11 2
Levels
   
Cooling system 
 
Only use the fluid recommended by the 
manufacturer. 
  Otherwise, you risk seriously damaging your 
engine. 
  When the engine is warm, the temperature 
of the coolant is controlled by the engine 
fan. As this fan can operate with the ignition 
key removed and because the cooling 
system is pressurised, wait for at least one 
hour after the engine has stopped before 
carrying out any work. 
  Slacken the cap by 1/4 of a turn to release 
the pressure to prevent any risk of scalding. 
When the pressure has dropped, remove the 
cap and top up the level with coolant. 
  If fluid has to be added frequently, this 
indicates a fault which must be checked by a 
PEUGEOT dealer or a qualified workshop as 
soon as possible. 
   
Power steering fluid level 
 
The vehicle must be parked on level ground 
with the engine cold. Unscrew the cap 
integrated with the gauge and check the 
level which must be between the MIN and 
MAX marks.    When this occurs with the engine running it 
is due to the start of saturation of the particle 
emission filter (exceptionally prolonged 
urban type driving conditions: low speed, 
long traffic jams, ...). 
  In order to regenerate the filter, you are 
advised to drive at a speed higher than 
40 mph (60 km/h) for at least five minutes 
as soon as possible, when traffic conditions 
permit (until the message disappears and 
the service warning lamp goes off). 
  During regeneration of the particle emission 
filter, relay noise may be heard under the 
dashboard. 
  If the message is still displayed and if the 
service warning lamp remains on, contact a 
PEUGEOT dealer or a qualified workshop. 
   
Topping up 
  The level must be between the MIN and 
MAX marks on the expansion bottle. If 
more than 1 litre of fluid is required to top 
up the level, have the system checked by a 
PEUGEOT dealer or a qualified workshop.  
 
 
 
Screenwash and headlamp wash 
level 
  For best quality cleaning and for your safety, 
we would advise that you use products of 
the PEUGEOT range. 
  Capacity of the screenwash reservoir: 
approximately 4.5 litres. 
  If your vehicle is fitted with headlamp 
washers, the capacity of the reservoir is 
7.5 litres. 
  To ensure optimum cleaning and prevent 
freezing, this fluid must not be topped up or 
replaced with plain water.  
 
 
Diesel additive level (Diesel 
with particle emission filter) 
  The minimum level of this additive 
is indicated by lighting of the 
service warning light, accompanied by an 
audible signal and a message in the screen.    
Topping up 
  This additive must be topped up by a 
PEUGEOT dealer or a qualified workshop 
without delay.  
  
         
        
        134
Changing a fuse
 
CHANGING A FUSE 
 
The three fuseboxes are placed: 
    -  
in the dashboard on the right-hand side (behind 
the storage compartments, retractable), 
   -   in the passenger compartment (battery 
compartment), 
  
-   under the bonnet.   
 If  fi tted on your vehicle, a further fusebox 
is added for towing, the towbar and the 
connections for the coachbuilder and platform 
cab conversions. It is located on the right 
behind the load retaining partition. 
   Removing and fitting a fuse 
 
Before changing a fuse, the cause of the 
fault must be found and rectified.     Always replace a failed fuse with a fuse 
of the same rating.
  
  PEUGEOT will not accept responsibility 
for the cost incurred in repairing your 
vehicle or for rectifying the malfunctions 
resulting from the installation of accessories 
not supplied and not recommended by 
PEUGEOT and not installed in accordance 
with its instructions, in particular when 
the combined consumption of all of the 
additional equipment connected exceeds 
10 milliamperes.   
  The descriptions communicated are only the 
fuses which can be changed by the user. 
For any other operations, go to a PEUGEOT 
dealer or a qualified workshop. 
  For motor trade use: for complete 
fuse and relay information, consult the 
"Repair procedure" wiring diagrams via the 
dealer network.  
         
        
        138
Changing a fuse
 
TOWING / TOWBAR / 
COACHBUILDERS / PLATFORM 
CAB FU
SES 
  The descriptions communicated are an 
indication only as this additional box relates 
to other information which depends on the 
coachbuilder/vehicle converter for which this 
document cannot act as a technical support.     Fuses
     
   F       
Amperes
     
   A      
Allocation
  
   
1        
15     Free 
   
2        
15     Ignition relay and optional generator 
   
3        
15     Trailer 12V supply 
   
4        
15     Permanent supply for vehicle converters 
   
5        
10     Hazard warning lamps