2013 MAZDA MODEL CX-5 warning lights

1112
SHIFT POSITION
INDICATOR LIGHT S
PEEDOMETERDASH bOARD
I LLUMINATION /
DIMMER
1/TRIP METER2 G LOSSARY OF W ARNING AND INDICATOR LIGHTS
NOTE: See Owner’s Manual for more details and explanations.
1 • Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.2 • Push to toggle between trip meter (A & B).
• When a trip meter is selected, push and hold to reset to zero.
Instrument Cluster
NOTE: Low ambient temperature and/or high altitude causes tire pressures to drop and
may turn the TPMS warning light on. If the warning light comes on, check the tire pressure
and fill the tires as soon as possible, preferably before moving the vehicle and warming up
the tires. Tire pressure should be checked when the tires are cold.
www.MazdaUSA.com
TCS OFF

Traction Control System
(TCS) Off Indicator Light

Low Engine Oil Pressure

Traction Control System
(TCS)/Dynamic Stability
Control (DSC) On: TCS/DSC malfunction
Flashing: TCS/DSC operating
Shift Position Indicator Light
KEY Warning Light RED

KEY Indicator Light GREEN

Power Steering Malfunction

Air bag/Front Seat b
elt
Pretensioner System
Malfunction
Turn Signals/Hazard
Warning Indicator Lights
4WD
4WD Warning Light
On:
Flashing: Stop vehicle/tow to
Mazda dealer.
Check Engine Light

Master Warning Light

Tire Pressure

Monitoring System
(TPMS
) Warning Light On/ Warning Beep: Low tire
pressure in one or more tires.
Flashing: TPMS Malfunction

Security Indicator Light

Cruise Main Indicator Light

On (A M bER)/Cruise Set
Indicator Light On (G REEN)

Automatic Transaxle

Warning Light

Lights On (Exterior) bSM
OFF

b
SM OFF
( b lind Spot Monitoring)

Seat b
elt
Unbuckled/Malfunction

Headlight High b
eams On

b
rake Warning Light Parking brake on/low brake
fluid/malfunction
AFS
OFF

Adaptive Front Lighting
System (AFS) OFF

Charging System
Malfunction
Door/Liftgate Ajar

Low Washer Fluid Level
Warning Light

A b S (Antilock b rake
System) Malfunction

Low Fuel Level

Check Fuel Cap
T
ACHOMETER
F UEL
GAUGE
ODOMETER/

TRIP METER
E NGINE C OOLANT T EMP LIGHTS Since this vehicle does not use an engine coolant
temperature gauge, red and blue engine coolant
temperature lights are used to indicate high and low
coolant temperature.
Red Coolant Temp Light
Flashing: Engine is starting to run hot. Drive
slowly to reduce engine load.
On: Engine is overheating. Safely pull over to
the side of the road and turn the engine off.

Refer to the Owner’s Manual for more information.
b lue Coolant Temp Light
On: Engine coolant is cold and no warm air is
available for heater/defroster.
Off: Engine coolant is warm and warm air is
available for heater/defroster.
The light may stay on for a few minutes after
start-up when the engine is cold, but the
vehicle can be driven with the light on or off.
INFORMATION D I S P L AYAM bIENT
T EMPERATURE
See page 8 or the
Owner’s Manual for
further information.
1191187_13c_Mazda_CX-5_SSG_062212.indd 12-136/22/12 2:47 PM

2122
www.MazdaUSA.comLights
TIRE PRESSURE MONITORING SYSTEM (TPMS)
Your vehicle is equipped with a Tire Pressure Monitoring System (TPMS)
that detects low tire pressure in one or more tires. In the following cases,
the TPMS must be “initialized” so the system can operate normally.
• The tire pressure is adjusted (up or down) in one or more tires.
• A tire rotation is performed.
•
Any tire or wheel is replaced.
•
The vehicle’s battery is disconnected, replaced or completely dead.
Initialization Process (TPMS Warning Light is Illuminated):
1
Park the vehicle in a safe place and firmly apply the parking brake.
2
Let the tires cool, then adjust the tire pressure to the specified
pressure (Refer to your Owner’s Manual for correct tire pressure) on
all four (4) tires.
3
Switch the ignition ON, but leave the vehicle parked.
4
Push and hold the TPMS “Set Switch” (left side of dash)
until the TPMS warning light
in the instrument cluster

flashes twice and a beep sound is heard once.
CAUTION: If the TPMS “Set Switch” is pressed without adjusting the tire
pressure, the system cannot detect the normal tire pressure. The TPMS
warning light may not illuminate, even if the tire pressure is low, or it may
illuminate if the tire pressure is normal.
Wheels
Push AFS OFF to turn system off or on. When off, AFS OFF
illuminates in the instrument panel.
With AFS
Without AFS
Genuine Mazda Accessory
Wheel Locks are available at
your Authorized Mazda Dealer
Your aluminum wheels have a protective
coating on them. Only use a mild soap or
neutral detergent with a sponge or soft cloth
to clean them.
CAUTION: Using a wire brush, polishing
compound, solvent, or any type of abrasive
cleaner may damage the protective coating.
ALUMINUM WHEEL CARE
A DAPTIVE FRONT-LIGHTING SYSTEM (AFS)
The adaptive front-lighting system (AFS) automatically turns the headlight
beam to the right or left in conjunction with the direction of the steering
wheel. The AFS improves the direction of headlight illumination while
cornering, and only works when the vehicle is moving.
NOTE:

•
With AFS, it is normal to see the headlights move and hear the sound of the
headlight leveling motors at the front of the vehicle when the ignition is ON.
•
The system will need to be reset if the vehicle battery has been disconnected
or the system fuse has been replaced. Please refer to your Owner’s Manual for
easy to follow resetting instructions.
1191187_13c_Mazda_CX-5_SSG_062212.indd 22-236/22/12 2:48 PM

2324
NOTE: Do not rely completely on the BSM system and be sure to look over
your shoulder before changing lanes:
• The BSM system can assist the driver in confirming the safety of the
surroundings, but is not a complete substitute.
• The driver is responsible for ensuring safe lane changes and other maneuvers.
• Always pay attention to the direction in which the vehicle is traveling and the
vehicle’s surroundings.
• The BSM system does not operate when the vehicle speed is lower than
about 20 mph (32 km/h).
Turning b SM System Off
To manually turn the BSM system off, push the BSM OFF
switch on the dash. The BSM OFF indicator will illuminate in the
instrument cluster when the BSM system is off. The BSM system
will automatically turn on the next time the vehicle is started.
Your Vehicle
Detection Areas
bLIND SPOT MONITORING (bSM) S YSTEM
The Blind Spot Monitoring (BSM) system is designed to assist the driver
by monitoring the blind spots to the rear of the vehicle on both sides.
• If your vehicle speed is 20 mph (32 km/h) or more, the BSM will warn
you of vehicles in the detection area by illuminating the BSM warning
lights located on the left and right door mirrors.
•

If you operate a turn signal in the direction of an illuminated BSM warning
light, the system will also warn you with a beep and warning light flash.
• BSM sensors are located under the left and right rear bumper areas.
The BSM system may not operate properly if the rear bumper gets
too dirty, so keep the rear bumper area clean.
Please refer to your Owner’s Manual for complete details.
INFO
Push INFO button on steering wheel to display the following (actual displayed
information will vary on your vehicle):
Average MPH
Current MPG
Average MPG
Remaining Miles
NOTE: To clear Average MPH or Average MPG, push and hold INFO button when
selected screen is displayed.
INFO
b utton
Information DisplayBlind Spot Monitor
1191187_13c_Mazda_CX-5_SSG_062212.indd 24-256/22/12 2:48 PM

Customer Delivery Checklist
Smart Start Guide
•
Remove this checklist from
Smart Start Guide
• Personalization Features
(refer to your Owner’s Manual)
Warranty Information

Warranty Start Date:
Customer Ini tial:
• Basic Vehicle –
36 months/36,000 miles
• Roadside assistance program
MyMazda.com
•
Offer to register customer on
MyMazda.com
P RESENTATION OF OWNER ’S M ATERIALS :
Review the following items with the customer
SERVICE DEPARTMENT
Introduce Service Manager;
provide business cards
Review Service and Parts
Department hours of operation
Explain free Full Circle
Service Inspection
Schedule first maintenance service
DEALERSHIP DAT E
SALES CONSULTANT CUSTOMER’S NAME
VIN E-MAIL
Owner’s Manual
Maintenance Passport
Floor Mats
•
Ensure floor mats are properly
hooked after cleaning
• Do not install two floor mats, one on
top of the other, on the driver side
• Accessory rubber floor mats should
be cleaned with mild soap and
water only
Tire P
ressure Monitoring System
• System overview
• Explain when & how to initialize
the system
• Review the system Caution
Keyless Entry
..............................1-2
• Advanced Keyless Entry*
• Door/Liftgate Request Switch*
• Liftgate Opener Switch
Starting the Engine
....................3-4
• Push Button Start System
•
Accelerated Warm-Up System (AWS)
• Emergency Vehicle Entry/
Engine Start/Stop
Seats
............................................5 -7
• Adjustments
Driver’s View
.............................9 -10
• Location of Switches and Controls
Instrument Cluster
..................11-12
• Review of Warning and Indicator
Light Function and Location
Lights
............................................13
Wiper/Washer
...............................14
Hill Launch Assist (HLA)
.............15
Set Clock
......................................16

US
b & AUX Input .......................17-18
Fuel Door
......................................19
• Fuel Door Release and Fuel Spec
Rear View Monitor* ......................20
Customer Delivery Checklist
Adaptive Front Lighting System
(AFS)*
............................................21
Aluminum Wheel Care
.................22
Information Display
.....................23
b
lind Spot Monitoring* ................24
Climate Control
........................25-26
• Manual • Automatic*


Audio Controls
.........................2 7- 3 0
• Bluetooth Audio*
• Personalization Features*
Navigation System*
.................31-32
• SD Card
• Planning a Route
b
luetooth®* ...................................33
• Pair Phone • To l l - F r e e
• Make/Receive Customer Service
a Call 800-430-0153
SCHEDULED MAINTENANCE
When replacing or topping off engine
oil, use Mazda Genuine oil. For optimal
engine performance, use SAE 0W-20
engine oil. Please consult an Authorized
Mazda Dealer for additional information.
*if equipped
SALES CONSULTANT DAT ECUSTOMER DAT E
All items in the Customer Deliver y Checklist have been reviewed with the
customer and the first maintenance appointment has been scheduled:
Signed copy must be placed in dealer jacket
V EHICLE PRESENTATION :
Refer to the Smart Start Guide during presentation
1191187_13c_Mazda_CX-5_SSG_062212.indd 36-376/22/12 2:50 PM