2013 Peugeot 807 wheel bolts

11 8


Changing a wheel


- Unwind the winch cable by
unscrewing the bolt using the
wheelbrace.

- Detach the spare wheel from the
rear of the vehicle and place it near
the wheel to be changed.



4. OPERATING PROCEDURE



- Remove the trim pulling at the
valve passage hole. Use the fl at
end of the towing eye as a lever.

- Loosen the wheel bolts and start
unscrewing them.

11 9
QUICK HELP
7


Changing a wheel

Do not extend the jack until you
have started unscrewing the bolts
on the wheel to be changed and
have placed the chock under the wheel
diagonally opposite.





- Place the jack in contact with the
locating point provided, the one
which is closest to the wheel to
be changed. Ensure that the base
of the jack is in contact with the
ground, and straight above.

- Extend the jack to lift the wheel
clear of the ground.
- Resume and complete the
unscrewing of the wheel bolts.

- Remove the bolts and remove the
wheel.


5. FITTING THE SPARE WHEEL



- Position the wheel on the hub and
start tightening the bolts by hand.

- Initially tighten the bolts using the
wheelbrace.

120


Changing a wheel


- Lower the vehicle completely by
folding the jack, then remove the
jack.

- Tighten the bolts again using the
wheelbrace, tighten them fully
without forcing them.
- Place the wheel to be repaired in the
boot well, with the valve uppermost
and the locating tab in place.

- Raise the winch cable using the
wheelbrace and tighten fully.
Check that the wheel is horizontal
and fl ush against the rear fl oor to
ensure that it is retained correctly
while driving.

- Remember to close the fl ap,
located in the boot, it permits
securing of the winch.

- Store the trim in the boot. Never go underneath a vehicle
that is supported only by a
jack (use a ramp). Never use a
screwdriver in place of the wheelbrace
to unwind or wind the winch cable.


6. REFITTING THE REPAIRED
WHEEL
The wheel is refi tted as described in
step 5, not forgetting to refi t the wheel
trim.
The spare wheel is not designed
to be used over long distances.
Have the tightening of the bolts
and the tyre pressure checked by a
PEUGEOT dealer as soon as possible.
Also, have the original wheel repaired
and refi tted by a PEUGEOT dealer as
soon as possible.