ 529
Wireless remote control/ electronic key battery ........ 532
Checking and replacing fuses ................................. 535
Light bulbs........................... 548 5-1. Essential information
Emergency flashers............ 558
If your vehicle needs to be towed................................ 560
If you think something is wrong ............................... 566
5-2. Steps to take in an emergency
If a warning light turns on or a warning buzzer
sounds... .......................... 567
If a warning message is displayed .......................... 577
If you have a flat tire ........... 579
If the hybrid system will not start ............................ 592
If the shift lever cannot be shifted from P ................... 594
If you lose your keys/ wireless remote control
transmitter ........................ 595
If the electronic key does not operate properly ......... 596
If the 12-volt battery is discharged........................ 598
If your vehicle overheats .... 602
If the vehicle becomes stuck ................................. 606
If your vehicle has to be stopped in an
emergency ....................... 607
4Maintenance and care5When trouble arises

197
2-1. Driving procedures
2
When driving
Tur n signal lever
■Turn signals can be operated when
Vehicles without smart key system
The engine switch is in
the “ON” position.
Vehicles with smart key system
The “POWER” switch is in ON mode.
■ If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
Right turn
Left turn
Move and hold the lever
partway to signal a lane
change.
The right hand signal will flash
until you release the lever.
Move and hold the lever
partway to signal a lane
change.
The left hand signal will flash
until you release the lever.

Maintenance and care4
479
4-1. Maintenance and careCleaning and protecting the vehicle exterior......... 480
Cleaning and protecting the vehicle interior.......... 483
4-2. Maintenance Maintenance requirements .................. 486
General maintenance....... 488
Emission inspection and maintenance (I/M)
programs........................ 491 4-3. Do-it-yourself maintenance
Do-it-yourself service precautions .................... 492
Hood ................................ 496
Positioning a floor jack ..... 498
Engine compartment ........ 500
12-volt battery .................. 511
Tires ................................. 515
Tire inflation pressure ...... 523
Wheels ............................. 526
Air conditioning filter......... 529
Wireless remote control/ electronic key battery ..... 532
Checking and replacing fuses .............................. 535
Light bulbs........................ 548

547
4-3. Do-it-yourself maintenance
4
Maintenance and care
■
After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. ( P. 548)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage to the vehicle, and possibly a fire or
injury.
●Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
● Do not modify fuses or the fuse box.
■ Fuse box near the power control unit
Never check or replace the fuses as there are high voltage parts and wiring
near the fuse box.
Doing so may cause electric shock, resulting in death or serious injury.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer as soon as possible.

548
4-3. Do-it-yourself maintenance
Light bulbs
You may replace the following bulbs yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Prepare a replacement light bulb.
Check the wattage of the light bulb being replaced. ( P. 623)
■ Turn the power back door main switch OFF. (vehicles with
power back door)
P. 7 4
■ Front bulb locations
Headlight high
beams and
daytime running
lights (if equipped)
Headlight low beams
Fog lights
Parking, front side
marker and front turn
signal lights

549
4-3. Do-it-yourself maintenance
4
Maintenance and care
Replacing light bulbs
■ Headlights
Unplug the connector while
depressing the lock release.
Low beam (outside)
High beam (inside)
■Rear bulb locations
Rear turn signal lights
Back up lights Stop/tail and rear
side
marker
lights
License plate lights
STEP1

550 4-3. Do-it-yourself maintenance
Turn the bulb base counterclock-
wise.Low beam
High beam
■ Fog lights
Unplug the connector while
depressing the lock release.
Turn the bulb base counterclock-
wise.STEP2
STEP1
STEP2

551
4-3. Do-it-yourself maintenance
4
Maintenance and care
■
Parking, front side marker and front turn signal lights
Right side only: Move the
washer fluid tank opening.
Turn the bulb base counterclock-
wise.
STEP1
STEP2