2013 MITSUBISHI OUTLANDER SPORT ECO mode

5
The sunshade can be operated with the ignition switch or the operation mode in ON.
A


-

Pull the s
witch in the arrow direction to
open the sunshade. Pulling the switch all
the way automatically opens the sunshade
completely.
B


-

Push the s
witch in the arrow direction to close the sunshade. Pulling the switch all the way
automatically closes the sunshade completely.
C


-

Push the s
witch to stop the moving sunshade. If an object obstructs the sunshade from
closing the safety mechanism will cause the sunshade to re-open automatically. The
opened sunshade will become operational again after a few seconds.
The sunshade illumination turns on with the ignition switch or when the operation mode is in ON or ACC.
D

-

Push the s
witch to change brightness of the sunshade illumination. The brightness switches in sequence from


high → middle → low → off → high.
A

-

T
urn for Temperature control
B
-

Push t
o select outside air (Indicator light off) or recirculated air
(Indicator light on)
C
-

T
urn to select the blower speed. To the right increases blower speed. To
the left decreases blower speed. Turned all the way to the left turns the
blower off. Note: OFF is located above AUTO.
D
-

Push f
or air conditioning ON/OFF (Indicator light on/Indicator light off).
E - Turn to select the air flow and direction mode (AUTO position is only
aut

o type air conditioning).
F
-

Push t
o defog the rear window (Indicator light on). Rear window



def
ogger light automatically turns off after 20 minutes.
To defog front windshield
1.
Set the Mode Dial
E to defrost
position.
2.
Set the blo
wer speed C to the maximum position.
3.

Set the t

emperature A to highest position.
Air Conditioning (Automatic shown) The wipers will operate once.
INT: Intermittent intervals can be
adjusted by turning the knob A
AUTO: The wipers will be
operated automatically by rain
sensor (if so equipped).
Slow
FastWindshield Wipers
CONTROLS
Sunshade
Turn the knob B to operate the
rear window wiper.
The wiper operates
continuously for several
seconds then operates
intermittently at intervals of
about 8 seconds.
Washer fluid is sprayed,
the wiper will aut

omatically
operate 2 or 3 times.
Rear Window Wiper/Washer
Rain Sensing Wipers
(if equipped)
It is possible to adjust the
sensitivity of the rain sensor by
turning the AUTO ring (C).
+ Higher sensitivity to rain
— Lower sensitivity to rain
C
A
D
B
C

6OWN THE ROAD
A - CANCEL: To deactivate the cruise control
B - ACC RES: To increase the set speed or resume previously
set cruise control operation.
C - COAST SET: To set the desired speed and to reduce
the set speed
D - ON/OFF: To turn ON/OFF cruise control
To set a cruising speed
1.
Press D and the CRUISE
indicator light in the meter
cluster will be turned on.
2.

A

ccelerate or decelerate to your desired speed (above
25 mph). Press C and remove your foot from the
accelerator pedal.
To accelerate or decelerate speed
Press B to increase set cruising speed.
Press C to decrease set cruising speed.
To cancel the cruising speed
Press A or press brake pedal, or press D .
– :SHIFT DOWN + :SHIFT UP
Paddle Shifters (if equipped) Drive Mode Selector (if equipped) The drive mode can be switched by pressing the
4WD button while the ignition switch is in the ON
position. The following drive modes are available:
2WD: This mode is for economical driving on
normal dry roads and freeways.
4WD AUTO: This mode is for all driving
conditions on various roads.
4WD LOCK: This mode is for driving in slippery conditions such as on
snow-covered roads or sand.
Cruise Control
A
Clock
To set the time
1.
Pr
ess and hold A and the clock display
flashes.
2.
Press C to set the “Hours”.
3.
Press D to set the “Minutes”.
4.
Press B to stop the clock display from
flashing.
ABCD
B
C
D
Simply upshift or
downshift with a
tap of your fingers,
without moving
your hands from the
steering wheel.
You can return to the
automatic shifting
mode by pulling the
+ (SHIFT UP) side
paddle shifter towards
you and holding for
over 2 seconds.
Seat Heater Switch Position - Action
1 (HI) - F or quick heating
2

- Hea
ter off
3

(L
O)
- T
o keep the seat warm
ECO Driving
When the ECO indicator light is on,
your current driving style supports
good fuel economy. ECO light will
only work in a normal mode. It will
not illuminate in either Sport Mode
or with Cruise Control on.

13
Q: I only have one remote for the remote start system on my Outlander Sport. Can I get a second one?
A: No . Only one remote can be programmed per vehicle for security reasons.
Q:

Ho
w can I get the MPG stated on the window sticker?
A: Vehicle
driving styles will greatly affect MPG. Avoid sudden abrupt starts from a stop and let the vehicle coast to the traffic light.
Both of these s

tyles will increase mileage and reduce brake lining wear.
• Vehicles
are designed to achieve the best fuel mileage when they are driven at the speed limits on the freeway. Avoid driving
o

ver 65 mph.
• Under
inflated tires will increase rolling resistance and will reduce fuel mileage. Check tire pressure frequently to increase miles
per gallon. Pr

oper tire pressure also ensures optimum tire performance (including tire wear.)
Q:

Ho
w does the Navigation System choose a certain route?
A:

T
he system takes into account traffic conditions, road types, distance and road width to recommend the route.
Q:

W
hy does my Anti-Lock Braking System (ABS) make a noise?
A:

Each time y
our vehicle is started and driven a short distance, you will hear the sound of the ABS motor operating from the right front
engine compartment. This is the normal sound the Anti-Lock Braking System makes when performing a self check.
Q:

W
hy do my Rain Sensing Windshield Wipers operate on their own when it’s not raining?
A: • When
the lever is in the AUTO position, the rain sensor detects rain or snow and automatically turns on the wipers.
• The
wipers may automatically operate when things such as insects or foreign objects are affixed to the windshield on top of the
r

ain sensor or when the windshield is frosted over.
• To
stop the wipers, place the lever in the OFF position.
Q:

W
hy does my check engine light come on after I put gas in my car?
A:

T
here are many reasons why your check engine light may illuminate. Before calling your dealership, make sure the
fuel cap is fully engaged and y

ou have heard three clicks when tightening it. If after checking and hearing three clicks and driving for
awhile the light is still on, contact your dealership.
Q:

Ho
w do I use the emergency key when the F.A.S.T. key battery or vehicle battery is run down?
A:

R
emove the emergency key from the F.A.S.T key fob and manually unlock the door. Once inside the vehicle insert the F.A.S.T.
k

ey fob into the key slot in the glove box. Starting the engine and changing the operation mode should now be possible.
R

emove the F.A.S.T. key from the slot after starting the engine or changing the operation mode.
FAQ ’ s