2013 Ram 1500 floor

NOTE:Ensure that the jack slides into the front hold
down location.
5. Turn the wing bolt clockwise to secure to the floor pan. Reinstall the plastic cover.WARNING!
After using the jack and tools, always reinstall them
in the original carrier and location. While driving
(Continued)
Jack Hold Down FastenerJack And Tools (1500 Series)6
WHAT TO DO IN EMERGENCIES 589

Reinstalling The Jack And Tools (2500 And 3500
Series)
1. Tighten the jack all the way down by turning the jackturn-screw counterclockwise until the jack is snug.
2. Position the jack and tools into bracket assembly. Make sure the lug wrench is under the jack near the
jack turn-screw. Snap tools into bracket assembly clips.
Install the jack into bracket assembly and turn the
jack-turn-screw clockwise until jack is snug into
bracket assembly.
3. Place the jack and tool bracket assembly in the storageposition holding the jack by the jack turn-screw, slip
the jack and tools under the seat so that the bottom slot
engages into the fastener on the floor.
Jack And Tools Bracket Assembly
606 WHAT TO DO IN EMERGENCIES

NOTE:Ensure that the jack and tool bracket assembly
slides into the front hold down location.
4. Turn the wing bolt clockwise to secure to the floor pan. Reinstall the plastic cover.Hub Caps/Wheel Covers — If Equipped
The hub caps must be removed before raising the vehicle
off the ground.
Jack Hold Down FastenerJack And Tools (2500/3500 Series)6
WHAT TO DO IN EMERGENCIES 607

These dual rear wheels should be tightened as follows:
1. Tighten the wheel nuts in the numbered sequence to asnug fit.
2. Retighten the wheel nuts in the same sequence to the torques listed in the table. Go through the sequence a second time to verify that specific torque has been
achieved. Retighten to specifications at 100 miles
(160 km) and after 500 miles (800 km).
It is recommended that wheel stud nuts be kept torqued
to specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
HOISTING
A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking loca-
tions. However, a floor jack or frame hoist must never be
used on any other parts of the underbody.
CAUTION!
Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.
Tightening Pattern
6
WHAT TO DO IN EMERGENCIES 611

Spray-On Bedliners are chemically-resistant to many
different types of chemicals (including gasoline, oil,
hydraulic fluids) for short periods of time. If a spill
occurs on your Spray-On Bedliner, rinse the truck out as
soon as possible to avoid permanent damage.
Repairing The Spray-On Bedliner
While extremely tough, it is possible to damage a
Spray-On Bedliner. One common condition is when
loading a heavy pallet and dragging that pallet across the
floor of the bed. If a nail or sharp point is exposed under
the weight of the pallet a scratch or tear is possible. While
not covered by your new vehicle warranty, a cosmetic fix
to cover the metal exposed by the scratch is required. To
repair a tear or gouge, follow the directions provided in
the MOPAR® Quick Repair Kit.FUSES
POWER DISTRIBUTION CENTER
The Power Distribution Center is located in the engine
compartment near the battery. This center contains car-
tridge fuses, micro fuses, relays, and circuit breakers. A
description of each fuse and component may be stamped
on the inside cover, otherwise the cavity number of each
fuse is stamped on the inside cover that corresponds to
the following chart.
668 MAINTAINING YOUR VEHICLE

Starting............................. .528
Flooded Engine Starting ....................345
Fluid, Brake ............................ .692
Fluid Capacities ......................... .689
Fluid Leaks ............................ .124
Fluid Level Checks Brake ............................... .654
Fluids, Lubricants and Genuine Parts ...........691
Fog Lights ............................. .166
Fold Flat Load Floor ...................... .227
Four-Way Hazard Flasher ...................571
Four Wheel Drive ........................ .386
Freeing A Stuck Vehicle .....................616
Front Axle (Differential) .....................656
Fuel .................................. .521
Adding ............................. .530
Additives ............................ .524
Clean Air ............................ .522
Ethanol ............................. .522Filler Cap (Gas Cap)
.....................531
Gasoline ............................. .521
Materials Added ....................... .524
Methanol ............................ .522
Octane Rating ......................... .521
Requirements ......................... .521
Tank Capacity ......................... .689
Fuel, Flexible ........................... .526
Fuel System Caution ...................... .530
Fuses ................................. .668
Gas Cap (Fuel Filler Cap) ...................531
Gasoline, Clean Air ....................... .522
Gasoline (Fuel) .......................... .521
Gasoline, Reformulated .....................522
Gauges Speedometer ......................... .262
Tachometer ........................... .257
Gear
Ranges ............................ .365
10
INDEX 719

Restraint, Head.......................... .154
Restraints, Child ...........................84
Restraints, Occupant ........................47
Rotation, Tires .......................... .506
Safety Checks Inside Vehicle .................122
Safety Checks Outside Vehicle ................124
Safety Defects, Reporting ....................709
Safety, Exhaust Gas ....................... .121
Safety Information, Tire .....................482
Safety Tips ............................. .120
Schedule, Maintenance .....................696
Seat Belt Maintenance ..................... .666
Seat Belt Reminder .........................64
Seat Belts ................................47
Adjustable Upper Shoulder Anchorage .........59
And Pregnant Women .....................65
Child Restraint ..........................84
Extender ..............................65 Front Seat
.............................51
Inspection ........................... .122
Pretensioners ...........................63
Reminder ............................ .261
Untwisting Procedure .....................59
Seats ................................. .140
Adjustment .......................... .140
Folding Floor ......................... .227
Memory ............................. .156
Power .............................. .141
Rear Folding ......................... .151
Reclining Rear ........................ .150
Security Alarm (Theft Alarm) ..................21
Selection of Coolant (Antifreeze) ...............691
Sentry Key (Immobilizer) ....................18
Sentry Key Programming ....................20
Sentry Key Replacement .....................19
Service Assistance ........................ .705
Service Contract ......................... .707
726 INDEX