2013 MITSUBISHI OUTLANDER XL tires

[x] Cancel search: tires

Page 319 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 3-204 Features and controls
3
Immobilizer is registered. Refer to “Customer key programming 
(Except for vehicles sold in Canada)” on 
page 3-7.
Refer to “Customer F.A.S.T.-key program-
ming (E

Page 409 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-2 Driving safety
4Driving precaution
N00629300053
Utility vehicles have higher ground clearance and a narrower
track, which enables them to perform in a wide variety of off-
road situations. Because

Page 413 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-6 Driving safety
4
DefrostersCheck these by selecting the defroster mode, and set the blower
switch on high. You should be able to feel the air blowing
against the windshield.
 Refer to “Defrostin

Page 418 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual Driving safety
4-11
4
This placard shows the maximum number of occupants permit-
ted to ride in your vehicle as well as “the combined weight of
occupants and cargo” (A), which is called the vehicl

Page 429 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 4-22 Driving safety
4
Vehicle preparationBefore you start, check the trailer hitch, safety chains, tires and
mirror adjustment.TireBe sure your vehicle’s tires are inflated to the cold inflation
pre

Page 582 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual For emergencies
6-11
6
NOTEThe chocks shown in the illustration do not come with
your vehicle. It is recommended that you purchase chocks
or blocks and keep them in the vehicle for use if needed.
If

Page 583 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 6-12 For emergencies
6
To remove the spare tire
N00849700260
1. Open the tailgate and use the bar to remove the cover (A)
over the tire hanger mounting bolt.
Refer to “Flap-fold tailgate: To open”

Page 589 of 714

MITSUBISHI OUTLANDER XL 2013  Owners Manual 6-18 For emergencies
6
5. Remove the wheel nuts with the wheel nut wrench, then
take the wheel off.6. Clean out any mud, etc. on the hub surface (F), hub bolts
(G) or in the installation holes (H) in