2013 MITSUBISHI OUTLANDER Audio

Overview
Instruments and controls
N00100201374
Cruise control switch
(if so equipped)
P. 3 - 1 4 3 Active stability control (ASC) OFF switch
P.3-140
Ignition switch P.3-25, 3-89Steering wheel tilt lock lever
P. 3 - 8 2 Wiper and washer switch P.3-228
Rear window wiper and washer
switch P.3-235 Instrument cluster P.3-163
Supplemental restraint system (SRS) - airbag (for driver’s seat) P.2-61, 2-72
Horn switch P.3-238Combination headlights and dimmer switch P.3-217
Turn signal lever P.3-225
Front fog light switch
(if so equipped) P.3-227
Sportronic steering wheel paddle
shifter (if so equipped)
P.3-101, 3-111
Steering wheel audio remote control
switches (if so equipped) P.5-120
Bluetooth
® 2.0 interface (if so equipped)
P. 3 - 2 3 9Headlight leveling switch
(if so equipped) P.3-224
BK0150600US.book 1 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

Overview
Supplemental restraint system (SRS) - air
bag (for front passenger’s seat)
P.2-61, 2-72 Center vents P.5-2
Upper glove compartment
P.3-278
Selector lever P.3-95, 3-10512 V power outlet P.3-271Lower glove compartment
P. 3 - 2 7 8
Fuel tank filler door release lever
P. 1 - 4Rear window defogger switch P.3-237Side vents P.5-2
Drive mode-selector (if so equipped)
P. 3 - 1 1 5 Personal compartment
P.3-280
Fuses P.7-40
Engine hood release lever
P. 7 - 4Hazard warning flasher switch
P.3-226
Built-in cup holder P.3-284
Parking brake lever P.3-81 Mitsubishi Multi-Communication System (if so equipped)
Audio (if so equipped) P.5-46, 5-66
Clock (if so equipped) P.5-136
Air conditioning P.5-6, 5-16, 5-25, 5-35
BK0150600US.book 2 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

Overview
Interior
N00100301160
Adjustable seat belt shoulder anchor P.2-45
Reading & dome light
P.3-274, 7-51, 7-73 Supplemental restraint system (SRS)
- curtain airbags P.2-79Seat belts P.2-39Head restraints P.2-26
Sun visors P.3-270
Vanity mirror P.3-270
Card holder P.3-270
Quarter trim box (if so equipped)
P.3-283
Arm rest
P.2-15
Cup holder
P.3-286Inside rearview mirror
P.3-83, 3-161
Arm rest P.2-11
Floor console box P.3-281
12 V power outlet P.3-271
USB input terminal (if so equipped) P.3-264
Auxiliary Audio connector (RCA) (if so equipped) P.5-118
Auxiliary Video connector (RCA) (if so equipped) P.5-118Front seat P.2-5
Heated seat (if so equipped)
P. 2 - 1 1 Cargo room light
P.3-276, 7-51, 7-75 Dome light (rear) P.3-275, 7-51, 7-75
Luggage floor box (if so equipped)
P.3-284Cargo area cover
(if so equipped)
P.3-288
Supplemental restraint system (SRS)
- side airbag (for front seats)
P.2-78
BK0150600US.book 3 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

1-8 General information
1
Modification/alterations to the electrical or fuel
systems
N00301800141
Mitsubishi Motors manufactures high quality vehicles with an
emphasis on safety. It is important to consult an authorized
Mitsubishi Motors dealer before installation of any accessory
which may involve modification of the electrical or fuel sys-
tems.
Genuine Mitsubishi Motors parts
N00301400219
Mitsubishi Motors Genuine Parts are designed and manufac-
tured to meet high standards of performance, and are recom-
mended for all of your maintenance needs. Also available from
your Mitsubishi Motors dealer are a wide variety of accessories
to personalize your new vehicle. Each Mitsubishi Motors vehi-
cle has a selection of Mitsubishi Motors authorized accessories
to choose from to tailor your new vehicle to your own personal
preference. Your Mitsubishi Motors dealer’s Parts Manager has
information on various audio systems, protection items, as well
as interior and exterior accessories available for your specific
model.
CAUTION
!
Please consult an authorized Mitsubishi Motors
dealer concerning any such accessory fitment or
modification.
If the wires interfere with the vehicle body or
improper installation methods are used (protective
fuses not included, etc.), electronic devices may be
adversely affected, resulting in a fire, vehicle dam-
age, or other accident.
BK0150600US.book 8 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

3-4 Features and controls
3
NOTE
The key is a precision electronic device with a built-in sig-
nal transmitter. Please observe the following in order to
prevent damage.
• Do not leave where it may be exposed to heat caused by
direct sunlight, such as on top of the dashboard.
• Do not take the remote control transmitter apart.
• Do not excessively bend the key or subject it to strong
impacts.
• Keep the remote control transmitter dry.
• Keep away from magnetic objects such as key rings.
• Keep away from devices that produce magnetism, such
as audio systems, computers and televisions.
• Keep away from devices that emit strong electromag-
netic waves, such as cellular phones, wireless devices
and high frequency equipment (including medical
devices).
• Do not clean with ultrasonic cleaners.
• Do not leave the key where it may be exposed to high
temperature or high humidity.

If you lose your key, to prevent the theft of the vehicle
immediately contact an authorized Mitsubishi Motors
dealer.
If you notify an authorized Mitsubishi Motors dealer of
the key number, they can make a new key. The key num-
ber is stamped on the key number plate. Keep the key
number plate in a safe place separate from the key itself.
No keys other than those registered in advance can be
used to start the engine.
Refer to “Electronic immobilizer (Anti-theft starting sys-
tem)” on page 3-5.
Refer to “Free-hand Advanced Security Transmitter
(F.A.S.T.-key): “Electronic immobilizer (Anti-theft start-
ing system)” on page 3-24.

When the theft-alarm is in the system operational status,
the alarm operates if a door or tailgate is opened after
using the key, the door lock knob or the power door lock
switch to unlock the vehicle.

The system does not enter the preparation status if the
keyless entry system or the F.A.S.T.-key operation was
not used to lock the vehicle.
BK0150600US.book 4 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

Features and controls
3-67
3
Armed stagePark the vehicle and stop the engine. Arm the system as
described below.
1. Turn the ignition switch to the “LOCK” position.
Also, if a key was used to start the engine, remove the key
from the ignition switch.
2. Make sure that the engine hood is closed.
3. Lock all doors and the tailgate by using the keyless entry
system or the F.A.S.T.-key operation.At this time, the theft-alarm indicator (A) on the audio
panel flashes for confirmation.
4. The system has entered the armed stage after about 20
seconds, when the theft-alarm indicator (A) flashing
becomes slower.
The theft-alarm indicator (A) continues to flash while the
system is in the armed stage.Arm the system and leave
BK0150600US.book 67 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

3-90 Features and controls
3
ACC power auto-cutout function
N00539600058
After about 30 minutes has elapsed with the ignition switch in
the “ACC” position, the function automatically cuts out the
power for the audio system and other electric devices that can
be operated with that position.
When the ignition switch is turned from the “ACC” position,
the power is supplied again to those devices.NOTE
It is possible to modify functions as follows:
• The time until the power cuts out can be changed to
about 60 minutes.
• The ACC power auto-cutout function can be deacti-
vated.
For details, we recommend you to consult an authorized
MITSUBISHI MOTORS dealer.
On vehicles equipped with Mitsubishi Multi-Communica-
tion System, screen operations can be used to make the
adjustment.
Refer to the separate Mitsubishi Multi-Communications
System manual for details.
To remove the key
N00550900113
When removing the key, first set the selector lever to the “P”
(PARK) position, and then turn the key to the “LOCK” position
and remove it.NOTE
The key cannot be removed unless the selector lever is set
to the “P” (PARK) position, which allows the ignition
switch to turn to the “LOCK” position.
BK0150600US.book 90 ページ ２０１２年３月３０日　金曜日　午前１０時４３分

3-192 Features and controls
3
NOTE
If the battery is disconnected, the language cooperative
control is automatically set to “A or 1” (language coopera-
tion: enabled).

The language cooperation setting can be switched in the
following manner.
• When “A or 1” (language cooperation: enabled) has
been selected, the language for Mitsubishi Multi-Com-
munication System (if so equipped) or Bluetooth
® 2.0
interface (if so equipped) is automatically changed to
the language selected for the multi-information display.
• When “M, 2 or P” (language cooperation: disabled) has
been selected, the language for Mitsubishi Multi-Com-
munication System (if so equipped) or Bluetooth® 2.0
interface (if so equipped) is not automatically changed
to match the language selected for the multi-information
display.

On vehicles equipped with the audio system, the language
on the display of the audio system is not switched even if
you select A or 1 of the language cooperation control.
Operation sound setting
N00557400146
You can turn off the operation sounds of the multi-information
meter switch and rheostat meter illumination button.
1. Press and hold the multi-information meter switch (for
about 2 seconds or more) to switch from the setting mode
screen to the menu screen.
Refer to “Changing the function settings (With ignition
switch in the “ON” position)” on page 3-184.
2. Lightly press the multi-information meter switch to select
“ ” (operation sound setting).3. Press and hold the multi-information meter switch (for
about 2 seconds or more) to switch in sequence from ON
(operation sound on) → OFF (operation sound off) → ON
(operation sound on).
The setting is changed to the selected condition.
Type 1
Type 2
BK0150600US.book 192 ページ ２０１２年３月３０日　金曜日　午前１０時４３分