82A-3V1 MR-372-J84-82A000$010.mif
ENGINE IMMOBILISER
Fault finding – Introduction82A
SVT
Vdiag No.: 04
4. REMINDER
Procedure
To run fault finding on the vehicle computers, switch on the ignition. Connect the diagnostic tool and perform the
required operations.
SCENIC II and MEGANE II:
To run fault finding on the vehicle computers, switch on the forced + after ignition feed.
Proceed as follows:
LOGAN, SANDERO, DUSTER, MASTER II ph2 and ph3, THALIA 2/SYMBOL 2, CLIO II F6, KANGOO VLL
To run fault finding on the vehicle computers, switch on the + after ignition feed.
Proceed as follows:Switch on the forced + after ignition feed:
– with the vehicle card in the card reader,
– press and hold the Start button (longer than 5 seconds) with start-up conditions not fulfilled,
– connect the diagnostic tool and perform the required operations.
Switching off the forced + after ignition feed:
Press the Start button twice briefly (less than 3 seconds).
Ensure that the + after ignition feed has been cut off by checking that the computer warning lights on the instrument
panel have gone out.
For vehicles with key/radiofrequency remote control unit,
switch on the ignition with the key.
