675
GS350_U (OM30C34U)
When trouble arises7
7-1. Essential information Emergency flashers....................676
If your vehicle has to be stopped in an emergency .... 677 7-2. Steps to take in an emergency
If your vehicle needs to be towed ................................ 678
If you think something is wrong ................684
Fuel pump shut off system ......685
If a warning light turns on or a warning buzzer sounds .....686
If a warning message is displayed .................................697
If you have a flat tire................... 722
If the engine will not start ........ 735
If the shift lever cannot be shifted from P ......................737
If the parking brake cannot be released ................................ 738
If the electronic key does not operate properly ......................740
If the vehicle battery is discharged ..............................743
If your vehicle overheats .......... 747
If the vehicle becomes stuck .............................................. 749
678
GS350_U (OM30C34U)
7-2. Steps to take in an emergency
If your vehicle needs to be towed
The following may indicate a problem with your transmission. Contact
your Lexus dealer before towing.
●The engine is running but the vehicle will not move.
●The vehicle makes an abnormal sound.
If a tow truck is not available in an
emergency, your vehicle may be
temporarily towed using a cable or
chain secured to the emergency
towing eyelet. This should only be
attempted on hard surfaced roads
for short distances at low speeds.
A driver must be in the vehicle to
steer and operate the brakes. The
vehicle’s wheels, drive train, axles,
steering and brakes must be in good
condition.
If towing is necessary, we recommend having your vehicle towed by
your Lexus dealer or a commercial towing service, using a lift-type
truck or flat bed truck.
Use a safety chain system for all towing, and abide by all state/provin-
cial and local laws.
Before towing
Emergency towing
6797-2. Steps to take in an emergency
GS350_U (OM30C34U)
7
When trouble arises
Take out the towing eyelet (→P. 7 2 3 )
Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehi-
cle body as shown in the illustration.
Insert the towing eyelet into the
hole and tighten partially by hand.
Tighten down the towing eyelet
securely using a wheel nut
wrench.
Installing towing eyelet
1
2
3
4