Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-30
You must fit the wiring of the white connector directly on the plastic windscreen lower
grid using a tyrap® as indicated below:
The fire extinguisher is controlled by a deported c ontrol unit fitted on the central tunnel.
A specific fire extinguisher loom allows to link th is control unit + fire extinguisher to the
chassis loom.
Position 1: system isolated
This position is to test the extinguisher loom. Eve rything must be correctly connected to
the loom. When you push the fire button (Facia swit ch panel or from outside deported
button), the green light must go ON but the extinguisher will n ot deploy.
NOTE :
if the green light is ON without testing the syste m, there is a default on the
loom. In this case, you must be careful because the extinguisher is directly connected to
the command box. As a consequence, if you switch to position 3, you will immediately
deploy the extinguisher.
Position 2: battery check
If the orange light goes ON, the battery is ok.
Position 3: system armed
“System armed” means that if you push the fire butt on (Facia switch panel or from
outside deported button), you will immediately depl oy the extinguisher.
The green light goes ON only when the extinguisher is deployed.
3
1
2 deported
control unit
Downloaded from www.Manualslib.com manuals search engine 98CUP_2013 Release
C-32
B.7.4 PASSENGER SEAT
A passenger seat may be installed on Clio Cup using the supports with part ref
8201380465 and 8201380466
The seats references remain the same as for driver side.
Fasteners:
Seat supports on the chassis:
Screws CHC10-25 x 4 77 11 156 901
Contact washer Ø10X22 x 4 77 11 156 926
Flat washer Ø10,25X26 ép:3 cl:10.9 x 4 77 03 053 341
Seat on the support :
Screws M8-35 cl.12,9 x 4 77 11 154 904
Contact washer Ø8X18 x 4 77 11 156 945
B.8
BALLAST
To respect the minimum weight
and the race weight
(refer to technical regulation and Nomenclature), s ome
ballast may be fitted.
Only the following ballast must be used: - 1kg: ref 77 11 160 299
- 2kg: ref 77 11 160 300
- 5kg: ref 77 11 160 301
These plates must be mounted using two drilled head
bolts with part ref 77 11 160 302 (sold in sets of 2).
In all cases, these ballast plates will be fitted a t the passenger seat rail sites,
(refer to the current Technical Regulations and Nom enclature).
