2013 MAZDA MODEL CX-5 brake

When Driving
5
Indicator light
Starting the Engine
For details, refer to Section 4, “Start/Stop Engine”.
(SKYACTIV-D 2.2)
• The starter does not rotate until the glow indicator light turns off.
• When starting the engine, do not release the clutch pedal (manual transaxle) or
the brake pedal (automatic transaxle) until the glow indicator light in the
instrument cluster turns off and the engine starts, after pressing the push button
start.
1. Make sure the parking brake is on.
2. Continue to press the brake pedal firmly until
the engine has completely started.
3. (Manual transaxle)
Continue to press the clutch pedal firmly until
the engine has completely started.
(Automatic transaxle)
Put the vehicle in park (P). If you must restart the
engine while the vehicle is moving, shift into
neutral (N).
4. Press the push button start after both the KEY indicator
light (green) (if equipped) in the instrument cluster and
the push button start indicator light (green) illuminate.
• If the clutch pedal (manual transaxle) or the brake pedal (automatic transaxle) is
released before the engine starts, depress the clutch pedal (manual transaxle) or
the brake pedal (automatic transaxle) again and press the push button start to
start the engine.
• If the ignition is left switched ON for a long period of time without the engine
running after the glow plugs are warmed up, the glow plugs may warm up again
which will illuminate the glow indicator light.
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

6
When Driving
Engine stop Restart
Neutral position
(Manual transaxle)
Automatic transaxle
Automatic transaxle
For details, refer to Section 4, “Start/Stop Engine”.
Operation of i-stop Function
The i-stop (idling stop) function automatically stops the engine when the vehicle is
stopped at a traffic light or stuck in traffic after the engine has been warmed up
(SKYACTIV-G 2.0, SKYACTIV-G 2.5) or other times when the engine is not cold
(SKYACTIV-D 2.2), and then restarts the engine automatically to resume driving.
The system provides improved fuel economy, reduced exhaust gas emissions, and
eliminates idling noise while the engine is stopped.
(Manual transaxle)
2. Depress the brake pedal and then the clutch pedal, and bring the vehicle to a
complete stop.
3. After bringing the vehicle to a stop, shift the lever to the neutral position while
depressing the clutch pedal. The engine automatically stops after the clutch
pedal is released. The i-stop indicator light (green) illuminates while the i-stop
function is operating.
4. To restart the engine, depress the clutch pedal (i-stop indicator light (green)
turns off). 1.(Except European model)
The i-stop indicator light (green) illuminates when the i-stop conditions
are met while the vehicle is being driven.
The i-stop indicator light (green) illuminates if the i-stop function conditions
are met again while driving (except European model).
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

7
When Driving
For details, refer to Section 4, “Start/Stop Engine”.
i-stop OFF Switch
The i-stop function can be turned off by
pressing the switch until the beep sounds and
the i-stop warning light (amber) in the
instrument cluster illuminates.
The i-stop function can be turned back on by
pressing the switch again until the beep sounds
and the i-stop warning light (amber) turns off.
Operation of i-stop Function
(Automatic transaxle)
1.(Except European model)
The i-stop indicator light (green) illuminates when the i-stop conditions are met
while the vehicle is being driven.
2. The i-stop function operates when the brake pedal is depressed while driving
the vehicle (except for driving in reverse) and the vehicle is stopped. The
i-stop indicator light (green) also illuminates while the i-stop function is
operating.
3. When the brake pedal is released while the shift lever is in the D/M position (not
second gear fixed mode), the engine restarts automatically and the i-stop
indicator light (green) turns off. The i-stop indicator light (green) illuminates if
the i-stop function conditions are met again while driving (except European
model)
With the selector lever in the N or P position, the engine will not restart even if
the brake pedal is released. If the brake pedal is depressed again, the engine
will restart.
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

8
When Driving
For details, refer to Section 4, “Instrument Cluster and Display”.
Warning/Indicator Lights
Signal Warning/Indicator Lights
1
2
3
4
5
6
7
8
9
10Brake System Warning Light Master Warning Light
ABS Warning Light
Charging System Warning Indication
Engine Oil Warning Indication
Check Engine Light
High Engine Coolant Temperature
Warning Light (Red)
i-stop Warning Light
(Amber)/Indicator Light (Green)
Rear Vehicle Monitoring (RVM)
System Warning Light
(Amber)/Indicator Light (Green)
11
12
13
14
15Lane Departure Warning System
(LDWS) Warning Light
(Amber)/Indicator Light (Green)
4WD Warning Indication
Automatic Transaxle Warning
Indication
Power Steering Malfunction
Indication
16Air Bag/Front Seat Belt Pretensioner
System Warning Light
Low Fuel Warning Light
17Seat Belt Warning Light
18
2022
23
24
30
31
32
33
Door-Ajar Warning IndicationTyre Pressure Monitoring System
Warning Light
KEY Indication
High Beam Control System (HBC)
Warning Light (Amber)/Indicator
Light (Green)
TCS/DSC Indicator Light
TCS OFF Indicator Light
AFS OFF Indicator Light
Low Engine Coolant Temperature
Indicator Light (Blue)
34
35
36
37
38Shift Position Indication
Headlight High-Beam Indicator
Light
Direction Indicator/Hazard Warning
Indicator Lights
Security Indicator Light
39Cruise Main Indicator Light
(Amber)/Cruise Set Indicator Light
(Green)
Lights-On Indicator Light
40Front Fog Light Indicator Light
Rear Fog Light Indicator Light Signal Warning/Indicator Lights
Some of the warning/indicator lights are displayed in the instrument cluster.
If a warning/indicator light is displayed in the instrument cluster, verify the
meaning of the warning in the Warning (Display Indication) item.
19Liftgate-Ajar Warning IndicationGlow Indicator Light
Diesel Particulate Filter Indication
Wrench Indication 25
26
27
Vehicle Speed Warning Indication28
29Sedimentor Warning Indication
Low Ambient Temperature Warning
Indication 21
Low Washer Fluid Level Warning
Indication
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

9
When Driving
Higher sensitivity
Less sensitivitySwitch
Centre
position
Lock-release button
For details, refer to Section 4, “Transmission” or “Switches and Controls”.
Automatic Transaxle Controls
Operation of the Headlights
Without auto-light control With auto-light control
Operation of the Windscreen Wipers
With intermittent wiper With auto-wiper control
Single wipe cycle (mist)
Intermittent (With intermittent wiper)/
Auto control (With auto-wiper control)
Low speed Switch
PositionWiper operation
High speed
When the wiper lever
is in the
position, the rain
sensor senses the
amount of rainfall on
the windscreen and
turns the wipers on
or off automatically.
Various Lockouts:
Indicates that you must depress
the brake pedal and hold in the
lock-release button to shift (The
ignition must be switched ON).
Indicates the selector lever can be
shifted freely into any position.
Indicates that you must hold in
the lock-release button to shift.
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

When Driving
10
i-ACTIVSENSE
Your vehicle is equipped with a variety of safety and driver support systems called
i-ACTIVSENSE
For details, refer to Section 4, “Switches and Controls”.
In addition, a Forward Sensing Camera (FSC) and Laser sensors are installed to
operate the systems.
Your vehicle is equipped with a Forward Sensing Camera (FSC). The Forward
Sensing Camera (FSC) is positioned near the rearview mirror and used by the
following systems. Safety and Driver Support Systems
• Smart City Brake Support (SCBS)
• Rear Vehicle Monitoring (RVM) System
• Lane Departure Warning System (LDWS)
• High Beam Control System (HBC)
Forward Sensing Camera
• High Beam Control System (HBC)
• Lane Departure Warning System (LDWS)
Always keep the windscreen glass around the camera clean by removing dirt or
fogging. Use the windscreen defroster to remove fogging on the windscreen.
• Adaptive Front Lighting System (AFS)
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

When Driving
11
Smart City Brake Support (SCBS)
The Smart City Brake Support (SCBS) system is designed to reduce damage in the
event of a collision by operating the brake control (SCBS brake) when the
system's laser sensor detects a vehicle ahead and determines that a collision with
the vehicle ahead is unavoidable.
For details, refer to Section 4, “Smart City Brake Support (SCBS)”.
It may also be possible to avoid a collision if the relative speed between your
vehicle and the vehicle ahead is less than about 15 km/h (9.3 mph).
Do not rely completely on the Smart City Brake Support (SCBS) system:
The Smart City Brake Support (SCBS) is a system which operates in response to a
vehicle ahead. It does not apply to 2-wheeled vehicles or pedestrians.
If the vehicle height or inclination is changed, the system will not be able to
correctly detect vehicles ahead resulting in the Smart City Brake Support
(SCBS) system not operating normally or mistakenly operating, which
could cause a serious accident.
WARNING
Do not modify the suspension:
NOTE
The Smart City Brake Support (SCBS) detects a vehicle ahead by emitting a
near-infrared laser beam and receiving the beam reflected off the reflector of the
vehicle ahead, and then using it for the measurement. Consequently, the Smart
City Brake Support (SCBS) may not operate under the following conditions:
• Trucks with low loading platforms and vehicles with an extremely low or
high profile.
• Under bad weather condition, such as rain, fog and snow.
• The window washer is being used or the windscreen wipers are not used when
its raining.
• The windscreen is dirty.
• The steering wheel is turned completely left or right, or the vehicle is acceler-
ated rapidly and comes close to the vehicle ahead.
Other details are described in the related text.
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD

Maintenance and Care
14
SKYACTIV-G 2.0 and SKYACTIV-G 2.5
SKYACTIV-D 2.2 Windscreen washer fluid reservoir
Engine oil-filler capBrake/Clutch fluid reservoir
BatteryFuse block
Engine oil dipstickEngine coolant reservoir Cooling system cap
Windscreen washer fluid reservoir
Engine oil-filler capBrake/Clutch fluid reservoir
BatteryFuse block
Engine oil dipstick Cooling system cap Engine coolant reservoir
Owner Maintenance Precautions
Routine Service
We highly recommend that these items be inspected daily, or at least every week.
• Engine Oil Level
• Engine Coolant Level
• Brake and Clutch Fluid Level
• Washer Fluid Level
• Battery Maintenance
• Tyre Inflation Pressure
For details, refer to Section 6, “Owner Maintenance”.
%:A',''&A'FKVKQPA3WKEM)WKFGKPFD