10Functional Verifcation
Function Checks: Look for:
Turn vehicle ignition to ON, depress power
button on each headrest monitor.Monitor should power on and start up
screen should appear on screen.
Insert disc into DVD player, press ENTER
button on the remote control or front panel. Disc should begin playing.
Listen with wireless headphones (be sure
to set to channel “A” to listen to Monitor A
and channel “B” to listen to Monitor B. Audio should be heard through wireless
headphones.
Press SOURCE button on Monitor B until it
reads Monitor A. DVD in Monitor A should be displayed on
Monitor B also.
Press SOURCE button on Monitor A until it
reads Monitor B. DVD in Monitor B should be displayed on
Monitor A also.
Depress eject button on the remote con-
trol or front panel. Disc should eject.
Turn on vehicle radio and set station to the
frequency set on FM transmitter
(if available). Only audio from Monitor A should be
heard through vehicle speakers.
Functional Verifcation
25Troubleshooting
EN
Troubleshooting
Symptom Remedy
Device does not power “ON” t
Is ignition turned “ON”?
t Are batteries installed in remote control?
IR sensor inoperative t
Verify that the batteries in the remote control are good.
t Verify that the remote sensor eye is not obstructed.
t Verify that the infrared transmitter is afxed over the
sensor eye of the component to be controlled.
Disc won’t play t
Insert a disc with label side rear of the vehicle.
t Check if the disc is defective by trying another disc.
t Check the type of disc you put into DVD compartment
slot. This DVD player only plays DVDs, audio CDs, and
MP3s.
t Both the device and the disc are coded by region.
If the regional codes don’t match, the disc can’t be
played. This DVD player us set to region number 1.
Disc plays, but then stops
immediately t
The disc is dirty and needs cleaning.
t Condensation has formed. Allow player to dry out.
No picture t
Check that the signal source is connected.
t The setting may be in the wrong status. Match your
monitor mode with the source correctly.
Distorted picture t
Check the disc for fngerprints and clean with a soft
cloth, wiping from center to edge.
t Sometimes a small amount of picture distortion may
appear. This is not a malfunction.
Cannot advance through a
movie t
You cannot advance through the opening credits and
warning information that appears at the beginning of
movies because the disc is programmed to prohibit
that action.
No sound or distorted sound t
Make sure that the DVD player is connected properly,
and all cables are securely inserted into the appropri-
ate jacks.
t If you are using the IR headphones, make sure you
turn on the IR power.
t Is volume turned “UP” on headphones?
t Is anything blocking signal between monitor and
headphones?
Device feels warm t
When the device is in use for a long period of time, the
surface will be warm. This is normal.
Player does not respond to all
commands during playback t
Operations are not permitted by the disc.
t Refer to the instructions in the disc inlay.
