2013 RENAULT KANGOO diagnostic menu

87B-6V1 MR-376-X76-87B000$040.mif
PASSENGER COMPARTMENT CONNECTION UNIT
Fault finding – Configuration87B
UCH
VDiag No.: 0F
CONFIGURATION OF THE UCH COMPUTER
●With the ignition on, establish dialogue with the UCH computer.
●In the Repair Mode menu, go to the Configuration tab.
Choose the scenario: SC008 UCH type and follow the instructions on the diagnostic tool.
Single Door Opening (SDO*) function:
Configuration CF272 SDO* enables the activation or deactivation of the Single Door Opening function.
There are two possible options for the configuration of this function:
WITH:
An initial press of the button unlocks the driver's door.
Pressing the button for a second time unlocks the whole vehicle after a predefined time.
WITHOUT:
Pressing the button once only unlocks the whole vehicle.
Check the configuration has been correctly stored using the Configuration reading menu.
*SDO: Single Door Opening

87B-27
AFTER REPAIRCarry out a road test, followed by a check with the diagnostic tool.
V1 MR-376-X76-87B000$130.mif
PASSENGER COMPARTMENT CONNECTION UNIT
Fault finding – Interpretation of commands87B
UCH
VDiag No.: 0F
VP004ENTERING THE VIN
NOTESThis command permits manual entry of the vehicle's VIN into the computer.
Use this command each time the computer is replaced.
The vehicle identification number is indicated on the manufacturer's plate on the
right-hand side door pillar.
Procedure for writing the VIN
– establish dialogue with the UCH,
– select the repair mode menu,
– select the other settings menu,
– select line VP004 Write VIN,
– enter the VIN twice,
– exit fault finding mode,
– switch off the ignition,
– wait for the end of power latch,
– re-read the VIN using ID019 VIN Code in the Identification menu for confirmation.
UCH_V0F_VP004

87B-29
AFTER REPAIRRepeat the conformity check from the start.
V1 MR-376-X76-87B000$130.mif
PASSENGER COMPARTMENT CONNECTION UNIT
Fault finding – Interpretation of commands87B
UCH
VDiag No.: 0F
UCH programming procedure
– Establish dialogue with the UCH.
– Select the Repair mode menu.
– Select the Programming menu.
– Select line SC004 Program UCH.
Follow the instructions on the CLIP diagnostic tool.
In "not connected" mode, when the Clip diagnostic tool displays the programming key, make a note of this key and
the VIN.
To obtain the immobiliser code, see Technical Note 5037A, Code delivery procedure.
Operations to be carried out after programming the UCH
Enter the vehicle's VIN into the computer using command VP004 Enter VIN.
After programming the UCH, allocate all the keys using command SC015 Allocate key.
Configure the equipment that is present or not on the vehicle using command SC008 UCH type.
SC004
CONTINUED
IMPORTANT
Do not interrupt the procedure when it is in progress.
If it is interrupted, restart the procedure in "not connected mode"; a new programming key will be displayed.
IMPORTANT
In "not connected" mode, the programming key can only be used for a limited amount of time, as indicated by the
Clip diagnostic tool.
After this time, the programming key and associated immobiliser code are no longer valid. The operation must be
restarted from the beginning.