2013 SKODA OCTAVIA stop start

[x] Cancel search: stop start

fuse box USB change language adblue reset fuse chart lights

Load previous 8 pages

Page 67 of 90

SKODA OCTAVIA 2013 3.G / (5E) Columbus Navigation System Manual Search selection near the location, destination, stopover and
along the routeFig. 45
Search area for POIs
First read and observe the introductory information given on page 63.
Explanation of graphic

Page 71 of 90

SKODA OCTAVIA 2013 3.G / (5E) Columbus Navigation System Manual Nav. announcementsFirst read and observe the introductory information given on page 67.
The device outputs the navigation announcements. The navigation announce-
ments are started as soon as the route

Nav. announcementsFirst read and observe the introductory information given on page 67.
The device outputs the navigation announcements. The navigation announce-
ments are started as soon as the route calculation is complete or a route type has
been selected.
Before turning, up to 3 recommendations are issued: The last navigation announcement can be repeated: › by pressing the menu knob
2

» Fig. 1 on page 5;
› Press the dial
2

» Fig. 10 on page 14 on the multifunction steering wheel.
The timing of the navigation announcement depends on the type of road and the
driving speed. For example, on motorways the first announcement is heard about 2000 m (6000 ft) before the location of the motorway exit.
During dynamic route guidance, the unit notifies the driver of traffic problems. If a
new route is calculated due to traffic problems, the Calculating the route... an-
nouncement is sounded.
Set the output volume of the navigation announcements or mute it during a phone call » page 53.

Route
First read and observe the introductory information given on page 67.
When there is a calculated route to the destination, the recommended route is
displayed.
›
In the navigation main menu, press  .
The following menu is displayed: ■ Stop route guidance - Stops route guidance
■ New dest./stopover - Enter a new destination or add a destination to the calcu-
lated route » page 60 or » page 71

■
Route information - Display information about the destination and the calcula-
ted route (setup of information displayed » page 54)
■  - Arrival time at destination/stopover 1)
■  - Remaining travelling time to destination or stopover 1)
■  - Remaining travelling distance to destination or stopover
■ Store destination - Stores the destination on the input screen » page 9
■ Route list - Displays the list of route sections
■ Tour - display of tour destinations » page 71
■ Congestion ahead - If you hear of a traffic problem (e.g. congestion), you can
enter this traffic problem manually. After entering, this device recalculates and
provides an alternative route. The traffic jam information increases or decreases
by touching the scale /  or by turning the menu button 2
» Fig. 1 on page 5.

Lane guidance
Fig. 47
Lane guidance
First read and observe the introductory information given on page 67.
A split screen lane guidance
A
» Fig. 47 may sometimes be shown during the
route guidance at some intersections, motorway junctions, multilane roads, and
similar.
This split screen with the lane guidance is only displayed only if information about the traffic area is available in the navigation data.
Switch function » page 53on/off.


1)
If the time of arrival or remaining travelling time is greater than 24 hours,  is displayed inside the
symbol.
69Navigation

Page 73 of 90

SKODA OCTAVIA 2013 3.G / (5E) Columbus Navigation System Manual NoteMaking a diversion from a traffic jam based on TMC traffic reports may not always
offer a time advantage, e.g. if the diversion route is also congested.
Detailed traffic reports
First read and

NoteMaking a diversion from a traffic jam based on TMC traffic reports may not always
offer a time advantage, e.g. if the diversion route is also congested.
Detailed traffic reports
First read and observe the introductory information given on page 70.
After pressing the TRAFFIC button, a screen appears with the following informa-
tion:
■ Function key All - Show all traffic information
■ Function key Route - only display the traffic information on the current route
■ A map showing the traffic obstruction
■ A window with a description of the traffic information
■ Location of event, the accuracy depends on the timeliness of the navigation
data
■ Description of up to three events related to the respective information
■ Description of the direction with respect to the event
■ probable duration of the event
■ Additional information, such as probable delay time
■ An information line, on how current the information is and on the provider of
the message
■ Symbol that specifies the type of information
■  - zoom in window with described traffic obstruction
■  - zoom out window with described traffic obstruction
■  - show previous traffic information
■  - show the following traffic information
■  - display list of all received traffic messages

My tour
 Introduction
This chapter contains information on the following subjects:
New tour
71
Tour editing
72
Tour memory
72First and foremost, pay attention to the safety instructions » page 4 , Important
notes .
New tour
Fig. 48
Entering a new tour
First read and observe the introductory information given on page 71.
›
In the navigation main menu, press 
→ New tour to open a menu for entering
a new tour
The route can be preset. After entering the route, you can start the guidance or
save the route for use at a later date.
You can switch the individual destinations by pressing a destination and dragging
it to another position.
Pressing the function key with the destination opens a window with function
keys for destination processing.
Explanation of graphic Enter a new destination
Select a destination from the list of stored destinations » page 62
Save the route in the tour memory
Calculate the specified route and start the route guidance Stop the route guidance
Stopover with sequential number Destination
Arrival time at destination/stopover 
ABCDE71Navigation

Page 74 of 90

SKODA OCTAVIA 2013 3.G / (5E) Columbus Navigation System Manual Distance to destination or stopoverDelete the stopover
Start direct route guidance
Open the destination details » page 73
When you press the name of the destination or stopover, the system displays

Distance to destination or stopoverDelete the stopover
Start direct route guidance
Open the destination details » page 73
When you press the name of the destination or stopover, the system displays a
menu where you can edit the destination ( ,
 ,
 ).
After the route has been calculated, the unit displays the arrival times at the indi- vidual destinations and the remaining distance to the destination.
Tour editing
First read and observe the introductory information given on page 71.
›
In the navigation main menu, press 
→ Edit tour to open a list containing the
destinations for the current route.
The route guidance is not cancelled.
When you press the name of the destination or stopover, the system displays a
menu where you can edit the destination » page 71.

Tour memory
First read and observe the introductory information given on page 71.
›
In the navigation main menu, press 
→ Tour memory to open a list containing
all saved routes.
When you confirm a route from the list, the system opens a menu for the selected
route containing destinations; here, you can edit the destinations and start the
route guidance. » page 71
Destination management
Introduction
This chapter contains information on the following subjects:
Stopover
72
n details
73
First and foremost, pay attention to the safety instructions » page 4 , Important
notes .

Stopover
First read and observe the introductory information given on page 72.
It is possible to add up to ten stopovers to the route during route guidance. The
route guidance is according to the sequence of the stopovers on the route. After
the next stopover has been reached, route guidance to the following stopover
continues.
›
In the navigation main menu, press 
New dest./stopover a menu opens for en-
tering a new destination » page 60 and then in the next step a menu for desti-
nation details » page 73.
If the route guidance is active, then after confirming with Start the device shows
after entering the stopover the message, Route guidance is already active. Do
you want to start route guidance directly to the new destination or add the new
destination as a stopover? and the following points » Fig. 48 on page 71 :
■ Cancel - the stopover destination input and the destination guidance to the
original destination is continued
■ Stopover - the destination entered is added to the route and guidance to this
destination is initially provided
■ Start - the destination entered is added as the final destination and the original
final destination is replaced by this new destination
After reaching the maximum number of ten stopover destinations one of the stopover destinations is to be deleted in order to enter the next destination.

72Navigation

Page 78 of 90

SKODA OCTAVIA 2013 3.G / (5E) Columbus Navigation System Manual Range (if the estimated range is less than 300 km, the vehicle starts to ap-
proach the symbol: )
Vehicle representation (the zones of the vehicle are shown in different col- ours, corresponding t

Range (if the estimated range is less than 300 km, the vehicle starts to ap-
proach the symbol: )
Vehicle representation (the zones of the vehicle are shown in different col- ours, corresponding to any warning messages that occur. The warning mes-
sages are displayed once you touch vehicle)
■ Driving data - Display travel data » Fig. 51
You can display one of three trip memories on the screen:
■ Since start - Driving data for the individual trip
■ Long-term - Long-term driving data
■ Since refuelling - Data since last refuelling
Changing between the individual travel data storage locations can be done with  / 
.
■ Convenience consumers - Displays up to three devices which use the largest
share of fuel and displays the fuel consumption required to run all conv. con-
sumers » Vehicle Owner's Manual , chapter Commercial driving and environmen-
tal compatibility
■ Vehicle status - Displays vehicle status » Fig. 51 or tyre pressure monitoring in-
formation
■ Vehicle status - Displays vehicle status information
■ / 
- No message/warning messages relating to vehicle status or number
of messages (if there is only one message, one warning message text is dis-
played)
■  - Display information about the status of the START-STOP system
■ TPMS - Tyre pressure monitoring function » Fig. 52
■  SET - Start a new calibration process
Changing between the individual menus can be done with 
/ 
.
Note
For more information on the warning messages concerning the vehicle status and
information on the START-STOP system, see the » Vehicle Owner's Manual .FGAuxiliary heater and ventilationFig. 53
Auxiliary heater: Main menu/set preset time
First read and observe the introductory information given on page 74.
Press the CAR/SETUP button on the Climatronic unit
→ 
.
Set-up Departure time: Day and time when the vehicle is to be ready for use » Fig. 53
Heating/ventilation: Set the operating mode
Select the preset time, switch off the preset timeSet the preset times 1 to 3 and the duration (10 - 60 minutes)
When the heating or ventilation is running, the windows are highlighted in
red or blue
Note
■ Only one preset time can be active. The activated preset time will be deactiva-
ted again after it has started automatically. For the next start, activate one of the preset times.■
In the selection of the day in the preset time, there is an option between Sun-
day and Monday without the specified day. If this setting is made, the vehicle will
be ready for use at the selected time, regardless of the current day.
■
The system in operation switches off on expiration of the operating duration or
can be deactivated by pressing the direct on/off icon  or by using the radio re-
mote control.
■
If a different time is set » page 21, Time and date settings , the activated preset
time is automatically deactivated. The preset time must be reactivated.

ABCDE76Vehicle

Page 87 of 90

SKODA OCTAVIA 2013 3.G / (5E) Columbus Navigation System Manual R
Radio
24
Automatic scan25
DAB - settings28
FM - settings28
List of available stations25
Main menu24
Multifunction steering wheel11
Operation24
Preface24
Radio station store25
Search25
Settings27
Sta

Page: < prev 1-8 9-16

air bleeding automatic transmission fluid navigation winter tyres dead battery turn signal