2013 JEEP GRAND CHEROKEE windshield wipers

▫Easy Entry/Exit Seat ...................198
 TO OPEN AND CLOSE THE HOOD .........199
 LIGHTS ............................ .201
▫ Headlight Switch .....................201
▫ Automatic Headlights — If Equipped .......202
▫ Headlights On Automatically With Wipers . . .202
▫ SmartBeam™ — If Equipped .............203
▫ Daytime Running Lights — If Equipped .....204
▫ Automatic Headlight Leveling — HID
Headlights Only ..................... .205
▫ Headlight Delay ..................... .205
▫ Parking Lights And Panel Lights ...........205
▫ Fog Lights — If Equipped ...............206 ▫
Interior Lights ....................... .206
▫ Lights-On Reminder ...................207
▫ Battery Saver ........................ .208
▫ Front Map/Reading Lights ..............208
▫ Courtesy Lights ...................... .268
▫ Ambient Light ....................... .210
▫ Multifunction Lever ....................210
▫ Turn Signals .........................211
▫ Lane Change Assist ....................211
▫ Flash-To-Pass ........................211
▫ High/Low Beam Switch .................211
 WINDSHIELD WIPERS AND WASHERS ......212
▫ Windshield Wiper Operation .............213
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 119

▫Intermittent Wiper System ...............214
▫ Windshield Washer Operation .............215
▫ Mist .............................. .216
▫ Rain Sensing Wipers — If Equipped ........216
 TILT/TELESCOPING STEERING COLUMN . . .218
 POWER TILT/TELESCOPING STEERING
COLUMN — IF EQUIPPED ...............219

HEATED STEERING WHEEL — IF EQUIPPED . . .220
 ELECTRONIC SPEED CONTROL ...........221
▫ To Activate ......................... .222
▫ To Set A Desired Speed .................223
▫ To Deactivate ....................... .223
▫ To Resume Speed .....................223 ▫
To Vary The Speed Setting ...............223
▫ To Accelerate For Passing ................224
 ADAPTIVE CRUISE CONTROL (ACC) — IF
EQUIPPED .......................... .225
▫ Adaptive Cruise Control (ACC) Operation . . . .228
▫ Activating Adaptive Cruise Control (ACC) . . . .229
▫ To Activate ......................... .230
▫ To Set A Desired ACC Speed .............231
▫ To Cancel .......................... .232
▫ ToTurnOff......................... .233
▫ To Resume Speed .....................233
▫ To Vary The Speed Setting ...............234
▫ Setting The Following Distance In ACC ......235
120 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Information Center (EVIC)/Customer-Programmable
Features” in “Understanding Your Instrument Panel” for
further information.
If your vehicle is equipped with a “Rain Sensitive Wiper
System” and it is activated, the headlights will automati-
cally turn on after the wipers complete five wipe cycles
within approximately one minute, and they will turn off
approximately four minutes after the wipers completely
stop. Refer to “Windshield Wipers And Washers” in this
section for further information.
NOTE:When your headlights come on during the day-
time, the instrument panel lights will automatically dim
to the lower nighttime intensity. Refer to “Lights” in this
section for further information.SmartBeam™ — If Equipped
The SmartBeam™ system provides increased forward
lighting at night by automating high beam control
through the use of a digital camera mounted on the
inside rearview mirror. This camera detects vehicle spe-
cific light and automatically switches from high beams to
low beams until the approaching vehicle is out of view.
NOTE:
• If the windshield or SmartBeam™ mirror is replaced,
the SmartBeam™ mirror must be re-aimed to ensure
proper performance. See your local authorized dealer.
• Broken, muddy, or obstructed headlights and taillights
of vehicles in the field of view will cause headlights to
remain on longer (closer to the vehicle). Also, dirt, film,
and other obstructions (sticker, toll box, etc.) on the
windshield or camera lens will cause the system to
function improperly.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 203

WINDSHIELD WIPERS AND WASHERS
The windshield wiper/washer controls are located on the
multifunction lever on the left side of the steering col-
umn. The front wipers are operated by rotating a switch,
located on the end of the lever. For information on the
rear wiper/washer, refer to “Rear Window Features” in
“Understanding The Features Of Your Vehicle”.
Multifunction Lever
212 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Windshield Washer Operation
To use the washer, push on the end of the lever (toward
the steering wheel) and hold while spray is desired. If the
lever is pushed while in the intermittent setting, the
wipers will turn on and operate for several wipe cycles
after the end of the lever is released, and then resume the
intermittent interval previously selected.If the end of the lever is pushed while the wipers are in
the off position, the wipers will operate for several wipe
cycles, then turn off.
Windshield Washer Operation
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 215

WARNING!
Sudden loss of visibility through the windshield
could lead to a collision. You might not see other
vehicles or other obstacles. To avoid sudden icing of
the windshield during freezing weather, warm the
windshield with the defroster before and during
windshield washer use.
Mist
Use the Mist feature when weather conditions make
occasional usage of the wipers necessary. Rotate the end
of the lever downward to the Mist position and release
for a single wiping cycle.
NOTE:The mist feature does not activate the washer
pump; therefore, no washer fluid will be sprayed on the
windshield. The wash function must be used in order to
spray the windshield with washer fluid.
Rain Sensing Wipers — If Equipped
This feature senses moisture on the windshield and
automatically activates the wipers for the driver. The
feature is especially useful for road splash or overspray
Mist Control
216 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Wiper Mode — If Equipped
When this feature is selected, the system will automati-
cally activate the windshield wipers if it senses moisture
on the windshield. To make your selection, press and
release the SELECT button until a check-mark appears
next to the feature showing the system has been activated
or the check-mark is removed showing the system has
been deactivated. When this feature is deactivated, the
system reverts to the standard intermittent wiper opera-
tion.
Hill Start Assist (HSA)
When this feature is selected, the HSA system is active.
Refer to “Electronic Brake Control System” in “Starting
And Operating” for system function and operating infor-
mation. To make your selection, press and release the
SELECT button until a check-mark appears next to thefeature showing the system has been activated or the
check-mark is removed showing the system has been
deactivated.
Blind Spot Alert
There are three selections when operating Blind Spot
Alert. By pressing and releasing the SELECT button once,
the Blind Spot Alert feature can be activated in “Blind
Spot: Lights Only” mode. When this mode is selected the
Blind Spot Monitor (BSM) system is activated and will
only show a visual alert in the outside mirrors. By
pressing and releasing the SELECT button a second time
“Blind Spot: Lights/CHM” mode is activated. In this
mode the Blind Spot Monitor (BSM) will show a visual
alert in the outside mirrors as well as an audible alert
when the turn signal is on. When “Blind Spot: Off” is
selected the Blind Spot Monitor (BSM) system is deacti-
vated.
360 UNDERSTANDING YOUR INSTRUMENT PANEL

Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc.
NOTE:Life expectancy of wiper blades varies depend-
ing on geographical area and frequency of use. Poor
performance of blades may be present with chattering,
marks, water lines or wet spots. If any of these conditions
are present, clean the wiper blades or replace as neces-
sary.
Rear Wiper Blade Removal/Installation
1. Lift the pivot cap on the rear wiper arm upward, this will allow the rear wiper blade to be raised off of the
liftgate glass. NOTE:
The rear wiper arm cannot be raised fully up-
ward unless the pivot cap is raised first.
2. Lift the rear wiper arm upward to raise the wiper blade off of the liftgate glass.
1 — Wiper Arm
2 — Pivot Cap7
MAINTAINING YOUR VEHICLE 573