2013 RENAULT CLIO CUP 98CUP_2013 Release

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-26

B.6.5 ADJUSTING THE DRIVING POSITION

B.6.5.1 Adjusting the steering wheel

To optimize the driving position, the height and de epness of the steering wheel may be
adjusted by unlocking the steering column lever (1)


NOTE :
After having set the
steering column position,
the adjustment lever
must be removed (1
screw to remove). It is
strictly forbidden to run
with it (FIA regulation)



B.6.5.2 Adjusting the seat

To move the seat forwards or backwards, place the s eat in the required position and then
re-screw the brackets in the appropriate holes (2).

The height and angle of the seat may be adjusted th e same way by altering its
attachment points on the brackets (3).


(2)
(3)

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-27

B.6.6 VENTILATION

The vehicle has 4 air vents: · 1 in the middle of the facia : activated by the “he at” switch on facia switch panel
· 2 on the roof: air coming though the roof hatch

Ventilation on the facia upper surface:

View from below:
The air comes from the electric ventilator and is directed by the lower duct to the facia


Electric
ventilator fitted
on the engine
bulkhead

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-28

Roof ventilation:

B.7 SAFETY EQUIPMENT

B.7.1 FIRE EXTINGUISHER

Each vehicle is equipped with an extinguishing
system targeting the driver compartment and the
engine compartment.
The fire extinguisher is located behind the driver’ s
seat.




The fire extinguisher is fitted on its support usin g 2 metallic straps which are mandatorily
screwed (automatic clamping forbidden).
The fire extinguisher support is fitted on the chas sis using 4 M6 screws (+2 spacers) + 4
nuts screwed under the chassis through plates (weld ed to the chassis)

Control unit
(3 positions)
2 mandatory
screwed clamps
Roof hatch Inside aerator

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-29

The system consists of 3 jets:
· In the driver compartment right hand side of the st eering wheel


· 2 in the engine compartment

1 pointing on the Turbo : 1 pointing on the air intake :

Use:
The extinguishing system can be triggered in 2 different ways:

· The driver presses on the button “Fire Ext” situate d on the Facia
control panel (9)
· From Outside: by pressing the button (E) located on the outside of the vehicle at
the base of the windshield pillar, and which must b e indicated by a red letter E.

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-30

You must fit the wiring of the white connector directly on the plastic windscreen lower
grid using a tyrap® as indicated below:



The fire extinguisher is controlled by a deported c ontrol unit fitted on the central tunnel.
A specific fire extinguisher loom allows to link th is control unit + fire extinguisher to the
chassis loom.

Position 1: system isolated

This position is to test the extinguisher loom. Eve rything must be correctly connected to
the loom. When you push the fire button (Facia swit ch panel or from outside deported
button), the green light must go ON but the extinguisher will n ot deploy.


NOTE :
if the green light is ON without testing the syste m, there is a default on the
loom. In this case, you must be careful because the extinguisher is directly connected to
the command box. As a consequence, if you switch to position 3, you will immediately
deploy the extinguisher.
Position 2: battery check


If the orange light goes ON, the battery is ok.
Position 3: system armed


“System armed” means that if you push the fire butt on (Facia switch panel or from
outside deported button), you will immediately depl oy the extinguisher.
The green light goes ON only when the extinguisher is deployed.
3
1
2 deported
control unit

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-31


Checks
-
Extinguisher cylinder compliance check:


The following information must be clearly
visible on the cylinder: · Serial number.
· Capacity and weight or volume of
extinguisher product.
· Activation date or date of last system check.
· Date of next service.
· Homologation number.

Take care not to exceed the extinguisher’s
next scheduled service date.

- Pressure check


The pressure of the cylinder may be checked using a
manometer placed on the cylinder.
The needle must be situated in the green area on th e
manometer dial.
B.7.2 CIRCUIT BREAKER

There is an emergency circuit breaker control at
the base of the windshield pillar. It must be
indicated by a sticker with a red lightening symbol
on a blue background. This button may be used to
switch off the vehicle’s electrics from the outside .



B.7.3 OTHER SAFETY EQUIPMENT
- The presence of the window safety net (ref. 77 11 160 041) on the driver side of
the roll cage is mandatory.

- It is mandatory for foam (ref 77 11 160 040) to be placed on all parts of the roll
cage with which the driver’s helmet may come into c ontact.
- The seats (original part ref: 77 11 167 158 and XL version part ref: 77 11 167
160 ) and the harness (ref 77 111 167 161) are compatible with FHR system.

The use of « FHR » system must be in compliance with the installation
standard of FIA.

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-32


B.7.4 PASSENGER SEAT

A passenger seat may be installed on Clio Cup using the supports with part ref
8201380465 and 8201380466
The seats references remain the same as for driver side.

Fasteners:


Seat supports on the chassis:
Screws CHC10-25 x 4 77 11 156 901
Contact washer Ø10X22 x 4 77 11 156 926
Flat washer Ø10,25X26 ép:3 cl:10.9 x 4 77 03 053 341

Seat on the support :
Screws M8-35 cl.12,9 x 4 77 11 154 904
Contact washer Ø8X18 x 4 77 11 156 945

B.8
BALLAST

To respect the minimum weight
and the race weight
(refer to technical regulation and Nomenclature), s ome
ballast may be fitted.

Only the following ballast must be used: - 1kg: ref 77 11 160 299
- 2kg: ref 77 11 160 300
- 5kg: ref 77 11 160 301

These plates must be mounted using two drilled head
bolts with part ref 77 11 160 302 (sold in sets of 2).
In all cases, these ballast plates will be fitted a t the passenger seat rail sites,
(refer to the current Technical Regulations and Nom enclature).

Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release

C-33

B.9 APPENDIX
B.9.1 LIST OF MARKED PARTS

All parts that are specific to Clio Cup are engrave d.
The following genuine Renault parts are identified either by a “Renault Sport” laser
engraving or by a hologram (its presence is compuls ory with NO PAINT)

PART NAME REFERENCE “RENAULT SPORT” HOLOGRAM
Engine bulkhead heat shield 67900 6317 R X
Front shock absorber 98CUP00040 X
Rear Wing 8201380868 X
Battery 7711127895 X
Rear spoiler 96030 5963 R X
Airbox 8201378943 X
Steering column 8201372112 X
Air intake duct 8201409155 X
Left lower air Guide 21469 1078 R X
Left air guide 21559 0558 R X
Right air guide 21558 9177 R X
Roof inside aerator 77 11 160 315 X
Battery cover 77 11 162 704 X
Dashboard Cosworth ICD 82 01 372 416 X
ECU Cosworth SQ7 82 01 381 101 X
Front left door inside cover 82 01 382 021 X
Front right door inside cover 82 01 382 023 X
Facia air duct 82 01 389 867 X
Fire extinguisher 82 01 396 046 X
Water Fan 214819617R X
Rear spoiler lower cover 960303776R X
Turbo air exchanger 98CUP00006 X
Complete fuel tank 98CUP00008 X
Water cooler 98CUP00009 X
Front Right headlight 98CUP00015 X
Front Left headlight 98CUP00017 X
Rear Right light on rear cover 98CUP00022 X
Rear Left light on rear cover 98CUP00024 X
FR door window 98CUP00058 X
FL door window 98CUP00059 X
RR door window 98CUP00061 X
RL door window 98CUP00062 X
RR quarter window 98CUP00063 X
RL quarter window 98CUP00064 X
Rear bumper skin 98CUP00065 X
Rear window 98CUP00068 X
Right rearview mirror 98CUP00070 X
Left rearview mirror 98CUP00071 X
Left rearview mirror cover 98CUP00072 X
Right rearview mirror cover 98CUP00073 X
Windscreen 98CUP00084 X
Roof hatch 82 01 383 889 X
Front crossbeam 752107246R X
rear air diffuser 960302211R X
FR mudguard 98CUP00074 X