2013 TOYOTA CAMRY HYBRID bulb

TABLE OF CONTENTSIndex
4
3-3. Using the interior lightsInterior lights list ................. 297
• Interior lights .................... 298
• Personal lights ................. 299
3-4. Using the storage features List of storage features....... 300
• Glove box ......................... 301
• Console box ..................... 302
• Coin holder ....................... 303
• Bottle holders ................... 304
• Cup holders ...................... 305
• Auxiliary boxes ................. 307
3-5. Other interior features Sun visors .......................... 309
Vanity mirrors ..................... 310
Clock .................................. 311
Outside temperature display .............................. 312
Ashtray ............................... 313
Power outlets ..................... 314
Seat heaters ....................... 316
Armrest............................... 318
Assist grips ......................... 319
Coat hooks ......................... 320
Floor mat ............................ 321
Trunk features .................... 323
Garage door opener ........... 325
Compass ............................ 332
Safety Connect................... 336 4-1. Maintenance and care
Cleaning and protecting the vehicle exterior ........... 344
Cleaning and protecting the vehicle interior ............ 347
4-2. Maintenance Maintenance requirements .................... 350
General maintenance ......... 352
Emission inspection and maintenance (I/M)
programs .......................... 356
4-3. Do-it-yourself maintenance Do-it-yourself service precautions ....................... 357
Hood ................................... 360
Positioning a floor jack........ 361
Engine compartment .......... 363
12-volt battery ..................... 373
Tires.................................... 377
Tire inflation pressure ......... 383
Wheels................................ 387
Air conditioning filter ........... 390
Electronic key battery ......... 392
Checking and replacing fuses ................................. 394
Light bulbs .......................... 405
4Maintenance and care

174
2-1. Driving procedures
Tur n signal lever
■Turn signals can be operated when
The “POWER” switch is in ON mode.
■ If the indicators flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned
out.
■ If the turn signals stop flashing be fore a lane change has been per-
formed
Operate the lever again.
The turn signal lever can be used to show the following intentions
of the driver:
Right turn
Left turn
Lane change to the right
(move the lever partway
and release it)
The right hand signals will
flash 3 times.
Lane change to the left
(move the lever partway
and release it)
The left hand signals will flash
3 times.

Maintenance and care4
343
4-1. Maintenance and careCleaning and protecting the vehicle exterior......... 344
Cleaning and protecting the vehicle interior.......... 347
4-2. Maintenance Maintenance requirements .................. 350
General maintenance....... 352
Emission inspection and maintenance (I/M)
programs........................ 356 4-3. Do-it-yourself
maintenance
Do-it-yourself service precautions .................... 357
Hood ................................ 360
Positioning a floor jack ..... 361
Engine compartment ........ 363
12-volt battery .................. 373
Tires ................................. 377
Tire inflation pressure ...... 383
Wheels ............................. 387
Air conditioning filter......... 390
Electronic key battery....... 392
Checking and replacing fuses .............................. 394
Light bulbs........................ 405

358 4-3. Do-it-yourself maintenance
ItemsParts and tools
Engine oil levelP. 364)
• “Toyota Genuine Motor Oil” or
equivalent
• Rag or paper towel
• Funnel (used only for adding engine oil)
Fuses (P. 394)• Fuse with same amperage rating
as original
Light bulbs (P. 405)
• Bulb with same number and watt-
age rating as original
• Phillips-head screwdriver
• Flathead screwdriver
• Wrench
Radiators and condenser
(P. 370)
Tire inflation pressure ( P. 383)• Tire pressure gauge
• Compressed air source
Washer fluid (P. 372)
• Water or washer fluid containing
antifreeze (for winter use)
• Funnel (used only for adding water or washer fluid)

404 4-3. Do-it-yourself maintenance
■After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. ( P. 405)
● If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
■ If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
■ When replacing light bulbs
Toyota recommends that you use genuine Toyota products designed for this
vehicle. Because certain bulbs are connected to circuits designed to prevent
overload, non-genuine parts or parts not designed for this vehicle may be
unusable.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
●Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
● Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
● Do not modify the fuses or fuse boxes.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by your
Toyota dealer as soon as possible.

405
4-3. Do-it-yourself maintenance
4
Maintenance and care
Light bulbs
You may replace the following bulbs by yourself. The difficulty level
of replacement varies depending on the bulb. If necessary bulb
replacement seems difficult to perfor m, contact your Toyota dealer.
For more information about replacing other light bulbs, contact your
Toyota dealer.
■ Preparing for light bulb replacement
Check the wattage of the light bulb to be replaced. ( P. 494)
■ Front bulb locations
Headlight low beam
(halogen bulb)
Headlight high beam
and daytime running
light
Front side marker light
Front turn signal/park-
ing light
Fog light (if equipped)

406 4-3. Do-it-yourself maintenance
Replacing light bulbs■ Headlights high beam and daytime running lights
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
■Rear bulb locations
Rear turn signal light
Stop/tail light License plate lightsBack-up light
Rear side marker light
STEP1
STEP2

407
4-3. Do-it-yourself maintenance
4
Maintenance and care
■
Headlight low beam (halogen bulb)
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
■ Fog light (if equipped)
Turn the steering wheel in the
opposite direction of the fog light
that you wish to replace.
For example, if you wish to
replace the fog light on the left
side, turn the steering wheel to
the right.
STEP1
STEP2
STEP1