
28
   
 
Instruments and controls  
 
 
INSTRUMENT PANEL
 
 
 
1. 
  Distance recorder in miles / kilometres. 
   
2. 
 Screen. 
   
3. 
  Fuel level, coolant temperature. 
   
4. 
 Rev counter. 
   
5. 
  Instrument panel lighting dimmer. 
   
6. 
  Trip distance recorder / service indicator 
zero reset.  
 
 
Instrument panel screen 
 
 
 
-   Speed limiter / cruise control. 
   
-   Miles / kilometres travelled. 
   
-   Service indicator, engine oil level 
indicator, total miles / kilometres. 
   
-   Presence of water in the Diesel filter. 
   
-  Diesel pre-heating. 
   
-   Gear shift indicator.  
 
 
 
Warning lamp and controls in the 
overhead storage unit 
   
 
-   Passenger airbag deactivated warning 
lamp. 
   
-   Driver / passenger heated seat controls 
(version with 2 front seats). 
   
-   Rear ventilation activation / deactivation 
control.  
 
 
INSTRUMENTS AND CONTROLS 

   
 
Instruments and controls  
 
 
WARNING LAMPS 
 
Each time the engine is started: a series of warning lamps comes on applying a check auto-test. They go off again almost immediately. 
When the engine is running: the warning lamp becomes a warning if it remains on continuously or flashes. This initial warning may be 
accompanied by an audible signal and a message in the screen. 
  Do not ignore these warnings 
   
Warning lamp    
is    
indicates    
Solution - action  
   
STOP    on, associated 
with another 
warning 
lamp and 
accompanied by 
a message in the 
screen.   major faults linked with the 
"Brake fluid level", "Engine oil 
pressure and temperature", 
"Coolant temperature", 
"Electronic brake force 
distribution", "Power steering" 
and "Under-inflation detection" 
warning lamps.    
You must stop as soon as it is safe to do so, park, 
switch off the ignition and call a PEUGEOT dealer or 
a qualified workshop.  
   
Parking brake / 
Brake fluid 
level / EBFD    on.   parking brake applied or not 
released correctly.   Releasing the parking brake switches off the warning lamp. 
  on.  low brake fluid level.   Top up using a fluid recommended by PEUGEOT. 
  remains on, even 
though the level 
is correct and 
associated with the 
ABS warning lamp.   failure of the electronic brake 
force distribution.    
You must stop as soon as it is safe to do so, park, 
switch off the ignition and call a 
 PEUGEOT  dealer or 
a qualified workshop.  
   
Engine oil 
pressure and 
temperature    on while driving.   insufficient pressure or 
temperature too high.   Park, switch off the ignition and allow to cool. Visually 
check the level. Chapter 6, "Levels" section. 
  remains on, even 
though the level 
is correct.   major fault.   Call a PEUGEOT dealer or a qualified workshop.  

 31
   
 
Instruments and controls  
 
REA
DY 
TO SET OFF
2
 
 
Warning lamp    
is    
indicates    
Solution-action  
   
Coolant 
temperature 
and level    on with needle in 
the red zone.   abnormal increase in 
temperature.   Park and switch off the ignition then allow to cool. 
Visually check the level. 
  flashing.  drop in coolant level.   Chapter 6, "Levels" section. Contact a PEUGEOT dealer 
or a qualified workshop. 
   
Service    on temporarily.   minor faults or warnings.   Consult the warnings log in the display or on the screen.  
See chapter 9, "Trip computer" section then 
"Warnings log".  
Depending on the seriousness of the fault, contact a 
PEUGEOT dealer or a qualified workshop.    remains on.   major faults. 
   
Row 1 seat belt 
not fastened    lit then flashing.   the driver or a front passenger 
has not fastened his seat belt.   Pull the strap then insert the tongue in the buckle. 
  accompanied by 
an audible signal 
then remains on.   the vehicle is moving with the 
driver or front passenger seat 
belt not fastened.   Check that the seat belt is fastened by pulling the strap. 
Chapter 4, "Seat belts" section. 
  The driver must ensure that all passengers have 
fastened their seat belt and use it correctly.  

36
   
 
Instruments and controls  
 
 
FUEL GAUGE 
 
The fuel level is tested each time the key is 
turned to the "running" position. 
  The gauge is positioned on: 
COOLANT TEMPERATURE 
 
 
The needle is positioned before the red 
zone: 
 normal operation. 
  In arduous conditions of use or hot climatic 
conditions, the needle may move close to 
the red graduations.    
What you should do if the warning lamp 
comes on:  
   
 
-   stop immediately, switch off the ignition. The 
fan may continue to operate for a certain 
time, up to approximately 10 minutes, 
   
 
-   1: 
 the fuel tank is full, approximately 
80 litres. 
   
-   0: 
 the reserve is now being used, the 
warning lamp comes on continuously.
The reserve when the warning first comes 
on is approximately 8 litres.  
  Refer to the "Fuel" section of chapter 6.    
What you should do if the needle enters 
the red zone:  
  Reduce your speed or let the engine run at 
idle.    
-   wait for the engine to cool down in order 
to check the coolant level and top it up if 
necessary.  
  As the cooling system is pressurised, follow 
this advice in order to avoid any risk of 
scalding: 
   
 
-   wait at least one hour after switching off 
the engine before carrying out any work, 
   
-   unscrew the cap by 1/4 turn to allow the 
pressure to drop, 
   
-   when the pressure has dropped, check 
the level on the expansion bottle, 
   
-   if necessary, remove the cap to top up.  
  If the needle remains in the red zone, have 
the system checked by a PEUGEOT dealer 
or a qualified workshop. 
  Refer to the "Levels" section of chapter 6.  

 11 7
   
 
Towing a trailer 
 
 
ACCE
SS
ORIE
S
5
 
For more information about weights, 
refer to the administrative documents 
(registration document, ...) or to the 
"Weights" section of chapter 8. 
  TOWING A TRAILER, CARAVAN, BOAT, ETC... 
 
 
Distribution of loads  
  Distribute the load in the trailer so that the 
heaviest objects are as close as possible 
to the axle and the nose weight is close to 
the maximum authorised without, however, 
exceeding it.    
Cooling  
  Towing a trailer on a slope increases the 
coolant temperature. 
  As the fan is electrically controlled, its 
cooling capacity is not dependent on the 
engine speed. 
   
Driving advice 
 
A towed vehicle must free wheel: gearbox in 
neutral.  

11 8
   
 
Towing a trailer 
  You should therefore use a high gear to 
lower the engine speed and reduce your 
speed. 
  In all cases, pay attention to the coolant 
temperature.     
Ty r e s  
  Check the tyre pressures of the towing 
vehicle (see the "Identification markings" 
section of chapter 8) and of the trailer, 
observing the recommended pressures. 
   Towbar 
 
We recommend the use of genuine 
PEUGEOT towbars and their harnesses, 
which have been tested and approved from 
the design stage of your vehicle, and that 
you entrust the fitting of this equipment to a 
PEUGEOT dealer. 
  If this equipment is not fitted by a PEUGEOT 
dealer, it is imperative that it is fitted using 
the electrical pre-equipment installed at the 
rear of the vehicle and in accordance with 
the manufacturer's instructions. 
  In accordance with the general instructions 
a reminder of which has been given above, 
we draw your attention to the risk associated 
with fitting a towbar or electrical accessory 
not recommended by PEUGEOT. Fitting 
such equipment could result in the failure 
of your vehicle's electronic system. Please 
obtain information from the Manufacturer 
before fitting this type of equipment.     If the coolant temperature warning 
lamp comes on, stop the vehicle 
and switch off the engine as soon 
as possible. 
   
Good Practice 
 
In certain cases of particularly arduous 
use (towing the maximum load up a steep 
slope in high temperatures), the engine 
automatically limits its power. In this 
case,  the air conditioning is automatically 
cut off to save engine power. 
See the "Levels" section of chapter 6.    
Brakes  
  Towing increases the braking distance. Drive 
at a moderate speed, change down early 
and brake gradually. 
   
Side wind  
  Sensitivity to side wind is increased. Drive 
smoothly and at a moderate speed. 
   
ABS/DSC  
  The ABS or DSC systems only control the 
vehicle, not the trailer or caravan. 
   
Rear parking sensors  
  The parking sensors system does not 
function while the vehicle is towing.   

124
   
 
Levels 
 
 
Cooling system 
 
Only use the fluid recommended by the 
manufacturer. 
  Otherwise, you risk seriously damaging your 
engine. 
  When the engine is warm, the temperature 
of the coolant is controlled by the engine 
fan. As this fan can operate with the ignition 
key removed and because the cooling 
system is pressurised, wait for at least one 
hour after the engine has stopped before 
carrying out any work. 
  Slacken the cap by 1/4 of a turn to release 
the pressure to prevent any risk of scalding. 
When the pressure has dropped, remove the 
cap and top up the level with coolant. 
  If fluid has to be added frequently, this 
indicates a fault which must be checked by a 
PEUGEOT dealer or a qualified workshop as 
soon as possible.   The vehicle must be parked on level ground 
with the engine cold. Unscrew the cap 
integrated with the gauge and check the 
level which must be between the MIN and 
MAX marks.  
 
 
Diesel additive level (Diesel
with particle emission filter)
  The minimum level of this additive 
is indicated by lighting of the 
service warning light, accompanied by an 
audible signal and a message in the screen. 
  When this occurs with the engine running it 
is due to the start of saturation of the particle 
emission filter (exceptionally prolonged 
urban type driving conditions: low speed, 
long traffic jams, ...). 
  In order to regenerate the filter, you are 
advised to drive at a speed higher than 
40 mph (60 km/h) for at least five minutes 
as soon as possible, when traffic conditions 
permit (until the message disappears and 
the service warning lamp goes off). 
  During regeneration of the particle emission 
filter, relay noise may be heard under the 
dashboard. 
  If the message is still displayed and if the 
service warning lamp remains on, contact a 
PEUGEOT dealer or a qualified workshop. 
   
Topping up 
  The level must be between the MIN and 
MAX marks on the expansion bottle. If 
more than 1 litre of fluid is required to top 
up the level, have the system checked by a 
PEUGEOT dealer or a qualified workshop.  
 
Screenwash and headlamp wash level 
 
For best quality cleaning and for your safety, 
we would advise that you use products of 
the PEUGEOT range. 
  Capacity of the screenwash reservoir: 
approximately 4.5 litres. 
  If your vehicle is fitted with headlamp 
washers, the capacity of the reservoir 
is 7.5 litres. 
  To ensure optimum cleaning and prevent 
freezing, this fluid must not be topped up or 
replaced with plain water.  
   
Topping up 
  This additive must be topped up by a 
PEUGEOT dealer or a qualified workshop 
without delay.