Page 436 of 796
02-58710-01
The remote engine control function has been deleted in this model.
1. COMPONENTS
STICS / ICM module
Air bag ECU
Sends the vehicle collision
signals to STICS.
Theft deterrent horn
Installed under the battery.
This horn works only for the
theft deterrent function, panic
function, and remote starting.
SCAN-tool
SIW is used for REKES key
coding and trouble
diagnosis.
REKES
Added the escort and panic
function
RK STICS
ICM module
This module contains
various relays, chime and
buzzer controlled by STICS
Page 469 of 796
02-38
▶Armed mode cancellation requirements
Unlocking by remote control key or engine starting. 1.
▶Warning operation requirements
When opening the door in armed mode
When unlocking the door lock switch in armed mode
When closing and then opening the door after completion of warning (27 seconds) 1.
2.
3.
▶Warning operation
The theft deterrent horn and hazard warning flasher output is “ON” for T3 (27 seconds)
with the interval of T2 (1second). 1.
▶Warning cancellation requirements
Cancels warning by using any signal from the remote control key (LOCK, UNLOCK, START,
STOP, PANIC, CHECK) during warning operation.
Cancels warning after 27 seconds (remaining period) while the ignition key is turned to
“ON” position. 1.
2.
▶Operation when warning is cancelled
The theft deterrent horn and hazard warning flasher outputs are “OFF”. 1.
Page 477 of 796

03-37010-06
1. SPECIFICATIONS
Item Item Specification
Immobilizer
unitOperating voltage
(CAN) 6.0 V to 16.0 V
(6.0 V ~18.0 V)
Operating temperature-30℃ ~ 80℃
Coil inductance420 uH ± 20 uH
Modulation methodFSK
(Frequency Shift Keying : frequency
displacement)
Frequency134.2 KHz ± 4 KHz
TransponderFrequency134.2 KHz ± 4 KHz
Operating temperature-40℃ ~ +85℃
Transponder coding Up to 5
2. CAUTIONS
The vehicle owner must observe the service works when deleting the transponder codes or
registering additional keys.
In any cases, the immobilizer system can not be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed to the vehicle equipped with the immobilizer
system.
Do not drop or shock to the transponder in the ignition key as it may be damaged.
With a damaged transponder, the engine cannot be started.
For the vehicle with the immobilizer, there can be a problem in starting the vehicle or the system
error: 1.
2.
3.
4.
5.
6.
When more than one immobilizer keys come into contact with (each) other(s) or key is close
to any device sending or receiving electromagnetic fields or waves
When the ignition key is close to any electronic or electric devices such as lighting equipment,
security keys or security cards
When the ignition key is close to a magnetic or metal object or a battery -
-
-
Page 483 of 796

03-97010-06
ECU
Immobilizer Indicator and Warning Lamp ▶
This indicator comes on when the ignition
key is communicating with the engine control
unit (during engine starting) and goes out
after starting the engine.
When turning the ignition key to ON position, the
ECU transmits the challenge message to the
immobilizer unit to verify whether the key is valid. (1)
Only when the two signals are identical, it
recognizes the key as the authorized one and
transmits the positive message to the ECU.
The ECU allows the engine to be started. (6)
(7)
Do not drop or shock to the transponder in the key as it may be damaged.
With a damaged transponder, the engine cannot be started.
When you erase the code or register an extra key, let the owner attend on the site.
In any case, the immobilizer system cannot be removed from the vehicle. If you attempt to
remove it and damage the system, starting will be impossible, so never attempt to remove,
damage or modify it.
The remote engine starter cannot be installed on the vehicle equipped with the immobilizer
system. -
-
-
-
-Lamp ON: in communication
Blinking twice for one second:
immobilizer system failure
Blinking once for two seconds:
immobilizer unit is not coded
The immobilizer indicator does not come
on if the communication time between
immobilizer key and ECU is too short.
Immobilizer Indicator and Warning Lamp