2013 Lexus IS300h warning

5298-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)

Indicates that:
• With the power switch off, the
doors were unlocked and then
the driver’s door was opened
and closed;
• The power switch was turned
to ACCESSORY mode with-
out starting the hybrid system;
or
• The shift lever was shifted to P
from another position with the
power switch in ON mode.
Press the power switch while
depressing the brake pedal.
Once
The power switch has been
turned off with the shift lever in a
position other than P.
Shift the shift lever to P.
Once
After the power switch has been
turned off with the shift lever in a
position other than P, the shift
lever has been shifted to P.
Turn the power switch off.

Power was turned off due to the
automatic power off function.
Next time when starting the
hybrid system, increase the
engine speed slightly and
maintain that level for approx-
imately 5 minutes to recharge
the 12-volt battery.
Con-
tinu-
ous

Indicates that the hybrid system
was stopped in an emergency
while driving
To restart the hybrid system,
shift the shift lever to N and
turn the power switch to ON
mode.
*
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Flashes)

5308-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
*: The hybrid system may not be restarted depending on the vehicle condition.
Warning messages
P. 525
Warning buzzer
P. 512
Once
Indicates that the power switch
has been pressed while driving
Except when emergency stop-
ping of the vehicle is needed,
immediately release the power
switch.
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
(Flashes)

5438-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)
CAUTION
When fixing the flat tire
Stop your vehicle in a safe and flat area.
Do not touch the wheels or the area around the brakes immediately after the
vehicle has been driven.
After the vehicle has been driven, the wheels and the area around the brakes
may be extremely hot. Touching these areas with hands, feet or other body
parts may result in burns.
Connect the valve and hose securely with the tire installed on the vehicle.
If the hose is not properly connected to the valve, air leakage may occur or
sealant may be sprayed out.
If the hose comes off the valve while inflating the tire, there is a risk that the
hose will move abruptly due to air pressure.
After inflation of the tire has completed, the sealant may splatter when the
hose is disconnected or some air is let out of the tire.
Follow the operation procedure to repair the tire. If the procedure is not fol-
lowed, the sealant may spray out.
Keep back from the tire while it is being repaired, as there is a chance of it
bursting while the repair operation is being performed. If you notice any
cracks or deformation of the tire, turn off the compressor switch and stop the
repair operation immediately.
The kit may overheat if operated for a long period of time. Do not operate the
compressor continuously for more than 10 minutes.
Parts of the kit become hot during operation. Be careful handling the kit
during and after operation.
Do not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located,
such as the pad of the steering wheel, it may prevent the SRS air bag from
operating properly.
Driving to spread the liquid sealant evenly
Drive the vehicle carefully at a low speed. Be especially careful when turning
and cornering.
If the vehicle does not drive straight or you feel a pull through the steering
wheel, stop the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel.
• Tire inflation pressure. If tire inflation pressure is 130 kPa (1.3 kgf/cm
2 or
bar, 19 psi) or below, this may indicate severe tire damage.

5448-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
NOTICE
When performing an emergency repair
Perform the emergency repair without removing the nail or screw that has
punctured the tread of the tire. If the object that has punctured the tire is
removed, repair by the emergency tire puncture repair kit may not be possible.
The kit is not waterproof. Make sure that the kit is not exposed to water, such
as when it is being used in the rain.
Do not put the kit directly onto dusty ground such as sand at the side of the
road. If the kit vacuums up dust etc., a malfunction may occur.
Use the kit with the top facing upward. The kit cannot work properly if it is
laid on its side.
Handling the emergency tire puncture repair kit
The compressor power source should be 12 V DC suitable for vehicle use. Do
not connect the compressor to any other source.
If gasoline splatters on the kit, the kit may deteriorate. Take care not to allow
gasoline to contact it.
Store the kit in its assigned place out of reach of children.
Do not disassemble or modify the kit. Do not subject parts such as the air
pressure indicator to impacts. This may cause a malfunction.
To avoid damage to the tire pressure warning valves and transmitters
When a tire is repaired with liquid sealants, the tire pressure warning valve and
transmitter may not operate properly. If a liquid sealant is used, contact any
authorized Lexus dealer or repairer, or another duly qualified and equipped
professional as soon as possible. Make sure to replace the tire pressure warning
valve and transmitter when replacing the tire. (P. 451)

5458-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)
Run-flat tires (A “RFT” or “DSST” mark is molded on the sidewall)
Take your vehicle to the nearest
Lexus dealer or authorized tire
dealer as soon as possible if any
tire goes flat.
The vehicle can be driven for a
maximum of 300 km (186 miles)
at a speed below 60 km/h (37
mph) after the tire pressure warn-
ing light comes on. (P. 510)
In some conditions (such as at high temperatures)
You cannot continue driving for up to 300 km (186 miles).
For the detailed information on run-flat tires
See the tire warranty booklet.
If you have a flat tire (vehicles with run-flat tires)
You can continue driving a vehicle with run-flat tires even if any tire
goes flat.In this case, slow down and drive with extra caution.
NOTICE
When replacing the tires
When removing or fitting the wheels, tires or the tire pressure warning valve
and transmitter, contact any authorized Lexus dealer or repairer, or another
duly qualified and equipped professional as the tire pressure warning valve and
transmitter may be damaged if not handled correctly.
When driving over bumps
If a vehicle has a flat tire, the vehicle height will be lower than usual. Ensure
that nothing strikes the bottom of the vehicle.
To avoid damage to the tire pressure warning valves and transmitters
When a tire is repaired with liquid sealants, the tire pressure warning valve and
transmitter may not operate properly. If a liquid sealant is used, contact any
authorized Lexus dealer or repairer, or another duly qualified and equipped
professional or other qualified service shop as soon as possible. Make sure to
replace the tire pressure warning valve and transmitter when replacing the tire.
(P. 451)

579
9 9-2. Customization
Vehicle specifications
IS300h_EE(OM53B95E)
Door lock (P. 136, 143, 549)
Smart entry & start system and wireless remote control (P. 136, 143)
FunctionDefault set-
tingCustomized set-
ting
Unlocking using a
mechanical keyAll doors
unlocked in
one stepDriver's door
unlocked in one
step, all doors
unlocked in two
steps
———O
Speed-detecting auto-
matic door lock functionOnOffO—OO
Shifting gears to position
other than P locks all
doors
OffOnO—OO
Shifting gears to P
unlocks all doorsOffOnO—OO
Opening driver's door
unlocks all doorsOnOffO—OO
Locking/unlocking of the
trunk when all doors are
locked/unlockedOnOff———O
1234
FunctionDefault set-
tingCustomized set-
ting
Operation signal
(Emergency flashers)OnOffO—OO
Time elapsed before auto-
matic door lock function
is activated if door is not
opened after being
unlocked
30 seconds
60 seconds
O—OO120 seconds
Open door warning
buzzerOnOff———O
1234

585
IS300h_EE(OM53B95E)
9
Vehicle specifications
9-3. Items to initialize
Items to initialize
The following item must be initialized for normal system operation after
such cases as the 12-volt battery being reconnected, or maintenance
being performed on the vehicle:
ItemWhen to initializeReference
Tire pressure warning system
• When rotating the tires
• When changing the tire infla-
tion pressure by changing
traveling speed or load
weight, etc.
P. 452

590What to do if... (Troubleshooting)
IS300h_EE(OM53B95E)
Is the window lock switch pressed?
The power window except for the one at the driver’s seat cannot be
operated if the window lock switch is pressed. (P. 184)
The auto power off function will be operated if the vehicle is left in
ACCESSORY or ON mode (the hybrid system is not operating) for a
period of time. (P. 211)
The seat belt reminder light is flashing
Are the driver and the front passenger wearing the seat belts? (P.
509)
The parking brake indicator is on
Is the parking brake released? (P. 224)
Depending on the situation, other types of warning buzzer may also
sound.
(P. 507, 514)

Did anyone inside the vehicle open a door or anything move inside the
vehicle during setting the alarm?
The sensor detects them and the alarm sounds. (P. 9 6 )
To stop the alarm, turn the power switch to ON mode or start the hybrid
system.The windows do not open or close by operating the power window
switches
The power switch is turned off automatically
A warning buzzer sounds during driving
An alarm is activated and the horn sounds (if equipped)