2013 JEEP WRANGLER battery

CAUTION!
•When installing the Integrated Power Module
cover, it is important to ensure the cover is properly
positioned and fully latched. Failure to do so may
allow water to get into the Integrated Power Mod-
ule, and possibly result in an electrical system
failure.
• When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
VEHICLE STORAGE
If you are leaving your vehicle dormant for more than
21 days, you may want to take steps to protect your
battery. You may:
• Remove Cartridge fuse #J13 in the Power Distribution
Center (PDC) labeled Ignition-Off Draw (IOD) and
store it in a safe location within the PDC.
• Or, disconnect the negative cable from the battery.
• Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
7
MAINTAINING YOUR VEHICLE 613

NOTE:Under no circumstances should oil change inter-
vals exceed 10,000 miles (16,000 km) or twelve months,
whichever comes first.
Once A Month Or Before A Long Trip:
• Check engine oil level
• Check windshield washer fluid level
• Check the tire inflation pressures and look for unusual
wear or damage
• Check the fluid levels of the coolant reservoir, brake
master cylinder, power steering and transmission as
needed
• Check function of all interior and exterior lights
Required Maintenance Intervals.
Refer to the maintenance schedules on the following
page for the required maintenance intervals.At Every Oil Change Interval As Indicated By Oil Change Indicator System:
•Change oil and filter
• Rotate the tires. Rotate at the first sign of irregu-
lar wear, even if it occurs before the oil indicator
system turns on.
• Inspect battery and clean and tighten terminals as
required
• Inspect automatic transmission fluid if equipped
with dipstick
• Inspect brake pads, shoes, rotors, drums, hoses
and park brake
•
Inspect engine cooling system protection and hoses
• Inspect exhaust system
• Inspect engine air cleaner if using in dusty or
off-road conditions
• Inspect all door latches for presence of grease,
reapply if necessary.
8
M
A I
N T
E
N
A
N
C E
S
C
H E
D
U L
E
SMAINTENANCE SCHEDULES 623

Automatic Transmission....................424
Adding Fluid ......................... .597
Fluid and Filter Changes ..................597
Fluid Change ......................... .597
Fluid Level Check ...................... .595
Fluid Type ........................... .594
Special Additives ...................... .595
Autostick .............................. .431
Auxiliary Electrical Outlet (Power Outlet) ........184
Auxiliary Power Outlet .....................184
Axle Lock .............................. .438
Battery ................................ .577
Keyless Transmitter Replacement (RKE) ........28
Belts, Seat ...............................50
Body Mechanism Lubrication .................582
Brake Assist System ...................... .462
Brake Control System, Electronic ..............460Brake System
........................... .592
Anti-Lock (ABS) ....................... .459
Master Cylinder ....................... .593
Parking ............................. .456
Warning Light ........................ .306
Brake/Transmission Interlock .................424
Break-In Recommendations, New Vehicle .........99
Bulb Replacement ........................ .614
Bulbs, Light ............................ .103
Calibration, Compass ..................... .322
Capacities, Fluid ......................... .618
Caps, Filler Fuel ................................ .517
Power Steering ........................ .456
Radiator (Coolant Pressure) ................589
Carbon Monoxide Warning ..................100
Cargo Light ............................ .174
Car Washes ............................ .601
10
INDEX 645

Hazard Warning Flasher..................546
Headlights ........................... .169
Headlight Switch ...................... .169
High Beam ........................... .305
High Beam Indicator .....................305
Hill Descent Control Indicator ..............474
Illuminated Entry ........................23
Instrument Cluster ..................... .169
Interior ............................. .173
Lights On Reminder .....................171
Low Fuel ............................ .304
Oil Pressure .......................... .305
Passing ............................. .172
Rear Servicing ........................ .617
Rear Tail ............................ .617
Seat Belt Reminder ..................... .305
Security Alarm (Theft Alarm) ...............309
Service .............................. .615
Side Marker .......................... .617Theft Alarm (Security Alarm)
...............309
Tire Pressure Monitoring (TPMS) ............310
Traction Control ....................... .472
Turn Signal .......................... .103
Voltage ............................. .304
Warning (Instrument Cluster Description) ......304
Loading Vehicle ......................... .519
Tires ............................... .482
Locking Axle ........................... .438
Locks ..................................38
Automatic Door .........................41
Child Protection .........................42
Door .................................38
Power Door ............................40
Steering Wheel ..........................17
Lubrication, Body ........................ .582
Maintenance Free Battery ....................577
Maintenance Procedures ....................573
10
INDEX 653

Safety.............................. .476
Sizes ............................... .477
Snow Tires ........................... .492
Spare Tire ............................ .549
Spinning ............................ .495
Tread Wear Indicators ....................496
Tire Safety Information .....................476
Tongue Weight/Trailer Weight ................532
To Open Hood .......................... .167
Tow Hooks, Emergency .....................561
Towing ............................... .522
24-Hour Towing Assistance ................130
Disabled Vehicle ....................... .563
Guide .............................. .526
Recreational .......................... .540
Weight .............................. .526
Towing Assistance ........................ .130
Trac-Lok Rear Axle ....................... .437
Traction Control ......................... .461Trailer Sway Control (TSC)
..................473
Trailer Towing .......................... .522
Cooling System Tips .....................539
Hitches ............................. .525
Minimum Requirements ..................533
Trailer and Tongue Weight .................532
Wiring .............................. .537
Trailer Towing Guide ...................... .526
Trailer Weight ........................... .526
Transfer Case ........................... .598
Four-Wheel-Drive Operation ...............433
Maintenance .......................... .598
Transmission ........................... .594
Automatic ........................... .424
Manual ............................. .418
Range

Indicator ....................... .310
Shifting ............................. .422
Transmitter Battery Service (Remote Keyless Entry) . .28
Tread Wear Indicators ..................... .496
660 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible. The
negative power connection should be made to body sheet
metal adjacent to the negative battery connection. This
connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use only
fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to ensure
a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interference
between the communications equipment and the vehicle’s
electronic systems.