2013 JEEP PATRIOT fuse

Cavity Car-tridgeFuse Mini-
Fuse Description
20 15 Amp
Lt Blue Radio
21 10 Amp
Red Intrusion Module/
Siren – If Equipped
22 10 Amp
Red Heating, AC/Compass
23 15 Amp
Lt Blue Auto Shutdown Relay
24 15 Amp
Lt Blue Power Sunroof –
If Equipped
25 10 Amp
Red Heated Mirror –
If Equipped
26 15 Amp
Lt Blue Auto Shutdown RelayCavity Car-
tridgeFuse Mini-
Fuse Description
27 10 Amp
Red Airbag Control
Module
28 10 Amp
Red Airbag Control
Module/Occupant
Classification Module
29 Hot Car (No Fuse
Required)
30 20 Amp
Yellow Heated Seat –
If Equipped
31 10 Amp
Red Headlamp Washer –
If Equipped
32 30 Amp Pink Auto Shutdown Relay
476 MAINTAINING YOUR VEHICLE

Cavity Car-tridgeFuse Mini-
Fuse Description
33 10 Amp
Red J1962 Conn/
Powertrain Control Module
34 30 Amp Pink Antilock BrakeValve
35 40 Amp Green Antilock Brake Pump
36 30 Amp Pink Headlamp/Washer
Control/Smart Glass – If Equipped
37 25 Amp
Natural Diesel Fuel Heater –
If EquippedCAUTION!
•When installing the IPM cover, it is important to
ensure the cover is properly positioned and fully
latched. Failure to do so may allow water to get into
the IPM, and possibly result in an electrical system
failure.
• When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
7
MAINTAINING YOUR VEHICLE 477

VEHICLE STORAGE
If you will not be using your vehicle for more than
21 days, you may want to take steps to preserve your
battery.
•Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
• Or disconnect the negative cable from the battery.
• Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
Interior Bulbs
Bulb Number
Front Header Lamp T578
Center Dome Lamp T578
Rear Cargo Lamp/
Flashlight 8–A35LF
478 MAINTAINING YOUR VEHICLE

Flashers............................... .414
Hazard Warning ...................... .414
Turn Signal .......................... .100
Flooded Engine Starting ....................315
Fluid, Brake ............................ .483
Fluid Capacities ......................... .481
Fluid Leaks ............................ .101
Fluid Level Checks Automatic Transmission ..................466
Cooling System ....................... .457
Power Steering ....................... .339
Fluids, Lubricants and Genuine Parts ...........482
Fog Lights ............................. .164
Folding Rear Seat ........................ .158
Folding Rear Seat (Sedan) ...................158
Four Wheel Drive ........................ .329
Systems ............................ .329
Four Wheel Drive Operation .................329
Freeing A Stuck Vehicle .....................431 Fuel
.................................. .389
Adding ............................. .394
Additives ........................... .392
Capacity ............................ .481
Clean Air ........................... .390
Ethanol ............................. .390
Filler Cap (Gas Cap) ....................394
Gasoline ............................ .389
Gauge .............................. .212
Light .............................. .213
Materials Added ...................... .392
Methanol ........................... .390
Octane Rating ........................ .389
Requirements ........................ .389
Tank Capacity ........................ .481
Fueling ............................... .394
Fuel

System Caution ...................... .395
Fuses ................................. .473
10
INDEX 509

Ignition.................................12
Key .................................12
Ignition Key Removal .......................12
Immobilizer (Sentry Key) ....................15
Infant Restraint ...........................75
Information Center, Vehicle ..................228
Inside Rearview Mirror .....................107
Instrument Cluster ....................... .212
Instrument Panel and Controls ................210
Instrument Panel Cover .....................472
Instrument Panel Lens Cleaning ...............473
Integrated Power Module (Fuses) ..............473
Interior Appearance Care ....................471
Intermittent Wipers (Delay Wipers) .............170
Introduction ..............................4
Jacking Instructions ....................... .418
Jack Location ........................... .416
Jack Operation .......................... .415Jump Starting
........................... .427
Key-In Reminder ..........................14
Keyless Entry System (Sedan) .................20
Key, Programming .........................17
Key, Replacement ..........................16
Keys ...................................12
Key, Sentry (Immobilizer) ....................15
Knee Bolster ..............................61
Lane Change and Turn Signals ................480
Lane Change Assist ....................... .165
Lap/Shoulder Belts .........................43
Latches ............................... .101
Hood .............................. .160
Lead Free Gasoline ....................... .389
Leaks, Fluid ............................ .101
Life of Tires ............................ .376
Liftgate (Sedan) ...........................38
10
INDEX 511

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained personnel.
The following must be observed during installation.
The positive power connection should be made directly to
the battery and fused as close to the battery as possible. The
negative power connection should be made to body sheet
metal adjacent to the negative battery connection. This
connection should not be fused.
Antennas for two-way radios should be mounted on the roof
or the rear area of the vehicle. Care should be used in
mounting antennas with magnet bases. Magnets may affect
the accuracy or operation of the compass on vehicles so
equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use only
fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to ensure
a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interference
between the communications equipment and the vehicle’s
electronic systems.