Wheel, Heated........................ .173
Wheel, Tilt ........................... .172
Steering Wheel Audio Controls ................311
Steering Wheel Mounted Sound System Controls . . .311
Storage Compartment, Center Seat .............216
Storage, Vehicle .......................... .331
Storing Your Vehicle ...................... .685
Sun Roof .............................. .202
Supplemental Tire Pressure Information .........508
Suspension, Air .......................... .410
Sway Control, Trailer ...................... .485
Synthetic Engine Oil ...................... .645
System, Remote Starting .....................30
Tachometer ............................. .255
Tailgate ............................... .242
Temperature Control, Automatic (ATC) ..........324
Tilt Steering Column ...................... .172
Tip Start ............................... .343Tire and Loading Information Placard
...........493
Tire Markings ........................... .487
Tires ................................. .120
Aging (Life of Tires) .....................506
Air Pressure .......................... .498
Chains .............................. .509
Compact Spare ........................ .503
Dual ............................... .512
General Information .....................498
High Speed .......................... .501
Inflation Pressures ...................... .499
Life of Tires .......................... .506
Load Capacity ........................ .493
Pressure Monitor System (TPMS) ............513
Pressure Warning Light ...................260
Quality Grading ....................... .719
Radial .............................. .501
Replacement .......................... .507
Rotation ..............................
511
736 INDEX
INSTALLATION OF RADIO TRANSMITTING EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
