2013 PEUGEOT 2008 light

47
2
Access
Electronic engine immobiliser
The key contains an electronic chip which has a special code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible.
This electronic engine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
Guide-me-home lighting

With the remote control
Make a long press this button to
operate the guide-me-home lighting(switching on the sidelamps, dipped
beams and number plate lamps).

A second press before the end of the timedperiod cancels the guide-me-home lighting.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal anda message in the screen.
In this case, your vehicle will not start; contact
a PEUGEOT dealer as soon as possible.
Keep safely the label attached to thekeys given to you on acquisition of the
vehicle.

49
2
Access
Secondary control
For mechanically locking and unlocking the doors in the event of a fault with the central
locking system or a battery failure.


Driver's door

Inser t the key in the lock to lock or unlock the door.


Passenger doors
)On the rear doors, check that the child lock
is not on.)Remove the black cap located on the edge
of the door, using the key. )Inser t the key into the aper ture without forcing, then without turning, move the
latch sideways towards the inside of thedoor.
)Remove the key and refit the cap.




Changing the battery

Battery ref.: CR1620 / 3 volts.
Do not throw the remote control batteries away, they contain metalswhich are harmful to the environment.
Take them to an approved collectionpoint.
Remote control problem
Reinitialisation
)
Switch off the ignition.)
Turn the key to position 2 (Ignition).)
Press the closed padlock immediately for a
few seconds.) Switch off the ignition and remove the key
from the ignition switch.
The remote control is fully operational again. Followin
g disconnection of the vehicle battery,replacement of the remote control battery or in the event of a remote control malfunction, you can no longer unlock, lock or locate your
vehicle.) First of all, use the key in the lock to unlock
or lock your vehicle.) Then, reinitialise the remote control.
I
f the problem persists, contact a PEUGEOT
dealer as soon as possible.
If the batter
y is flat, you are informed
by lighting of this warning lamp in the
instrument panel, an audible signal
and a message in the screen.) Unclip the cover using a screwdriver in thecutout.)
Remove the cover.)
Extract the flat battery from its location.
)
Place the new battery into its location
observing the original direction. ) Clip the cover in place.

56
!
Access











Panoramic sunroof System which comprises configurable light guides and a panoramic tinted glass area to increase
the light and visibility in the passenger compar tment. It is fitted with a manual blind in two par ts tomaintain a comfortable temperature.
It is fitted with an electric blind to improve temperature and acoustic comfor t.
Opening
)Lift the control Atowards the rear.
The blind stops when you release the control.
Electric blind

Closin
g
)
Lift the control Atowards the front.
The blind stops when you release thecontrol.


If something is trapped when operatingthe blind, you should reverse the movement of the blind. To do this press the control in question. When the driver operates the blind, they should ensure that nobody prevents its correct closing.
The driver should ensure that passengers use the blind correctly.
Be aware of children when operating the blind.

62
!
Comfort
If the mirrors are folded using control A,they will not unfold when the vehicle isunlocked. Pull again on control A.


The folding and unfolding of the door mirrors using the remote control can bedeactivated by a PEUGEOT dealer or a qualified workshop.
Fold the mirrors when putting your vehicle through an automatic car wash.
Folding
- Automatic: lock the vehicle using the
remote control or the key.
- Manual: with the ignition on, pull control Arearwards.
Unfolding
- Automatic: unlock the vehicle using the remote control or the key.
- Manual: with the ignition on, pull control Arearwards.

Automatic day/night model

By means of a sensor, which measures the
light from the rear of the vehicle, this system
automatically and progressively changes
between the day and night uses. Adjustable mirror providing a central rear ward
vi
ew.
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlamps from other vehicles...





Rear view mirror



Manual day/night model

Ad
justment
)
Adjust the mirror so that the glass is
directed correctl
y in the "day" position.



Day / night position
)
Pull the lever to change to the "night" anti-
dazzle position.
) Push the lever to change to the normal "day" position.



In order to ensure optimum visibilityduring your manoeuvres, the mirror lightens automatically when reversegear is engaged.

As a safety measure, the mirrors should be adjusted to reduce the "blind spot".

65
3
Comfort
1. Temperature adjustment
) Turn the dial from blue(cold) to red (hot) to adjust
the temperature to your
requirements.The air conditioning system only operates with the engine running.


2. Air fl ow adjustment
)Turn the dial from position 1
to position 6to obtain a comfortable air flow.



If you put the air flow control in position 0(system off), the temperature is no longer controlled. However,a slight flow of air can still be felt, resulting from the movement of the vehicle.

Manual air conditioning
Heating / Ventilation

69
3
Comfort

7. Air fl ow adjustment
)
Press this "full fan"
button toincrease the air flow.
)
Press this "empty fan"
button to
reduce the air flow.
8. Air intake/Air recirculation
) Press the "empty fan"
air flow
button until the fan symboldisappears and "---" appears.

Switching the system off
)Press this button to recirculatethe interior air. The indicator lamp in the button comes on and
the air recirculation symbol is
displayed.

Air recirculation prevents exterior odoursand smoke from entering the passenger compartment. It is activated automatically when
operating the screen wash.

Avoid driving for too long with the system switched off (risk of misting andof deterioration of the air quality).
Pressing the "full fan"button reactivates the system with the settings prior to deactivation.
The air
flow symbol (a fan) appears in thescreen. It is filled in progressively in relation to
the value required. Thi
s action switches off all of the functions of
the air conditioning system. The temperature is no longer maintained at a comfor table level. However, a slight flow of air, due
to the movement of the vehicle, can still be felt.) As soon as possible, press this button
again to permit the intake of exterior air and
prevent misting. The indicator lamp in the
button goes off.
) Press this button several times in succession to direct the air flowin turn towards:


6. Air distribution adjustment



- the windscreen, the side windows and the
footwells,

- the windscreen and side windows (demisting or defrosting),

- the central and side vents,

- the central vents, the side vents and the
footwells,

- the footwells.



Avoid prolonged operation in interior air recirculation mode (risk of misting andof deterioration of the air quality).

77
3
Comfort











Warning triangle (stowing)

Before leaving your vehicle to set up
and install the triangle, put on your high visibility vest.

The dimensions o
f the triangle (once folded) or
its storage box must be:


- A
: length = 438 mm,

- B: height = 56mm, -C: width = 38 mm.
To use the triangle, refer to the manufacturer'sinstructions.
Placing the triangle in the road


The location for stowing a folded triangle or its box is under the front seat or under the boot carpet (depending on version).
Distance from your vehicle (in metres)
Road
Motorway
DayNight
50 m 80 m15 0 m

These are the internationally recognisedvalues.
Use the triangle in line with local driving regulations.

The triangle is available as an accessory, contact a PEUGEOT dealer or a qualified
workshop.
) Place the triangle at a distance behindthe vehicle, as shown in the table below,
according to the type of road and the level
of ambient light.

82
Driving
Gear lever positions
N
. Neutral R
. Reverse 1, 2, 3, 4, 5.
Gears in sequential mode AUTO.
This comes on when the automatedmode is selected. It switches off on changing to sequential mode.
)Select position N.)Press the brake pedal fully.)Star t the engine.
Nappears in the instrument panel.


Moving off
N
flashes in the instrument panelscreen if the gear lever is not inposition N
on starting.
)
Place your foot on the brakewhen this warning lamp flashes(e.g.: star ting the engine).

There is an audible signal on engagement of reverse.

When moving off on a slope, accelerate gradually while releasing the parking brake.
)
Select first gear (position Mor A
) or Areverse (position R)R)
Release the parking brake.)
Progressively take your foot off the brakepedal, then move off.
AUTO
and 1
or R
appear in the
instrument panel.

Stopping - Moving off on a slope

When stopping on a slope, do not use the
accelerator to immobilise the vehicle; apply the
parkin
g brake.


Sequential mode
AUTOdisappears and the gearsengaged appear in succession in the
instrument panel.
)After star ting the vehicle, select position Mto change to sequential mode.
The
gear change commands are only carried
out if the engine speed permits.
When driving at low speed, on approachinga stop sign or traffic lights for example,
the gearbox changes down to first gear
automatically.
You must press the brake pedal while star ting
the en
gine.
Automated mode
)Following use of the sequential mode, select position A
to return to the automated mode.
AUT
Oand the gear engaged appear in the instrument panel.

The gearbox then operates in auto-adaptive mode, without any action on the par t of the
driver. It continuously selects the most suitable
gear for:


- optimisation of fuel consumption,

- the drivin
g style,

- the road conditions,

- th
e vehicle load.