2013 LINCOLN MKX audio

25Troubleshooting
EN
Troubleshooting
Symptom Remedy
Device does not power “ON”t

Is ignition turned “ON”?
t
Are batteries installed in remote control?
IR sensor inoperative t

Verify that the batteries in the remote control are good.
t
Verify that the remote sensor eye is not obstructed.
t
Verify that the infrared transmitter is afxed over the
sensor eye of the component to be controlled.
Disc won’t play t

Insert a disc with label side rear of the vehicle.
t
Check if the disc is defective by trying another disc.
t
Check the type of disc you put into DVD compartment
slot. This DVD player only plays DVDs, audio CDs, and
MP3s.
t
Both the device and the disc are coded by region.
If the regional codes don’t match, the disc can’t be
played. This DVD player us set to region number 1.
Disc plays, but then stops
immediately t

The disc is dirty and needs cleaning.
t
Condensation has formed. Allow player to dry out.
No picture t

Check that the signal source is connected.
t
The setting may be in the wrong status. Match your
monitor mode with the source correctly.
Distorted picture t

Check the disc for fngerprints and clean with a soft
cloth, wiping from center to edge.
t
Sometimes a small amount of picture distortion may
appear. This is not a malfunction.
Cannot advance through a
movie t

You cannot advance through the opening credits and
warning information that appears at the beginning of
movies because the disc is programmed to prohibit
that action.
No sound or distorted sound t

Make sure that the DVD player is connected properly,
and all cables are securely inserted into the appropri-
ate jacks.
t
If you are using the IR headphones, make sure you
turn on the IR power.
t
Is volume turned “UP” on headphones?
t
Is anything blocking signal between monitor and
headphones?
Device feels warm t

When the device is in use for a long period of time, the
surface will be warm. This is normal.
Player does not respond to all
commands during playback t

Operations are not permitted by the disc.
t
Refer to the instructions in the disc inlay.

26Specifcations
EN
Specifcations
Dimensions 210(W ) x 190(H) x 50(D) mm
Weight .862 Kg
Power ConsumptionOperation <17W
Standby <2.5W
LCD Backlight LED
Resolution 480x3(RGB) x234 TFT LCD Panel
Luminance 450cd/m2 (typ.)
DVD Slot-In Loader
Supported Disc DVD (Single, Dual Layer), DVD-R/+R, DVD+R Dual layer,
DVD-RW/+RW, CD, CD-R, CD-RW
Supported Format DVD (Single, Dual Layer), DVD-R/+R, DVD+R Dual layer,
DVD-RW/+RW, CD, CD-R, CD-RW
Source Internal DVD, CD, Analog AV input
Operation Temperature/Humidity -20°C~70°C/20~90% RH
Storage Temperature/Humidity -30°C~85°C/5~95% RH
Expected Backlight Life 10,000 hours
Video Display System NTSC/PAL
Supply Input Voltage 10V~16V DC
Maximum Input Current 1.3A (Vin = 10V DC)
Frequency Response 20Hz ~20KHz ± 1dB
Signal/Noise Ratio 85dB
Audio Distortion + Noise -80dB (1KHz)

27
EN
Acoustic Noise 40dB
Control Button on the Front Panel POWER, SOURCE, PLAY, STOP, EJECT
I/O Ports 1/8” Headphone Jack, AV In RCA Jacks
Audio Out (analog audio)0.4
(headphone)Output Level: 2V ± 10%
Load Impedance (Audio Out) 10K
Video Out Output Level 1Vp-p ± 20%
Load Impedance (Video Out) 75
Wireless Audio Dual channel infrared audio transmitter,
Support IR receiver stereo headphone
(reception: 0.9 m; 80°, 1.8 m; 50°)
IR Channels Channels
A: 2.3/2.8 MHZ
B: 3.3/3.8 MHZ
3: Proprietary
4: Proprietary