2013 MINI 3 door ignition

CareVehicle equipmentAll standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not available in a vehi‐
cle, e. g., because of the selected optional
equipment or country variant. This also applies
for safety-related functions and systems.
Car washes
Hints Steam jets or high-pressure washers
When using steam jets or high-pressure
washers, hold them a sufficient distance away
and use a maximum temperature of
140 ℉/60 ℃.
If the vehicle has a glass sunroof, ensure that a
distance of at least 31.5 inches/80 cm is main‐
tained. Holding them too close or using exces‐
sively high pressures or temperatures can
cause damage or preliminary damage that may
then lead to long-term damage.
Follow the user's manual for the high-pressure
washer. ◀
Cleaning sensors/cameras with high-pres‐
sure washers
When using high-pressure washers, do not
spray the exterior sensors and cameras, e.g.,
Park Distance Control, for extended periods of
time and only from a distance of at least
12 in/30 cm. ◀▷Regularly remove foreign items such as
leaves in the area below the windshield
when the hood is raised.▷Wash your vehicle frequently, particularly in
winter.Intense soiling and road salt can damage
the vehicle.
Automatic car washes
Hints
▷Give preference to cloth car washes or
those that use soft brushes in order to
avoid paint damage.▷Make sure that the wheels and tires are not
damaged by the transport mechanisms.▷Fold in the exterior mirrors; otherwise, they
may be damaged, depending on the width
of the vehicle.▷Unscrew the rod antenna.▷Deactivate the rain sensor, refer to
page 50, to avoid unintentional wiper acti‐
vation.▷In some cases, an unintentional alarm can
be triggered by the interior motion sensor
of the alarm system. Follow the instructions
on avoiding an unintentional alarm, refer to
page 28.
Guide rails in car washes
Avoid car washes with guide rails higher
than 4 in/10 cm; otherwise, the vehicle body
could be damaged. ◀
Before driving into a car wash In order to ensure that the vehicle can roll in a
car wash, take the following steps:
Manual transmission:
1.Drive into the car wash.2.Shift to neutral.3.Switch the engine off.4.Switch on the ignition.Seite 203CareMobility203
Online Edition for Part no. 01 40 2 925 116 - X/13

Automatic transmission:1.Drive into the car wash.2.Engage transmission position N.3.Switch the engine off.
In this way, the ignition remains switched
on, and a Check-Control message is dis‐
played.
Do not turn off the ignition in the car
wash
Do not turn off the ignition in the car wash;
otherwise, the transmission position P is
engaged and damages can result. ◀
To start the engine:
1.Depress the brake pedal.2.Press the Start/Stop button.
Pressing the Start/Stop button without stepping
on the brake turns the ignition off.
The vehicle cannot be locked from the outside
when in transmission position N. A signal is
sounded when an attempt is made to lock the
vehicle.
Headlamps
▷Do not rub dry and do not use abrasive or
caustic cleansers.▷Soak areas that have been soiled, e.g., due
to insects, with shampoo and wash off with
water.▷Thaw ice with de-icing spray; do not use an
ice scraper.
After washing the vehicle
After washing the vehicle, apply the brakes
briefly to dry them; otherwise, braking action
can be reduced and corrosion of the brake
discs can occur.
Completely remove all residues on the win‐
dows, to minimize loss of visibility due to
smearing and to reduce wiper noises and wiper
blade wear.
Vehicle care
Car care products MINI recommends using cleaning and care
products from MINI, since these have been
tested and approved.
Car care and cleaning products
Follow the instructions on the container.
When cleaning the interior, open the doors or
windows.
Only use products intended for cleaning vehi‐
cles.
Cleansers can contain substances that are dan‐
gerous and harmful to your health. ◀
Vehicle paint
Regular care contributes to driving safety and
value retention. Environmental influences in
areas with elevated air pollution or natural con‐
taminants, such as tree resin or pollen can af‐
fect the vehicle's paintwork. Tailor the fre‐
quency and extent of your car care to these
influences.
Aggressive substances such as spilled fuel, oil,
grease or bird droppings must be removed im‐
mediately to prevent the finish from being al‐
tered or discolored.
Leather care Remove dust from the leather often, using a
cloth or vacuum cleaner.
Otherwise, particles of dust and road grime
chafe in pores and folds, and lead to increased
wear and premature degradation of the leather
surface.
To guard against discoloration, such as from
clothing, provide leather care roughly every
two months.
Clean light-colored leather more frequently be‐
cause soiling on such surfaces is substantially
more visible.Seite 204MobilityCare204
Online Edition for Part no. 01 40 2 925 116 - X/13

Fuel consumption, refer toAverage fuel consump‐
tion 64
Fuel filler flap 162
Fuel gauge 59
Fuel quality 164
Fuel recommendation 164
Fuel, tank capacity 211
Fuse 197
G Garage door opener, refer to Universal garage door
opener 110
Gasoline 164
Gasoline quality 164
Gear change, automatic trans‐ mission 53
Gear selector lever, automatic transmission 53
Gear shift indicator 61
General driving notes 124
Glass sunroof, refer to Panor‐ amic glass sunroof 30
Glove compartment 118
Gong, volume equaliza‐ tion 138
GREEN mode 131
GREEN mode, bonus range 132
GREEN mode indicator 131
GREEN - program, driving dy‐ namics 88
GREEN tip 133
Gross vehicle weight, ap‐ proved 210
Ground clearance 126
H Halogen headlamps 188
Handbrake, refer to parking brake 48
Hand-held transmitter, alter‐ nating code 111 Hands-free system 152
Hazard warning flashers 198
HD Radio 141
Head airbags 71
Headlamp control, auto‐ matic 67
Headlamp courtesy delay fea‐ ture 67
Headlamp flasher 49
Headlamp glass 187
Headlamps, care 204
Headlamp washer system 49
Headliner 15
Head restraints 32
Head restraints, front 35
Head restraints, rear 36
Heavy cargo, stowing 128
High-beam Assistant 68
High beams 49
High beams/low beams, refer to High-beam Assistant 68
Hills 126
Hill start assistant, refer to Drive-off assistant 89
Hints 6
Holder for beverages 119
Homepage 6
Hood 178
Horn 12
Hot exhaust system 125
Hydroplaning 125
I
Ice warning, refer to External temperature warning 59
Icy roads, refer to External temperature warning 59
Identification marks, tires 169
Identification number, refer to Important features in the en‐
gine compartment 178
Ignition key, refer to Remote control 20
Ignition off 44
Ignition on 44 Illuminated ring, central in‐
strument cluster 65
Indication of a flat tire 75, 78
Individual air distribu‐ tion 105, 107
Individual settings, refer to Personal Profile 21
Inflation pressure, tires 166
Inflation pressure warning, tires 77
Info display, refer to Com‐ puter 63
Initialize, Tire Pressure Moni‐ tor TPM 75
Initializing, Flat Tire Monitor FTM 78
Instrument cluster 56
Instrument cluster, electronic displays 57
Instrument lighting 70
Integrated key 20
Intelligent Safety 79
Intensity, AUTO program 107
Interior equipment 110
Interior lamps 70
Interior lamps via remote con‐ trol 22
Interior motion sensor 28
Interior rearview mirror, auto‐ matic dimming feature 38
Interior rearview mirror, com‐ pass 112
Interior rearview mirror, man‐ ually dimmable 38
Internet site 6
Interval display, service re‐ quirements 60
J Jacking points for the vehicle jack 194
Joystick, automatic transmis‐ sion 53
Jump-starting 198 Seite 223Everything from A to ZReference223
Online Edition for Part no. 01 40 2 925 116 - X/13