2013 SUZUKI ALTO roof

0-4
82PH0-74E
(m) Insignificant defects which do not affect the function of the
vehicle including without limitation, sound, vibration and fluid
seep.
(n) Any natural wear and tear including without limitation, aging
etc.
(o) Installation and usage of domestic LPG gas/LPG Cylinder.
(p) V-belts, hoses and gas leaks.
(q) Any vehicle retrofitted with LPG/CNG kits.
(5) Extent of Warranty:This warranty is the entire written warranty given by Maruti Suzuki
for Maruti Suzuki vehicles and no dealer or its or his agent or
employee is authorised to extend or enlarge this warranty and no
dealer or its or his agent or employee is authorised to make any
oral warranty on Maruti Suzuki’s behalf.
Maruti Suzuki reserves the right to add any improvements or
change the design of any model at any time with no obligation to
make the same changes on units previously sold.
(6) Warranty Service:To obtain warranty service, the complete vehicle must be pre-
sented at the owner’s expenses to any authorised Maruti Suzuki
workshop.
(7) Owner’s Warranty Responsibilities:It is responsibility of each owner to:
– Make certain that the PDl card was completed at the time of
delivery of the vehicle;
– Have performed, at his own expenses, by an Maruti Suzuki
authorised dealer/service station all the service inspections
specified in the Maruti Suzuki “Owner’s Manual and Service
Booklet and maintain adequate proof that such service
inspections have been performed.– Make certain that the Maruti Suzuki authorised dealer/ser-
vice station performing the service inspection has certified
the work on the “Maintenance Service Record” page in the
“Owner’s Manual and Service Booklet and
– Present the Maruti Suzuki “Owner’s Manual and Service
Booklet to the authorised Maruti Suzuki dealer whenever
requesting service inspections or warranty service.
If the “Owner’s Manual and Service Booklet should be lost or
destroyed the owner should consult the authorised Maruti Suzuki
dealer from whom the vehicle was purchased for instructions con-
cerning replacement of the “Owner’s Manual and Service Book-
let”.
(8) Disclaimer of Consequential Damage:Maruti Suzuki assumes no responsibility for loss of vehicle, loss of
time, inconvenience or any other indirect incidental or consequen-
tial damage resulting from the vehicle not being available to the
owner because of any defect covered by this warranty.
(9) Change of OwnerEven if ownership of the vehicle changes, the remaining warranty
period is effective for the new owner.

2-4
BEFORE DRIVING
53MH0-74E
Child-Proof Locks (rear door)
53M-04-007
(1) LOCK (2) UNLOCK
Each of the rear doors is equipped with a child-proof lock which can be used to helpprevent unwanted opening of the door from inside the vehicle. When the lock lever is in the “LOCK” position (1), the rear door canonly be opened from outside. When the lock lever is in the “UNLOCK” position (2), the rear door can be opened from inside oroutside.
Ta i l g a t e
53M-04-008
To open the tailgate, insert the key andturn it clockwise to unlatch and lift the tail- gate.
53M-04-009
You can also unlatch the tailgate by pullingthe release lever (if equipped) located on the outboard side of the driver’s seat.
WA R N I N G
Be sure to place the child-proof lock in the “LOCK” position whenever children are seated in the rear.
EXAMPLE
NOTICE
Do not use the key to lift up the tail- gate, or the key may break off in the lock.
EXAMPLE
WA R N I N G
Always make sure that the tailgate is closed and latched securely. Com- pletely closing the tailgate helps pre- vent occupants from being thrown from the vehicle in the event of an accident. Completely closing it alsohelps keep exhaust gases from enter- ing the vehicle.
EXAMPLE

7-12
INSPECTION AND MAINTENANCE
53MH0-74E
ALTO K10
53M-09-009
Tightening torque for drain plug (1):
35 Nm (3.6 kg-m, 25.8 lb-ft)4) Reinstall the drain plug and new gas-
ket. Tighten the plug with a wrench to
the specified torque.
Replace the Oil Filter
1) Using an oil filter wrench, turn the oil fil-
ter counterclockwise and remove it.
2) Using a clean rag, wipe off the mount-
ing surface on the engine where the
new filter will be seated.
3) Smear a little engine oil around the rub-
ber gasket of the new oil filter.
4) Screw on the new filter by hand until the
filter gasket contacts the mounting sur-
face.
54G092
(1) Loosen
(2) TightenTightening (viewed from filter top)
82JN146
(1) Oil filter
(2) 1 turn
5) Tighten the filter specified turn from the
point of contact with the mounting sur-
face (or to the specified torque) using
an oil filter wrench.
Tightening torque for oil filter
1 turn or 14 Nm (1.4 kg-m, 10.1 lb-ft)
WA R N I N G
New and used oil can be hazardous.
Children and pets may be harmed by
swallowing new or used oil. Keep
new and used oil and used oil filters
away from children and pets.
Continuous contact with used engine
oil may cause skin cancer laboratory
animals.Brief contact with used oil
may irritate skin.
To minimize your exposure to used
oil, wear a long-sleeve shirt and
moistureproof gloves (such as dish-
washing gloves) when changing oil. If
oil contacts your skin, wash thor-
oughly with soap and water.
Launder any clothing or rags if wet
with oil.Recycle or properly dispose
of used oil and filters.
EXAMPLE
EXAMPLE
NOTICE
To tighten the oil filter properly, it is
important to accurately identify the
position at which the filter gasket
first contacts the mounting surface.
NOTICE
To prevent oil leakage, make sure
that the oil filter is tight, but do not
over-tighten it.
(1)(2)
EXAMPLE