2013 Lexus IS300h key

4146-3. Using the storage features
IS300h_EE(OM53B95E)
Open (press the button)
Unlock with the mechanical key
Lock with the mechanical key
The glove box light turns on when the power switch is in ACCESSORY or ON
mode.
The trunk opener main switch is located in the glove box. (P. 145)
Push the knob.
Lift by hand to fully open the con-
sole box.
Glove box
1
2
3
The insert inside the glove box can be
removed.
Console box

425
7Maintenance and care
IS300h_EE(OM53B95E)
7-1. Maintenance and care
Cleaning and protecting
the vehicle exterior ......... 426
Cleaning and protecting
the vehicle interior .......... 430
7-2. Maintenance
Maintenance
requirements ................... 433
7-3. Do-it-yourself
maintenance
Do-it-yourself service
precautions...................... 435
Hood ................................. 437
Positioning a floor jack ..... 438
Engine compartment ......... 439
12-volt battery................... 447
Tires .................................. 450
Replacing the tire .............. 460
Tire inflation pressure ....... 466
Wheels .............................. 468
Air conditioning filter ....... 470
Electronic key battery ....... 472
Checking and replacing
fuses ................................ 475
Light bulbs ........................ 479

426
IS300h_EE(OM53B95E)7-1. Maintenance and care
Working from top to bottom, liberally apply water to the vehicle body,
wheel wells and underside of the vehicle to remove any dirt and dust.
Wash the vehicle body using a sponge or soft cloth, such as a chamois.
For hard-to-remove marks, use car wash soap and rinse thoroughly
with water.
Wipe away any water.
Wax the vehicle when the waterproof coating deteriorates.
If water does not bead on a clean surface, apply wax when the vehicle body is
cool.
Automatic car washes
Fold the mirrors before washing the vehicle. Start washing from the front of the
vehicle. Make sure to extend the mirrors before driving.
Brushes used in automatic car washes may scratch the vehicle surface and harm
your vehicle’s paint.
High pressure car washes
Do not allow the nozzles of the car wash to come within close proximity of the
windows.
Before using the car wash, check that the fuel filler door on your vehicle is
closed properly.
When using a car wash (vehicles with entry function)
If the door handle becomes wet while the electronic key is within the effective
range, the door may lock and unlock repeatedly. In that case, follow the follow-
ing correction procedures to wash the vehicle:
Place the key in a position 2 m (6 ft.) or more separate from the vehicle while
the vehicle is being washed. (Take care to ensure that the key is not stolen.)
Set the electronic key to battery-saving mode to disable the smart entry & start
system. (P. 150)
Cleaning and protecting the vehicle exterior
Perform the following to protect the vehicle and maintain it in prime con-
dition:

4487-3. Do-it-yourself maintenance
IS300h_EE(OM53B95E)
The meanings of each caution symbol on the top of the 12-volt battery are
as follows:
Before recharging
When recharging, the 12-volt battery produces hydrogen gas which is flammable
and explosive. Therefore, observe the following precautions before recharging:
If recharging with the 12-volt battery installed on the vehicle, be sure to discon-
nect the ground cable.
Make sure the power switch on the charger is off when connecting and discon-
necting the charger cables to the 12-volt battery.
After recharging/reconnecting the 12-volt battery
The hybrid system may not start. Follow the procedure below to initialize the
system.
Shift the shift lever to P.
Open and close any of the doors.
Restart the hybrid system.
Unlocking the doors using the smart entry & start system may not be possible
immediately after reconnecting the 12-volt battery. If this happens, use the
wireless remote control or the mechanical key to lock/unlock the doors.
Start the hybrid system with the power switch in ACCESSORY mode. The
hybrid system may not start with the power switch turned off. However, the
hybrid system will operate normally from the second attempt.
The power switch mode is recorded by the vehicle. If the 12-volt battery is
reconnected, the vehicle will return the power switch mode to the status it was
in before the 12-volt battery was disconnected. Make sure to turn off the power
switch before disconnecting the 12-volt battery. Take extra care when connect-
ing the 12-volt battery if the power switch mode prior to the 12-volt battery
being disconnected is unknown.
If the system will not start even after multiple attempts at all the methods above,
contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
Caution symbols
No smoking, no naked
flames, no sparks12-volt battery acid
Shield eyesNote operating instruc-
tions
Keep away from childrenExplosive gas
1
2
3

4727-3. Do-it-yourself maintenance
IS300h_EE(OM53B95E)
Flathead screwdriver
Small flathead screwdriver
Lithium battery CR2032
Take out the mechanical key.
Remove the cover.
To prevent damage to the key, wrap
the tip of the screwdriver with tape.
Remove the battery cover.
To prevent damage to the key, wrap
the tip of the screwdriver with tape.
Electronic key battery
Replace the battery with a new one if it is depleted.
You will need the following items:
Replacing the battery
1
2
3

4737-3. Do-it-yourself maintenance
7
Maintenance and care
IS300h_EE(OM53B95E)
Remove the depleted battery.
Insert a new battery with the “+” ter-
minal facing up.
Use a CR2032 lithium battery
Batteries can be purchased at any authorized Lexus dealer or repairer, or
another duly qualified and equipped professional, local electrical appliance
shops or camera stores.
Replace only with the same or equivalent type recommended by the manufac-
turer.
Dispose of used batteries according to local laws.
When the card key battery needs to be replaced (if equipped)
The battery for the card key is available only at Lexus dealers. Your Lexus dealer
can replace the battery for you.
If the electronic key battery is depleted
The following symptoms may occur:
The smart entry & start system and wireless remote control will not function
properly.
The operational range will be reduced.
Certification for the key battery
Replace only with the same or equivalent type recommended by the manufac-
turer.
Dispose of used batteries according to local laws.
4

497
8When trouble arises
IS300h_EE(OM53B95E)
8-1. Essential information
Emergency flashers ........... 498
If your vehicle has to be
stopped in an
emergency ....................... 4998-2. Steps to take in an
emergency
If your vehicle needs to
be towed.......................... 500
If you think something
is wrong .......................... 506
If a warning light turns
on or a warning buzzer
sounds ............................. 507
If a warning message is
displayed ......................... 513
If you have a flat tire
(vehicles without
run-flat tires) ................... 530
If you have a flat tire
(vehicles with
run-flat tires) ................... 544
If the hybrid system will
not start ........................... 545
If the shift lever cannot
be shifted from P ............ 547
If the electronic key
does not operate
properly........................... 548
If the 12-volt battery is
discharged ....................... 550
If your vehicle overheats .. 555
If the vehicle becomes
stuck................................ 559

5268-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
Con-
tinu-
ousThe driver’s door was opened
when the shift lever was not in P
and the power switch was not
turned off.
Shift the shift lever to P.
Con-
tinu-
ousCon-
tinu-
ous
The driver’s door was opened
and closed while the electronic
key was not in the vehicle, the
shift lever was not in P and the
power switch was not turned off.
Shift the shift lever to P.
Bring the electronic key back
into the vehicle.
Once
The electronic key is not
detected when an attempt is
made to start the hybrid system.
Start the hybrid system with
the electronic key present.
OnceCon-
tinu-
ous
An attempt was made to exit the
vehicle with the electronic key
and lock the doors without first
turning the power switch off
when the shift lever was in P.
Turn the power switch off and
lock the doors again.
(Flashes)
(Displayed alternately)
(Flashes)
(Flashes)
(Displayed alternately)
(Flashes)