2013 NISSAN VERSA SEDAN light

[x] Cancel search: light

Page 265 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual and are installed securely. Check the belt web-
bing for cuts, fraying, wear or damage.
Steering wheelCheck for changes in the steer-
ing system, such as excessive freeplay, hard
steering or strange n

Page 272 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual CHANGING ENGINE OIL FILTER
1. Park the vehicle on a level surface and applythe parking brake.
2. Turn the engine off.
3. Place a large drain pan under the oil filter
C.
4. Loosen the oil filter with

Page 273 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual CAUTION
●Use only Genuine NISSAN CVT Fluid
NS-3. Do not mix with other fluids.
● Using transmission fluid other than
Genuine NISSAN CVT Fluid NS-3 will
damage the CVT, which is not covered
by the

Page 281 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual If the brakes do not operate properly, have the
brakes checked by a NISSAN dealer.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes.
The front disc-type brakes self-adjust eve

Page 283 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual PASSENGER COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equ

Page 284 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual Extended storage switch
If any electrical equipment does not operate,
remove the extended storage switch and check
for an open fuse.
NOTE:
The extended storage switch is used for
long term vehicle sto

Page 287 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual or modifications not expressly approved by
the party responsible for compliance could
void the user’s authority to operate the
equipment.
For Canada:
This device complies with RSS-210 of In-
dustry

Page 288 of 331

NISSAN VERSA SEDAN 2013 2.G Owners Manual 1. Disconnect the battery negative cable.
2. Disconnect the electrical connector
Afrom
the rear end of the bulb.
3. Pull off the rubber cap
B. 4. Push and turn the retaining pin
Cto loosen
it.
5. R