2013 JEEP WRANGLER UNLIMITED adding oil

• Check Gascap (refer to “Adding Fuel” in “Starting
And Operating” for more details)
• Oil Change Required (with a single chime)
• ECO (Fuel Saver Indicator) — if equipped
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The “Oil Change Required” message
will flash in the EVIC display for approximately 10 sec-
onds after a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style. Unless reset, this message will continue to display each
time you turn the ignition switch to the ON position. To
turn off the message temporarily, press and release the
MENU button. To reset the oil change indicator system
(after performing the scheduled maintenance), perform
the following procedure:
1. Turn the ignition switch to the ON position. Do not
start the engine .
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
4 UNDERSTANDING YOUR INSTRUMENT PANEL 325

MAINTAINING YOUR VEHICLECONTENTS  ENGINE COMPARTMENT — 3.6L ......... .561
 ONBOARD DIAGNOSTIC SYSTEM — OBD II . .562
▫ Loose Fuel Filler Cap Message ........... .562
 EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS ......................... .563
 REPLACEMENT PARTS ................. .564
 DEALER SERVICE ..................... .564
 MAINTENANCE PROCEDURES .......... .565
▫ Engine Oil ......................... .566
▫ Engine Oil Filter ..................... .569 ▫ Engine Air Cleaner Filter ............... .569
▫ Maintenance-Free Battery .............. .570
▫ Air Conditioner Maintenance ............ .571
▫ Body Lubrication .................... .572
▫ Windshield Wiper Blades .............. .573
▫ Adding Washer Fluid ................. .574
▫ Exhaust System ..................... .574
▫ Cooling System ..................... .577
▫ Brake System ....................... .583
▫ Automatic Transmission – If Equipped ..... .585
7

CAUTION! (Continued)• Your vehicle has been built with improved fluids
that protect the performance and durability of your
vehicle and also allow extended maintenance inter-
vals. Do not use chemical flushes in these compo-
nents as the chemicals can damage your engine,
transmission, power steering or air conditioning.
Such damage is not covered by the New Vehicle
Limited Warranty. If a flush is needed because of
component malfunction, use only the specified
fluid for the flushing procedure. Engine Oil
Checking Oil Level
To assure proper lubrication of your vehicle’s engine, the
engine oil must be maintained at the correct level. The
engine oil level should be checked five minutes after a
warmed up engine has been shut off.
Checking the oil while the vehicle is on level ground will
improve the accuracy of the oil level readings. Always
maintain the oil level within the SAFE zone on the
dipstick. Adding 1 U.S. Quart (0.95L) of oil when the
reading is at the bottom of the SAFE zone will result in a
reading at the top of the safe zone on these engines.566 MAINTAINING YOUR VEHICLE

WARNING!• Use only refrigerants and compressor lubricants
approved by the manufacturer for your air condi-
tioning system. Some unapproved refrigerants are
flammable and can explode, injuring you. Other
unapproved refrigerants or lubricants can cause the
system to fail, requiring costly repairs. Refer to
Warranty Information Book, located on the DVD,
for further warranty information.
• The air conditioning system contains refrigerant
under high pressure. To avoid risk of personal
injury or damage to the system, adding refrigerant
or any repair requiring lines to be disconnected
should be done by an experienced technician. Refrigerant Recovery And Recycling
R-134a Air Conditioning Refrigerant is a hydrofluoro-
carbon (HFC) that is endorsed by the Environmental
Protection Agency and is an ozone-saving product. How-
ever, the manufacturer recommends that air conditioning
service be performed by authorized dealer or other
service facilities using recovery and recycling equipment.
NOTE: Use only manufacturer approved A/C system
sealers, stop leak products, seal conditioners, compressor
oil, and refrigerants.
Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, sliding doors and hood hinges, should be lubri-
cated periodically with a lithium based grease, such as572 MAINTAINING YOUR VEHICLE

4. Place the shift lever momentarily into each gear posi-
tion (allowing time for the transmission to fully en-
gage in each position), ending with the shift lever in
PARK.
5. Remove the dipstick, wipe it clean and reinsert it until
seated.
6. Remove the dipstick again and note the fluid level on
both sides. The fluid level reading is only valid if there
is a solid coating of oil on both sides of the dipstick.
The fluid level should be between the HOT (upper)
reference holes on the dipstick at normal operating
temperature. If the fluid level is low, add fluid through
the dipstick tube to bring it to the proper level. Do not
overfill. After adding any quantity of oil through the
dipstick tube, wait a minimum of two minutes for the
oil to fully drain into the transmission before recheck-
ing the fluid level. NOTE:
• The holes in the dipstick will be full of fluid if the
actual level is at or above the hole.
• If it is necessary to check the transmission below the
operating temperature, the fluid level should be be-
tween the two COLD (lower) holes on the dipstick with
the fluid at approximately 80° F (27° C). If the fluid level
is correctly established at 80° F (27° C), it should be
between the HOT (upper) reference holes when the
transmission reaches 180° F (82° C). Remember it is best
to check the level at the normal operating temperature.
CAUTION!Be aware that if the fluid temperature is below 50° F
(10° C), it may not register on the dipstick. Do not add
fluid until the temperature is elevated enough to
produce an accurate reading.
7 MAINTAINING YOUR VEHICLE 587

Adding Fluid
Fluid should be added only at filler hole until fluid
begins to run out of the hole.
Drain
First remove the fill plug (B), then the drain plug (C). The
recommended tightening torque for the drain and fill
plugs is 15 to 25 ft lbs (20 to 34 N·m).
CAUTION!When replacing the plugs, do not overtighten them.
You could damage them and cause them to leak.
Selection Of Lubricant
Use only manufacturer’s recommended fluid. Refer to
“Fluids, Lubricants, and Genuine Parts” in “Maintaining
Your Vehicle” for further information. Front/Rear Axle Fluid
For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons
the exterior surfaces of the axle assembly should be
inspected. If gear oil leakage is suspected inspect the
fluid level. Refer to “Fluids, Lubricants, and Genuine
Parts” in “Maintaining Your Vehicle” for further informa-
tion.
Fluid Level Check
Lubricant should be at the bottom edge of the oil fill hole.
Adding Fluid
Add lubricant only at the fill hole and only to the level
specified above.590 MAINTAINING YOUR VEHICLE

ABS (Anti-Lock Brake System) ............... .303
Adding Engine Coolant (Antifreeze) ........... .579
Adding Fuel ............................ .510
Additives, Fuel .......................... .509
Airbag ..................................62
Airbag Deployment ........................71
Airbag Light .............................74
Airbag Maintenance ........................73
Airbag, Side ..............................70
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .569
Air Conditioner Maintenance ................ .571
Air Conditioning ......................... .392
Air Conditioning Controls .................. .392
Air Conditioning Filter .................... .402
Air Conditioning, Operating Tips ............. .403
Air Conditioning Refrigerant ................ .571
Air Conditioning System ................... .392
Air Pressure, Tires ........................ .483
Alarm Light ............................ .305 Alarm (Security Alarm) ......................19
Alterations/Modifications, Vehicle ...............9
Antenna, Satellite Radio .................... .352
Antifreeze (Engine Coolant) ................. .578
Disposal ............................ .581
Anti-Lock Brake System (ABS) ............... .455
Anti-Lock Warning Light ................... .303
Appearance Care ........................ .591
Arming Theft System (Security Alarm) ...........20
Assistance Towing ........................ .130
Auto Down Power Windows ..................42
Automatic Door Locks ......................39
Automatic Headlights ..................... .168
Automatic Oil Change Indicator .............. .325
Automatic Temperature Control (ATC) ......... .396
Automatic Transmission ................... .420
Adding Fluid ........................ .588
Fluid and Filter Changes ................ .588
Fluid Change ........................ .588634 INDEX

Filters
Air Cleaner .......................... .569
Air Conditioning ...................... .402
Engine Oil ........................... .569
Engine Oil Disposal .................... .568
Flashers
Hazard Warning ...................... .538
Turn Signal .......................... .103
Flash-To-Pass ........................... .170
Flooded Engine Starting .....................411
Fluid Capacities ......................... .610
Fluid Leaks ............................ .103
Fluid Level Checks ....................... .590
Engine Oil ........................... .566
Manual Transmission ................... .589
Power Steering ....................... .451
Fluids, Lubricants and Genuine Parts ...........611
Fog Lights ............................. .170
Fog Light Service ........................ .608 Fold and Tumble Rear Seat ................. .161
Folding Rear Seat ........................ .164
Folding Windshield ....................... .286
Four-Way Hazard Flasher .................. .538
Four Wheel Drive ........................ .428
Four Wheel Drive Operation ................ .428
Freeing A Stuck Vehicle .................... .552
Front Axle (Differential) .................... .590
Fuel .................................. .506
Adding ............................. .510
Additives ........................... .509
Clean Air ........................... .507
Ethanol ............................. .507
Filler Cap (Gas Cap) ................... .510
Gasoline ............................ .506
Gauge .............................. .300
Materials Added ...................... .509
Methanol ........................... .507
Octane Rating ........................ .506
10 INDEX 639