2013 JEEP GRAND CHEROKEE battery replacement

▫Using The Panic Alarm..................26
▫Programming Additional Transmitters........27
▫Transmitter Battery Replacement...........27
▫General Information....................29
REMOTE STARTING SYSTEM —
IF EQUIPPED..........................29
▫How To Use Remote Start................30
DOOR LOCKS.........................34
▫Power Door Locks.....................35
▫Child-Protection Door Lock System — Rear
Doors...............................36
KEYLESS ENTER-N-GO™.................38
WINDOWS...........................42
▫Power Windows.......................42▫Wind Buffeting.......................46
LIFTGATE............................46
▫Liftgate Flipper Glass...................47
▫Power Liftgate — If Equipped.............48
OCCUPANT RESTRAINTS................51
▫Lap/Shoulder Belts....................55
▫Lap/Shoulder Belt Operating Instructions.....56
▫Lap/Shoulder Belt Untwisting Procedure.....59
▫Adjustable Upper Shoulder Belt Anchorage . . .60
▫Seat Belts In Passenger Seating Positions......61
▫Automatic Locking Retractor Mode (ALR) — If
Equipped............................61
▫Energy Management Feature..............63
12 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

NOTE:The interior lights will turn off if you turn the
ignition switch to the ACC or ON/RUN position while
the Panic Alarm is activated. However, the exterior lamps
and horn will remain on.
Programming Additional Transmitters
Programming Key Fobs or RKE transmitters may be
performed at an authorized dealer.
Transmitter Battery Replacement
The recommended replacement battery is one CR2032
battery.
NOTE:
•Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
•Do not touch the battery terminals that are on the back
housing or the printed circuit board.1. Remove the emergency key by sliding the mechanical
latch at the top of the RKE transmitter sideways with
your thumb and then pull the key out with your other
hand.
Emergency Key Removal
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 27

MAINTAINING YOUR VEHICLE
CONTENTS
ENGINE COMPARTMENT — 3.6L..........607
ENGINE COMPARTMENT — 5.7L..........608
ONBOARD DIAGNOSTIC SYSTEM (OBD II) . . .609
▫Loose Fuel Filler Cap Message............609
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS..........................610
REPLACEMENT PARTS..................611
DEALER SERVICE......................612
MAINTENANCE PROCEDURES...........612
▫Engine Oil..........................613▫Engine Oil Filter......................616
▫Engine Air Cleaner Filter................616
▫Maintenance-Free Battery...............617
▫Air Conditioner Maintenance.............618
▫Body Lubrication.....................621
▫Windshield Wiper Blades...............621
▫Adding Washer Fluid..................623
▫Exhaust System......................624
▫Cooling System......................627
▫Brake System........................632
7

4. Approximately 15 seconds later, one of two things will
happen:
•The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system isnot readyand you should
notproceed to the I/M station.
•The MIL will not flash at all and will remain fully
illuminated until you turn OFF the ignition or start the
engine. This means that your vehicle’s OBD II system
isreadyand you can proceed to the I/M station.
If your OBD II system isnot ready,you should see your
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the above test routine
may then indicate that the system is now ready.Regardless of whether your vehicle’s OBD II system is
ready or not, if the MIL is illuminated during normal
vehicle operation you should have your vehicle serviced
before going to the I/M station. The I/M station can fail
your vehicle because the MIL is on with the engine
running.
REPLACEMENT PARTS
Use of genuine MOPAR® parts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-MOPAR® parts for mainte-
nance and repairs will not be covered by the manufac-
turer’s warranty.
7
MAINTAINING YOUR VEHICLE 611

Engine Air Cleaner Filter Selection
The quality of replacement engine air cleaner filters
varies considerably. Only high quality filters should be
used to assure most efficient service. MOPAR® engine air
cleaner filters are a high quality filter and are recom-
mended.
Maintenance-Free Battery
Your vehicle is equipped with a maintenance-free battery.
You will never have to add water, nor is periodic main-
tenance required.
WARNING!
•Battery fluid is a corrosive acid solution and can
burn or even blind you. Do not allow battery fluid
to contact your eyes, skin, or clothing. Do not lean
over a battery when attaching clamps. If acid
splashes in eyes or on skin, flush the area imme-
diately with large amounts of water. Refer to
“Jump-Starting Procedures” in “What To Do In
Emergencies” for further information.
•Battery gas is flammable and explosive. Keep
flame or sparks away from the battery. Do not use
a booster battery or any other booster source with
an output greater than 12 Volts. Do not allow cable
clamps to touch each other.
•Battery posts, terminals, and related accessories
contain lead and lead compounds. Wash hands
after handling.
7
MAINTAINING YOUR VEHICLE 617

VEHICLE STORAGE
If you are leaving your vehicle dormant for more than 21
days you may want to take steps to protect your battery.
You may:
•Remove fuse #J13 in the Totally Integrated Power
Module (TIPM) labeled Main Ignition-Off Draw (IOD).
•Or, disconnect the negative cable from the battery.
•Anytime you store your vehicle, or keep it out of
service (i.e. vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
Interior Bulbs
Bulb Number
Glove Box Lamp 194
Grab Handle Lamp L002825W5W
Overhead Console
Reading LampsVT4976
Rear Cargo Lamp 214–2
Visor Vanity Lamp V26377
Underpanel Courtesy
Lamps906
Instrument Cluster
(General Illumination)103
Telltale/Hazard Lamp 74
652 MAINTAINING YOUR VEHICLE

Fluid and Filter Changes.................639
Fluid Change.........................639
Fluid Level Check......................636
Fluid Type...........................636
Special Additives.......................637
Autostick...............................455
Auxiliary Electrical Outlet (Power Outlet)........277
Auxiliary Power Outlet.....................277
Battery.................................617
Keyless Transmitter Replacement (RKE)........27
Belts, Seat...............................55
Blind Spot Monitoring......................127
Body Mechanism Lubrication.................621
B-Pillar Location..........................513
Brake Assist System.......................495
Brake Control System, Electronic..............494
Brake Fluid.............................633Brake System............................632
Anti-Lock (ABS).......................494
Fluid Check...........................633
Master Cylinder........................633
Parking..............................491
Warning Light.........................308
Brake/Transmission Interlock.................448
Bulb Replacement.........................652
Bulbs, Light.............................113
Calibration, Compass......................337
Camera, Rear............................255
Capacities, Fluid..........................659
Caps, Filler
Fuel................................550
Oil (Engine)..........................615
Power Steering........................490
Radiator (Coolant Pressure)...............630
Carbon Monoxide Warning..................110
10
INDEX 683