2013 Peugeot 208 stop start

95
4
Driving
The system is reactivated automatically at every new star t using the key.


Reactivation

Press the "ECO OFF"switch again.
The s
ystem is active again; this is confirmed
by the switch warning lamp going off,
accompanied by a message in the screen.
Operating fault
In the event of a fault with the system,
the "ECO OFF"switch warning lamp flashes
then comes on continuously.
Have it checked by a PEUGEOT dealer or aqualified workshop.
In the event of a fault in STOP mode, the
vehicle ma
y stall. All of the warning lamps come on. It is then necessary to switch off
the ignition and star t the engine again using
the key.

Before doing anything under the bonnet,deactivate the Stop & Start system toavoid any risk of injury resulting fromautomatic operation of STA R T m o d e .

This s
ystem requires a battery with a specialspecification and technology (reference
numbers available from a PEUGEOT dealer or
a qualified workshop).
Fitting a battery not listed byPEUGEOT introduces the risk of malfunction of
the system.



Maintenance

The Stop & Start system makes use of advanced technology. All work onthis type of battery must be done by a PEUGEOT dealer or a qualifiedworkshop.

102
Driving





Park Assist
This system provides active assistance with parking, detecting a parking space then controlling the steering to park in the space.
It controls the steering while the driver manages the accelerator, brakes, gears and clutch (manual gearbox). During phases of entry into and exit froma parking space, the system provides visual and audible information to the driver in order to make the manoeuvre safe. It may be necessary to move
forwards and backwards more than once.

For entry into a parking space (parallel
parking) the system does not detect spaces which are clearly much smaller or larger than the size of the vehicle.
This "parking assistance" systemis activated automatically duringmanoeuvres; it is therefore possiblethat a symbol comes on in the screen, accompanied by an audible signal,without affecting the manoeuvre.
When Park Assist is activated, it prevents a change to STOP mode of Stop & Star t. In STOP mode, activationof Park Assist restarts the engine.



The Park Assist system cannot in anycircumstances replace the care and responsibility of the driver.
The driver must remain in control of their vehicle ensuring that the space remains clear during the manoeuvre. In some circumstances, the sensors may not detect small obstacles located in their blind spots.
During a manoeuvre the steering wheel
turns quickly: do not hold the steering wheel, do not place your hand between the spokes of the steering wheel andtake care with loose and bulky clothing,scarves, handbags... There is a risk of injury.

The s
ystem provides assistance in entering and exiting a parking space when parallel parking.
The driver can take control at any time by gripping the steering wheel.

174
Practical information




Battery
The presence of this label indicatesthe use of a 12 V lead-acid battery withspecial technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is requiredwhen replacing or disconnecting thebattery.
Failure to observe this recommendation may cause premature wear of thebattery.

After refitting the battery, the Stop & Start system will only be active
after several hours depending on the climatic conditions and the state of charge of the battery (up to about 8 hours).
)Raise the locking tab fully.




Disconnecting the cables

Reconnecting the cables
)Position the open clip 1of the cable on the positive terminal (+) of the battery.
)Press ver tically on the clip 1
to position it correctly against the battery.)Lock the clip by spreading the positioning
lug and then lowering the tab 2.
Do not force the tab as locking will not be possible if the clip is not positionedcorrectly; start the procedure again.
Procedure for char
ging your battery when it is flat or for star ting the engine using another battery.

The battery is located under the bonnet.
To gain access to it:) open the bonnet using the interior releaselever, then the exterior safety catch, )
secure the bonnet stay, )
remove the plastic cover on the (+)
t
erminal.

Access to the battery

175
7
Practical information

The Stop & Start battery does not have to be disconnected for charging.
Starting using another
battery
)Connect the red cable to the positive
terminal (+) of the flat battery A , then to the positive terminal (+) of the slave battery B .)Connect one end of the green or blackcable to the negative terminal (-) of the slave battery B.
)
Connect the other end of the green or blackcable to the ear th point C
on your vehicle (engine mounting).)
Operate the star ter, let the engine run.)
Wait until the engine returns to idle and disconnect the cables.

Charging the battery using
a battery charger
)
Disconnect the battery from the vehicle.)
Follow the instructions for use provided by
the manufacturer of the charger. ) Connect the battery starting with the negative terminal (-).)
Check that the terminals and connectors
are clean. If they are covered with sulphate (whitish or greenish deposit), remove themand clean them.

177
7
Practical information
System which manages the duration of use of certain functions to retain a sufficient level of charge in the battery.

After the engine has stopped, you can still use functions such as the audio andtelematics system, windscreen wipers, dipped
beam headlamps, cour tesy lamps, etc. for a maximum combined duration of about
thirty minutes.








Electrical energy economy mode
Switching to economy
mode
Once this time has elapsed, a message appears in the screen indicating that the vehiclehas switched to economy mode and the activefunctions are put on standby.
I
f a telephone call is being made at this time, it will be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.


Exiting economy mode

These functions are reactivated automatically
next time the vehicle is driven.
) To restore these functions immediately,start the engine and let it run for at least five minutes.

A flat battery prevents the engine from starting (refer to the correspondingsection).

188
Checks











Bonnet
)Open the left hand front door.


Before doing anything under the bonnet,switch off the Stop & Start system toavoid any risk of injury resulting from anautomatic change to START mode.


Closing
)Take the stay out of its suppor t slot. )Clip the stay back into its housing. )Lower the bonnet and release it at the end of its travel. )Pull on the bonnet to check that it has
latched correctly.
)Unclip the stay from its housing and place it in the suppor t slot to hold the bonnet open.

Do not open the bonnet under verywindy conditions.When the engine is hot, handle the exterior safety catch and the stay with care (risk of burns).To avoid damaging electrical units,it is strictly forbidden
to use a highpressure jet wash under the bonnet.


Opening
)
Lift the safety catch and raise the bonnet.


)Pull the release lever, located at the bottom
of the door aper ture, towards you.

206
Technical data
* The maximum power corresponds to the type approved value on a test bed, under conditions defined by European legislation (directive 1999/99/EC).















Diesel engines and gearboxes
Engines 1.4 litre HDi68 hp1.4 litre e- HDi 68 hp1.6 litre e- HDi 92 hp
GearboxesManual (5-speed)Electronic(5-speed)


Manual (5-speed)

Model codes: CC... CA...
8HR0
8HP0/PS
9HP0/S
Cubic capacity (cc) 1 398

1 560

Bore x stroke
(mm)

73.7 x 8275 x 88.3

Max power: EU standard (kW)
* 50
68

Max power engine speed
(rpm)
4 000 4 000
Max torque: EU standard
(Nm) 160

230

Max torque en
gine speed (rpm)
1 750
2 000

Fuel Diesel
Diesel

Catalytic conver ter yes yes

P
article emission filter yes
yes

OIL CAPACITIES
(in litres)
Engine (with filter replacement) 3.75 3.75

...
/S: e-HDi model fitted with Stop & Start.

9
207
Technical data
Engines1.6 litree-HDi 92 hp1.6 litre e- HDi 115 h p
Gearboxes

Electronic
(6-speed)

Manual(6-speed)
Model codes: CC... CA...
9HPP - 9HP8/PS
9HD8/S - 9HR8/S
Cubic capacity (cc)
1 560
1 560

Bore x stroke (mm) 75 x 88.3

75 x 88.3

Max power: EU standard
(kW)
* 6884
Max power engine speed
(rpm) 4 000 3 600
Max torque: EU standard
(Nm)

230
270

Max torque engine speed (rpm) 1 750

1 750

F
uel
Diesel Diesel

Catalytic converter yes
yes

Particle emission filter yes
yes
OIL CAPACITIES (in litres)

Engine (with filter replacement) 3.75
3.75
*
The maximum power corresponds to the type approved value on a test bed, under conditions defined by European legislation (directive 1999/99/EC).

Diesel engines and gearboxes

.../S: e-HDi model fitted with Stop & Start.