7-27
INSPECTION AND MAINTENANCE
53MH0-74E
Bulb ReplacementInterior Light
53M-09-046
Pull down the lens by using a flat blade
screwdriver covered with a soft cloth as
shown. To install it, simply push it back in.
The bulb can be removed by simply pulling
it out. When replacing the bulb, make sure
that the contact springs are holding the
bulb securely.
Headlight
53M-09-049
Disconnect the coupler (1). Remove the
sealing rubber (2). Push the retaining
spring (3) forward and unhook it. Then
remove the bulb. Install a new bulb in the
reverse order.
CAUTION
• Light bulbs can be hot enough to
burn your finger right after being
turned off. This is true especially
for halogen headlight bulbs.
Replace the bulbs after they
become cool enough.
• The headlight bulbs are filled with
pressurized halogen gas. They can
burst and injure you if they are hit
or dropped. Handle them carefully.
NOTICE
The oils from your skin may cause a
halogen bulb to overheat and burst
when the lights are on. Grasp a new
bulb with a clean cloth.
NOTICE
Frequent replacement of a bulb indi-
cates the need for an inspection of
the electrical system. This should be
carried out by your MARUTI SUZUKI
dealer.
EXAMPLEEXAMPLE
11-3
SPECIFICATIONS
53MH0-74E
ITEM: Lights
ALTO 800 ALTO K10
WATTAGE BULB No. WATTAGE BULB No.
Headlight 12V 60/55W H4 12V 60/55W
H4
Turn signal lightFront 12V 21W P21W 12V 21W PY21W
Rear 12V 21W PY21W 12V 21W PY21W
Side turn signal light 12V 5W W5W 12V 5W W5W
Position light 12V 5W W5W 12V 5W W5W
Brake/tail light 12V 21/5W P21/5W 12V 21/5W P21/5W
License plate light 12V 5W W5W 12V 5W W5W
Reversing light 12V 21W P21W 12V 21W P21W
Interior light 12V 8W – 12V 8W –
High mount stop light 12V 16W W16W 12V 16W W16W
