2013 NISSAN ROGUE wheel

*See your Owner’s Manual for information.VEHI
cLE I
NFORMATION DISPLAY*
HEADLIGHT AND TURN SIGNAL c
O
NTROL
LOW TIRE PRESSURE WARNING LIGHT
INSTRUMENT BRIGHTNESS c
O
NTROL
SWIT
cH*
TR
IP c
HAN
GE BUTTON* WINDSHIELD WIPER / WASHER SWIT
cH
OU
TSIDE MIRROR c ONTROL SWIT
c
H
STEERING WHEEL SWIT
cH
ES FOR
AUDIO c
O
NTROL* / BLUETOOTH
®
cRUISE
cONTROL
H
EADLIGHT AIMING c
O
NTROL* AWD LO
c

k SWIT
cH*
VE
HI
cLE D
YNAMI
c
c
O
NTROL (VD
c
)
OFF SWIT
c
H*
STEERING WHEEL TILT ADJUSTMENT*
HOOD RELEASE* AUDIO AND NAVIGATION SYSTEM
AUTOMATI
c

c
LI
MATE c
O
NTROLS*
POWER OUTLET*
FRONT PASSENGER AIR BAG
STATUS LIGHT*
01
0610
14
02
07
11
15
03
08
12
16
04
09
13
1718
05
01
10
03
0711
15
04
12
16
05
06
18
17
02
08
09
14
13
1276461_13c_Rogue_QRG_122112.indd 412/21/12 10:30 AM

TowiNG Your veHiC le
ALL-W HEEL DR IVE (AWD) V EHIcLE


•

An all-wheel drive vehicle must be towed with all wheels off the ground.
For proper towing and to avoid accidental damage to your vehicle, NISSAN recommends



that a service operator tow your vehicle after carefully reading the Own\
er
’s Manual precautions.
For more information, refer to the “in case of emergency (section 6)” of your Owner’s Manual.
ouTSiDe T eM P eraT ure DiS P laY
When the ignition switch is in the o N position, the



outside air temperature will appear in the vehicle




information display 01 .
If the outside air temperature is below 25°F (-4°
c ),



the outside temperature display will blink for 20




seconds then remain on when the ignition is




switc
hed on.
If the outside air temperature is between 2 7°F and



3
7°F (-3° c and +3° c ), the outside temperature



display will blink continuously with the ignition switc
h



in the
o N position.
To stop the outside temperature display from blinking,



stop the vehicle in a s
afe place and move the shift



lever to the
(P) P
arK
position. Perform the following procedure:



1.

Press the control c
hange button
02 until the Settings mode is displayed.




2.


T

urn the control button until it reaches the a
larms
mode, then press to select.



3.


T

urn the control button until it reaches the o utside temp mode, then press to select.



4.


T

urn the control button until it reaches the o ff mode, then press to select.



5.


T

o exit, press the control button again.
LOW OUTSIDE TEMPERATURE WARNING
The l ow outside temperature warning message will appear in the vehicle information
display
03 when the outside temperature drops below 37°F (+3° c ) with the ignition switch
in the
o
N position.
For more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
01
03
02
essential information
6To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1276461_13c_Rogue_QRG_122112.indd 612/21/12 10:30 AM

TriP Co MP u T er
With the ignition switch in the o N position, trip
computer
01 modes can be selected by pressing the



control c

hange button
02 on the instrument panel.
The following modes can be selected in the display:



•

F
uel e conomy – displays the current and average



fuel consumption.




•
a
verage Speed

– displays the average vehicle



speed since the last reset.




•

Driving Distance
– displays the distance driven since the last reset.



•
e
lapsed Time – displays the time since the last reset.



•
r
ange – displays the estimated distance to empty (dte) the vehicle can be driven



before refueling.




•

Settings
– This menu allows you to set the clock, preferences for alerts, maintenance intervals



or language displays. T
urn the control change button
02 to select or adjust menu items



a

nd press the button to set.
For more information, refer to the “instruments and controls (section 2)” of your Owner’s Manual.
02
01
Blue TooTH® HaNDS-Free PHo Ne SYST eM (if so equipped)
With an overhead microphone and sound



t
ransmitted through the audio system speakers,



the Bluetooth® Hands-free Phone System utilizes



Bluetooth wireless tec
hnology and voice recognition



to provide hands-free cellular phone communication.
A cellular telephone should not be used while driving



so full attention may be given to vehicle operation.
*
SYSTEM OPERATING TIPS
Reduce background noise as much as possible by



closing windows and pointing HV
A
c
vents away from



the ceiling.
Press the
button on the steering wheel to activate
voice recognition.
Wait for the tone before speaking.
Begin speaking a command within 5 seconds of the tone.
Speak in a clear and natural voice without pausing



between words.
Look straight ahead and avoid speaking too loudly or too softly .
To go back to the previous command, say “Go back” or “ c orrection.”
15
system guide
*Some jurisdictions prohibit the use of cellular telephones while drivin\
g.
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1276461_13c_Rogue_QRG_122112.indd 1512/21/12 10:30 AM

To cancel a voice recognition session, simply wait 5 seconds, say “c ancel” or “Quit,” or press



and hold the button for 5 seconds.
To interrupt the system voice and give a command quickly, press the
button.

When speaking Phonebook names, please be aware some phones require the la\
st name to be



spoken before the first name. F
or example, “Michael Smith” may be spoken as “Smith Michael”.
To increase or decrease the volume of the voice prompts, push the volume \
control switches
or
on the steering wheel or turn the VOL/ON•OFF control knob on the audio

system while the system is responding.
If the Voice Recognition system does not recognize your voice commands, train th\
e system



using the Speaker Adapt
ation Mode. See your Owner’s Manual for detailed information.
Some commands are not available while the vehicle is in motion.
The “Help” command can be used to hear a list of available commands\
at any time.
Please refer to the cellular phone manufacturer’s Owner’s Manual for detailed information



regarding your Bluetooth phone.
For recommended phones and detailed instructions, please visit
www

.nissanusa.com/bluetooth.
cONNEcTING PRO c EDURE
NOTE: The vehicle must be stationary when connecting the phone.
1.

Press the
button on the steering wheel. The system announces the available commands.

2.


S

ay: “
c
onnect phone”. The system acknowledges the command and announces the next set



of available commands.
3.


S

ay: “Add phone”. The system acknowledges the command and asks you to initiate connecting



from the phone handset.
4.


Initiate connecting from the phone:
The connecting procedure varies according to each cellular phone model. For detailed



connecting instructions and compatible phones, please visit




www
.nissanusa.com/bluetooth.
When prompted for a Passkey code, enter “1234” from the handset. (The Passkey code is



assigned by N
ISSAN and cannot be changed.)
5.


S
ay a name for the phone when the system asks you to provide one. You can give the phone



a name of your c
hoice.
PHONEBOOk SE TUP
Depending on your cell phone, the system may automatically download your\
cell phone’ s



entire phonebook to the vehicle’
s Bluetooth system.
If the phonebook does not download automatically , 40 entries can be individually downloaded.
system guide
16To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1276461_13c_Rogue_QRG_122112.indd 1612/21/12 10:30 AM

17
To manually download entries:



1.

Push the button on the steering wheel.




2.


After the tone, s
ay “Phonebook”.



3.


After the next tone, s
ay “Transfer Entry”. The system acknowledges the command and



asks you to initiate the transfer from the phone handset. T
he new contact phone number



will be transferred from the cellular phone to the vehicle.
The transfer procedure varies according to each cellular phone. See your cellular phone’s



owner
’s manual for details. You can also visit www.nissanusa.com/bluetooth for



instructions on transferring phone numbers from N
ISSAN recommended cellular phones.



4.

T
he system repeats the number and prompts you for the next command. When you have



finished entering numbers or transferring an entry
, choose “Store.”



5.

T
he system confirms the name, location and number.
MAkING A cALL F ROM THE PHONEBOOk
1. Press the
button.

2.


After waiting for the tone, s
ay “ c all”.
3.


After the next tone, speak a name of a phonebook entry
. For example “Michael Smith”.
4.

c
onfirm the correct name is recognized by saying “Dial” after the tone.
NOTE: Names stored in all UPPER
cA

SE letters may not be recognized correctly by the voice
recognition system.
MAkING A cALL B Y PHONE NUMBER
1. Press the
button. A tone will sound.
2.


S

ay: “
c
all”. The system acknowledges the command and announces the next set of



available commands.

3.


S

ay: “Phone Number”. The system acknowledges the command and announces the next



set of available commands.

4.


S

ay the number you wish to call starting with the area code in single digit format.
5.


W

hen you have finished speaking the phone number, the system repeats it back and



announces the available commands.

6.


S

ay: “Dial”. The system acknowledges the command and makes the call.
REcEIVING/ENDING A cA LL
When you receive a phone call, a ring tone sounds through the audio syste\
m.
To accept the call, press the
button. To reject the call, press the button.
To hang up the phone at the end of a call or to disconnect during call pl\
acement, press
the button.
For more information, refer to the “Center display, heater, air conditioner, audio, phone and voice recognition systems
(section 4)” of your Owner’s Manual.
To view detailed instructional videos regarding these and other features, please go\
to www.nissanownersinfo.mobi
1276461_13c_Rogue_QRG_122112.indd 1712/21/12 10:30 AM