2013 Ram 1500 wiring

7. Reach into the front wheel house ahead of the frontwheel, remove the fastener, and lift the cover over the
access hole in the front of the wheel house splash
shield. Access to the rear of the lamp can be gained
through this access hole.
8. Reach through the access hole of the wheel house splash shield and lift the slide lock upward far enough
to disengage it from the lock post on the back of the
front lamp unit housing.
9. Remove the headlamp assembly. Grasp the outboardedge of the lamp and pull it straight forward to
disengage the ball stud from the plastic grommet.
10. Disconnect the wiring harness connectors from the bulb socket.
11. Replace bulb(s) as necessary.
7
MAINTAINING YOUR VEHICLE 681

CAUTION!
•Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
• Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the bulb
socket, or the lamp wiring.
NOTE: There are access covers over both headlamp bulb
access holes in the quad front lamp unit housing (if
equipped). These covers MUST be reinstalled after the
bulb has been replaced.
Fog Lamps – If Equipped
1. Reach under and behind the front bumper to access the back of the front fog lamp housing. 2. Disconnect the fog lamp wiring harness connector
from the fog lamp bulb.
3. Rotate the bulb counterclockwise ¼ turn to unlock the bulb from the housing.
4. Pull the bulb straight out from the housing.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
Rear Tail/Stop, Turn Signal And Backup Lamps
1. Remove the two screws that pass through the bed sheetmetal.
682 MAINTAINING YOUR VEHICLE

2. Pull the outboard side of the lamp rearward farenough to unsnap the two receptacles on the outboard
side of the lamp housing from the two plastic snap
post retainers in the outer box side panel. 3. Disconnect the wiring harness connectors from the
bulb socket.
4. Rotate the bulb socket counterclockwise 1/4 turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
7
MAINTAINING YOUR VEHICLE 683

Tire Safety Information.....................482
Tongue Weight/Trailer Weight ................544
Tonneau Cover .......................... .667
Tonneau Cover Cleaning ....................667
Torque Converter Clutch ....................375
Tow Hooks, Emergency .....................618
Towing ............................... .534
Disabled Vehicle ....................... .623
Guide .............................. .540
Recreational .......................... .561
Weight .............................. .540
Traction ............................... .441
Traction Control ......................... .471
Trailer Sway Control (TSC) ..................481
Trailer Towing .......................... .534
Cooling System Tips .....................556
Hitches ............................. .539
Minimum Requirements ..................545
Mirrors ............................. .139Trailer and Tongue Weight
.................544
Wiring .............................. .553
Trailer Towing Guide ...................... .540
Trailer Weight ........................... .540
Transfer Case ........................... .658
Electronically Shifted .....................390
Fluid ............................... .692
Transmission ........................... .355
Automatic ........................... .355
Fluid ............................... .692
Maintenance .......................... .658
Shifting ............................. .352
Transmitter Battery Service (Remote Keyless Entry) . .30
Transmitter Programming (Remote Keyless Entry) . . .23
Transmitter, Remote Keyless Entry (RKE) .........23
Tread Wear Indicators ..................... .500
Turn Signals ............................ .171
Uniform Tire Quality Grades .................
71110
INDEX 729