2013 SSANGYONG NEW ACTYON SPORTS sunroof

02-4
Input Signals
▶
NO.
Input Signal Name Logic Status
1 IGN1 ON = BAT
(IGN ON or START)
2 IGN2 ON = BAT (IGN ON)
3 ALT_D ON = BAT (engine started)
4 Key reminder switch IN = BAT (key in)
5 Driver's door switch OPEN = GND, CLOSE = OPEN
6 Passenger's door switch OPEN = GND, CLOSE = OPEN
7 Rear door switch - OPEN (one of rear doors) = GND
- CLOSE (all rear doors) = OPEN
8 Hood switch OPEN = GND, CLOSE = OPEN
9 Driver's door lock/unlock switch LOCK = OPEN, UNLOCK = GND
10 Passenger's door lock/unlock switch LOCK = OPEN, UNLOCK = GND
11 Rear door lock/unlock switch - UNLOCK (one of rear doors)
= GND
- LOCK (all rear doors) = OPEN
12 Tailgate lock/unlock switch LOCK = OPEN, UNLOCK = GND
13 Rear defogger switch ON = GND, OFF = OPEN
14 Seat belt switch Unfastened = GND, Fastened = OPEN
15 Sunroof open switch ON = GND, OFF = OPEN
16 Parking brake switch ON = GND, OFF = OPEN
17 Air bag collision sensor ON = 200 ms output (LOW), OFF = OPEN
18 Wiper motor (parking) switch STOP = BAT VOLTAGE, ROTATING = GND
19 Washer switch ON = BAT, OFF = OPEN
20 INT-AUTO switch ON = BAT, OFF = OPEN
21 Auto washer switch ON = BAT, OFF = OPEN
22 Intermittent resistance 0W ~ 51KW (for intermittent wiper)
23 Speed sensor ON = GND (PWM), OFF = OPEN
24 Mirror lock/unlock switch ON = GND, OFF = OPEN
25 Front defogger switch ON = GND, OFF = OPEN
26 Auto hazard switch ON = GND, OFF = OPEN

02-558710-01
STICS Outside Rearview Mirror Folding/Unfolding Control Circuit
▶
If you remove the ignition switch and open the driver's door with the su\
nroof open, the chime buzzer
sounds.
As soon as you close the driver's door or the sunrooof, the chime buzzer\
output stops.
However, when operating conditions in step (1) are met after the opera\
tion in step (2), the chime
buzzer will not sound again. If you turn the ignition swtich to the "ON"\
position again and the
operating contions in step (1) are met, the chime buzzer sounds again.\
If the operating condtions for door ajar warning and sunroof open warnin\
g are met at the same time,
the sunroof open warning is activated preferentially.
1.
2.
3.
4.
In order to prevent the driver from getting off the
vehicle with the sunroof open, the reminder function for
the driver is added. This function is activated as follows: Sunroof open warning
▶

04-37340-00
1. SPECIFICATIONS
2. CAUTIONS WHEN WORKING
Wear clean work clothes and gloves.
Replace and wash the gloves frequently.
Any unauthorized modification or operational test is not allowed since the sunroof motor and control
unit are preset at the factory.
Take care not to drop the sunroof assembly when removing it and do not keep it right up. 1.
2.
3.
4.
Operating voltage 9 ~ 16 V
Operating current (open & close) Max. 6 A
At no load Max. 2 A
Leakage current Max. 1 mA or less
Roof motor operating speed (at opening and closing)1.2 ± 0.5 sec./100 mm
Motor overload stop conditionsCurrent for up to 26 A and torque (load)
for up to 8.3 Nm
Opening amount230 ± 3
Vertical/horizontal tolerance for sunroof glass panel± 2 mm/± 2.5 mm
3. CAUTIONS FOR OPERATION
Even though the sunroof can be operated when the engine is not running, operating the sunroof
repeatedly with the engine turned off will run down the battery. Operate the sunroof while the engine is
running.
When the sunroof operation is completed, release the switch. Keeping pressing the switch can result
in malfunction.
Especially in winter, never operate the sunroof if operation areas are iced. Wait until melted.
Make sure that the sunroof is completely closed when leaving the vehicle. Leaving the vehicle with the
sunroof open result in a theft. In addition, rain or snow can get into the vehicle through the open
sunroof.
When the sunroof is fully open, wind buffeting symptom can be worse. In this case, try to adjust the
sunroof position manually or open the sunroof until the wind buffeting is disappeared
Parts of the body can be trapped in the sunroof and can be struck by passing objects. Do not stick
hands, head or anything else out of the openings.
Remove any dirt and foreign material stuck on the edge of the sunroof glass periodically.
Noise can occur due to friction when operating the sunroof. -
-
-
-
-
-

04-4
TILTOPEN
Sunroof switch
1. SYSTEM LAYOUT
Sunroof assemblySunroof motor &
control unit

04-57340-00
2. OPERATING PROCESS
1) Sunroof Switch
This can be closed or open manually to block sunlight when the sunroof function is not in use. The sunroof glass can be open automatically and can be tilted by the switch operation. The sunroof switches are included in the overhead console switches and consists of the TILT,
CLOSE and OPEN switches.
CLOSE
OPEN ▷
▷
Sun shade blindSunroof glass Sunroof operation switch ▶
Closes the sunroof.
Opens the sunroof.
Sunroof glass ▶
Roller blind ▶

04-6
2) Sunroof Sliding Opening/Closing
Opening sunroof (Sliding open) ▶
Auto open
When turing the switch to the "OPEN" position briefly, the sunroof is tilted up and opened
automatically until it stops. The sunroof operation stops if you operate the switch during its operation.
Manual open
1st step (tilt up): When making a long turn of the switch to the "OPEN" position with the sunroof
closed, it is tilted up.
2nd step (opens by itself from tilted up condition): When making a long turn of the switch to the
"OPEN" position with the sunroof tilted up, it opens only whilst turning the switch. -
-
Closing sunroof (Sliding close) ▶
Manual close
While turning the switch to the "CLOSE" position, the sunroof is closed. Release the switch at the
desired position.
Since the sunshade blind does not operate together with the sunroof, you should open and
close it manually.