Page 94 of 336
92
C.
Foglamp selection ring.
The foglamp operates with the dipped and main beam headlamps.
Rear foglamp.
)
Turn the ring C
forwards and release to switch on the rear foglamp.
When the lighting is switched off automatically (with AUTO model)
or when the dipped beam headlamps are switched off manually, the
foglamp and the sidelamps will remain on.
)
Turn the ring C
rearwards and release to switch off all the lamps.
In good or rainy weather, both day and night, use of the rear
foglamp is prohibited. In these situations, the power of its beam
may dazzle other drivers. It should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch
on the foglamp and dipped beam headlamps manually as the
sunshine sensor may detect suffi cient light.
Do not forget to switch off the rear foglamp when it is no longer
needed.
Switching off the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately,
except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate ring A
to the "0"
position -
lamps off, then to the desired position.
On opening the driver's door a temporary audible signal warns the
driver that the lighting is on.
The lamps, with the exception of the sidelamps, switch off
automatically after a maximum duration of thirty minutes to
prevent discharging of the battery.
Page 95 of 336
4/
VISIBILITY
DAYTIME RUNNING LAMPS
Daytime lighting, compulsory in certain countries, which comes on
automatically when the engine is started providing better visibility of the
vehicle by other road users
In countries in which it is imposed by regulations:
- by default, this function is activated and cannot be deactivated,
- the dipped beam headlamps come on, associated with the
sidelamps and the number plate lamps.
For other countries where the vehicle is sold, this function is assured
by specifi c lamps. The lighting control stalk should be in position "0"
or
"AUTO"
.
This function can be activated or deactivated via the vehicle
confi guration menu.
Deactivation of the daytime running lamps is effective after
operation of the lighting control stalk or after the next engine
start; activation is immediate.
LED LAMPS
They come on when the engine is started.
Depending on the destination country, they are used for:
- daytime running lamps * in day mode and sidelamps in night mode
(they are brighter when daytime running lamps),
or
- sidelamps in day and night mode.
Where LED lamps are fi tted, the fi lament bulbs for the daytime running
lamps / sidelamps in the front lamp units are not used.
* function that can be set in the vehicle confi guration menu.
Page 96 of 336
94
AUTOMATIC ILLUMINATION OF HEADLAMPS
When a low level of ambient light is detected by a sunshine sensor, the
number plate lamps, sidelamps and dipped beam headlamps are switched
on automatically, without any action on the part of the driver. They can also
come on if rain is detected, at the same time as automatic operation of the
windscreen wipers.
As soon as the brightness returns to a suffi cient level or after the windscreen
wipers are switched off, the lamps are switched off automatically.
Activation
)
Turn the ring to the "AUTO"
position. The activation of the function
is accompanied by the display of a message in the screen.
Deactivation
)
Turn the ring to another position. Deactivation of the function is
accompanied by the display of a message in the screen.
MANUAL GUIDE-ME-HOME LIGHTING
The temporary illumination of the dipped beam headlamps after the
vehicle's ignition has been switched off makes the driver's exit easier
when the light is poor.
Switching on
)
With the ignition off, "fl ash" the headlamps using the lighting stalk.
)
A further "headlamp fl ash" switches the function off.
Switching off
The manual guide-me-home lighting switches off automatically after a
set time.
Page 97 of 336
4/
VISIBILITY
AUTOMATIC "GUIDE-ME-HOME" LIGHTING
Operating fault
In the event of a malfunction of the sunshine sensor, the
lighting comes on, this warning lamp is displayed in the
instrument panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact a PEUGEOT dealer or a qualifi ed workshop.
In fog or snow, the sunshine sensor may detect suffi cient light. In
this case, the lighting will not come on automatically.
Do not cover the sunshine sensor, coupled with the rain sensor
and located in the centre of the windscreen behind the rear view
mirror; the associated functions would no longer be controlled.
When the automatic illumination of headlamps function is activated,
under low ambient light the dipped beams headlamps come on
automatically when the ignition is switched off.
Programming
Activation or deactivation, as well as the duration of the guide-me-home
lighting, is set in the vehicle confi guration menu.
Page 98 of 336
96
MANUAL ADJUSTMENT OF
HALOGEN HEADLAMPSA
UTOMATIC ADJUSTMENT OF
XENON HEADLAMPS
To avoid dazzling other road users, the height of the halogen bulb
headlamps must be adjusted according to the load in the vehicle.
0.
1 or 2 people in the front seats.
-.
3 people.
1.
4 people.
-.
Intermediate setting.
2.
4 people + maximum authorised loads.
-.
Intermediate setting.
3.
Driver + maximum authorised loads. In order to avoid causing a nuisance to other road users, this system
corrects the height of the xenon headlamp beams automatically and
when stationary, in relation to the load in the vehicle.
If a malfunction occurs, this warning lamp is displayed on the
instrument panel, accompanied by an audible signal and a
message in the screen.
The system then places your headlamps in the lowest position.
Initial setting is position "0". Do not touch the xenon headlamp bulbs.
Contact a PEUGEOT dealer or a qualifi ed workshop.
Travelling abroad
If using your vehicle in a country that drives on the other side of
the road, the headlamps must be adjusted to avoid dazzling on-
coming drivers.
Contact a PEUGEOT dealer or a qualifi ed workshop.
Page 99 of 336
4/
VISIBILITY
DIRECTIONAL LIGHTING
When the dipped or main beam headlamps are on, this function enables
the light beams to provide improved lighting of the side of the road when
cornering.
The use of this function, from approximately 12 mph (20 km/h) and
associated with the xenon headlamps only, considerably improves the
quality of your lighting when cornering.
with directional lighting
without directional lighting
PROGRAMMING
OPERATING FAULT
When stationary or moving at very low speed or when reverse
gear is engaged, the function is inactive.
The status of the function remains in the memory when the
ignition is switched off. If a fault occurs, this warning lamp fl ashes in the instrument
panel, accompanied by a message in the screen.
Contact a PEUGEOT dealer or a qualifi ed workshop. The function is activated or deactivated via the vehicle
confi guration menu.
Page 101 of 336
4/
VISIBILITY
WINDSCREEN AND HEADLAMP WASH
)
Pull the windscreen wiper stalk towards you. The windscreen wash
then the windscreen wipers operate for a fi xed period.
The headlamp washers only operate when the dipped beam
headlamps are on
.
Screenwash/headlamp wash low
In the case of vehicles fi tted with headlamp washers, when
the minimum level of the reservoir is reached, this warning
lamp and/or the service warning lamp is displayed in the
instrument panel, accompanied by an audible signal and a
message in the screen.
Next time you stop, fi ll the screenwash / headlamp wash fl uid reservoir.
The warning lamp is displayed when the ignition is switched on, or
every time the stalk is operated, until the reservoir is fi lled.
Page 151 of 336
7/
CHECKS
PETROL ENGINES
The various caps and covers allow access for checking the levels of the various fl uids and for replacing certain components.
1.
Power steering reservoir.
2.
Screenwash and headlamp wash reservoir.
3.
Coolant reservoir.
4.
Brake fl uid reservoir.
5.
Battery / Fuses.
6.
Fusebox.
7.
Air fi lter.
8.
Engine oil dipstick.
9.
Engine oil fi ller cap.
