Trip Computer.......................... .226
Trip Odometer .......................... .221
Trip Odometer Reset Button ..................219
Turn Signals ............................ .164
UCI Connector .......................... .286
Uconnect (Hands-Free Phone) ................111
Understanding Your Instrument Panel ...........210
Uniform Tire Quality Grades .................501
Universal Consumer Interface (UCI) Connector . . . .286
Universal Transmitter ..................... .176
Unleaded Gasoline ....................... .389
Untwisting Procedure, Seat Belt ................52
Vanity Mirrors ...........................110
Variance, Compass ....................... .237
Vehicle Certification Label ...................396
Vehicle Identification Number (VIN) .............7Vehicle Loading
......................... .364
Vehicle Modifications/Alterations ...............8
Vehicle Storage .......................... .306
Vehicle Theft Alarm (Security Alarm) ............18
Voice Recognition System (VR) ................141
Warning Lights (Instrument Cluster Description) . . .212
Warning, Roll Over .........................4
Warnings and Cautions .......................7
Warranty Information ..................... .498
Washer Adding Fluid ........................ .453
Washers, Windshield ...................... .170
Washing Vehicle ......................... .469
Wheel and Wheel Trim .....................470
Wheel and Wheel Trim Care .................470
Wind Buffeting .......................... .187
Window Fogging ........................ .307
Windows ................................35
520 INDEX
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible. The
negative power connection should be made to body sheet
metal adjacent to the negative battery connection. This
connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use only
fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to ensure
a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interference
between the communications equipment and the vehicle’s
electronic systems.
