2013 JEEP COMPASS headlight bulb

NOTE:If either light remains on and does not flash, or
there is a very fast flash rate, check for a defective outside
light bulb. If an indicator fails to light when the lever is
moved, it would suggest that the indicator bulb is
defective.
Lane Change Assist
Tap the lever up or down once, without moving beyond
the detent, and the turn signal (right or left) will flash
three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever away from you to switch
the headlights to high beam. Pull the multifunction lever
toward you to switch the headlights back to low beam.
Flash-To-Pass
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will turn on the high beam headlights until the lever is
released.
NOTE: If the multifunction lever is held in the flash-to-
pass position for more than 20 seconds, the high beams
will shut off. If this occurs, wait 30 seconds for the next
flash-to-pass operation.Turn Signal Operation
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165

alert you to turn the signals off. If either indicator flashes
at a rapid rate, check for a defective outside light bulb.
9. High Beam IndicatorThis indicator shows that the high beam head-
lights are on. Push the multifunction lever for-
ward to switch the headlights to high beam, and pull
toward yourself (normal position) to return to low beam.
10. Anti-Lock Brake (ABS) Light
This light monitors the Anti-Lock Brake System
(ABS). The light will turn on when the ignition
switch is turned to the ON/RUN position and
may stay on for as long as four seconds.
If the ABS light remains on or turns on while driving, it
indicates that the Anti-Lock portion of the brake system
is not functioning and that service is required. However,
the conventional brake system will continue to operate
normally if the BRAKE warning light is not on. If the ABS light is on, the brake system should be serviced
as soon as possible to restore the benefits of Anti-Lock
brakes. If the ABS light does not turn on when the
ignition switch is turned to the ON/RUN position, have
the light inspected by an authorized dealer.
11. Seat Belt Reminder Light
When the ignition switch is first turned to ON/
RUN, this light will turn on for four to eight
seconds as a bulb check. During the bulb check, if
the driver’s seat belt is unbuckled, a chime will sound.
After the bulb check or when driving, if the driver’s seat
belt remains unbuckled, the Seat Belt Reminder Light
will illuminate and the chime will sound. Refer to
“Occupant Restraints” in “Things To Know Before Start-
ing Your Vehicle” for further information.
214 UNDERSTANDING YOUR INSTRUMENT PANEL

Lights................................ .101
Airbag ...............................68
Alarm .............................. .217
Anti-Lock ........................... .214
Back-Up ............................ .471
Brake Assist Warning ....................349
Brake Warning ........................ .215
Bulb Replacement ..................... .470
Cargo .............................. .197
Center Mounted Stop ....................472
Daytime Running ..................... .163
Dimmer Switch, Headlight ................162
Electronic Stability Program (ESP) Indicator . . . .349
Engine Temperature Warning ..............215
Exterior ............................. .101
Fog ................................ .164
Headlights .......................... .163
Headlight Switch ...................... .163
High Beam .......................... .165High Beam Indicator
....................214
High Beam/Low Beam Select ..............165
Instrument Cluster ..................... .163
License ............................. .472
Lights On Reminder .....................163
Low Fuel ........................... .213
Malfunction Indicator (Check Engine) ........223
Map Reading ......................... .167
Oil Pressure ......................... .213
Seat Belt Reminder ..................... .214
Security Alarm (Theft Alarm) ...............18
Service ............................. .470
Theft Alarm (Security Alarm) ..............217
Tire Pressure Monitoring (TPMS) ............219
Traction Control ....................... .349
Turn Signal .......................... .101
Voltage ............................. .212
W

arning (Instrument Cluster Description) .....212
Loading Vehicle ......................... .388
502 INDEX